| /OK3568_Linux_fs/kernel/arch/arm/mach-sa1100/ |
| H A D | badge4.c | 178 GPCR = (BADGE4_GPIO_LGP2 | BADGE4_GPIO_LGP3 | in badge4_init()
193 GPCR = (BADGE4_GPIO_SDSDA | BADGE4_GPIO_SDSCL); in badge4_init()
197 GPCR = (BADGE4_GPIO_UART_HS1 | BADGE4_GPIO_UART_HS2); in badge4_init()
201 GPCR = BADGE4_GPIO_MUXSEL0; in badge4_init()
206 GPCR = BADGE4_GPIO_TESTPT_J7; in badge4_init()
210 GPCR = BADGE4_GPIO_PCMEN5V; /* initially off */ in badge4_init()
283 GPCR = BADGE4_GPIO_PCMEN5V; in badge4_set_5V()
|
| H A D | assabet.c | 128 GPCR = SDA; in adv7171_start()
144 GPCR = SCK; in adv7171_send()
149 GPCR = SDA; in adv7171_send()
154 GPCR = SCK; in adv7171_send()
164 GPCR = SCK | SDA; in adv7171_send()
178 GPCR = SDA | SCK | MOD; /* clear L3 mode to ensure UDA1341 doesn't respond */ in adv7171_write()
193 GPCR = (~gplr) & (SDA | SCK | MOD); in adv7171_write()
558 GPCR = GPIO_SSP_TXD | GPIO_SSP_SCLK | GPIO_SSP_SFRM; in assabet_init()
566 GPCR = GPIO_GPIO27; in assabet_init()
|
| H A D | pm.c | 107 GPCR = ~gpio; in sa11x0_pm_enter()
|
| H A D | generic.c | 440 GPCR = GPIO_MBGNT; in sa1110_mb_disable()
459 GPCR = GPIO_MBGNT; in sa1110_mb_enable()
|
| H A D | pleb.c | 133 GPCR = GPIO_ETH0_EN; /* clear MCLK (enable smc) */ in pleb_map_io()
|
| H A D | jornada720_ssp.c | 112 GPCR = GPIO_GPIO25; in jornada_ssp_start()
|
| H A D | shannon.c | 144 GPCR = SHANNON_GPIO_CODEC_RESET; in shannon_map_io()
|
| H A D | jornada720.c | 269 GPCR = GPIO_GPIO20; /* stop gpio20 */ in jornada720_init()
|
| H A D | h3xxx.c | 285 GPCR = 0x0fffffff; /* All outputs are set low by default */ in h3xxx_map_io()
|
| /OK3568_Linux_fs/kernel/arch/arm/mach-pxa/ |
| H A D | mfp-pxa2xx.c | 34 #define GPCR(x) __REG2(0x40E00000, BANK_OFF((x) >> 5) + 0x24) macro
374 GPCR(i * 32) = ~PGSR(i); in pxa2xx_mfp_suspend()
398 GPCR(i * 32) = ~saved_gplr[i]; in pxa2xx_mfp_resume()
|
| /OK3568_Linux_fs/kernel/drivers/gpio/ |
| H A D | gpio-intel-mid.c | 47 GPCR, /* pin clear */ enumerator
115 gpcr = gpio_reg(chip, offset, GPCR); in intel_gpio_set()
|
| H A D | gpio-merrifield.c | 22 #define GPCR 0x04c /* pin clear w/o */ macro
115 gpcr = gpio_reg(chip, offset, GPCR); in mrfld_gpio_set()
|
| /OK3568_Linux_fs/u-boot/board/armadeus/apf27/ |
| H A D | lowlevel_init.S | 23 ldr r0, =GPCR
|
| /OK3568_Linux_fs/kernel/Documentation/spi/ |
| H A D | pxa2xx.rst | 154 GPCR(2) = GPIO_bit(2);
163 GPCR(3) = GPIO_bit(3);
|
| /OK3568_Linux_fs/u-boot/arch/arm/lib/ |
| H A D | asm-offsets.c | 95 DEFINE(GPCR, IMX_SYSTEM_CTL_BASE + in main()
|
| /OK3568_Linux_fs/u-boot/drivers/usb/gadget/ |
| H A D | pxa27x_udc.c | 613 writel(GPIO_bit(CONFIG_USB_DEV_PULLUP_GPIO), GPCR(CONFIG_USB_DEV_PULLUP_GPIO)); in udc_disconnect()
|
| H A D | pxa25x_udc.c | 1870 GPCR(CONFIG_USB_DEV_PULLUP_GPIO)); in udc_command()
|
| /OK3568_Linux_fs/u-boot/arch/arm/include/asm/arch-pxa/ |
| H A D | pxa-regs.h | 1253 #define GPCR(x) (((((x) & 0x7f) < 96) ? _GPCR(x) : GPCR3)) macro
1263 #define GPCR(x) _GPCR(x) macro
|
| /OK3568_Linux_fs/u-boot/include/ |
| H A D | SA-1100.h | 1507 #define GPCR /* GPIO Pin output Clear Reg. */ \ macro
1522 #define GPCR (io_p2v (_GPCR)) macro
|
| /OK3568_Linux_fs/u-boot/arch/arm/include/asm/arch-imx/ |
| H A D | imx-regs.h | 67 #define GPCR __REG(IMX_SYSCTRL_BASE + 0xC) /* Function Multiplex Control Register */ macro
|
| /OK3568_Linux_fs/kernel/arch/arm/mach-sa1100/include/mach/ |
| H A D | SA-1100.h | 1108 #define GPCR __REG(0x9004000C) /* GPIO Pin output Clear Reg. */ macro
|