| /OK3568_Linux_fs/kernel/arch/arm/mach-sa1100/ |
| H A D | badge4.c | 184 GPDR &= ~BADGE4_GPIO_INT_VID; in badge4_init()
185 GPDR |= (BADGE4_GPIO_LGP2 | BADGE4_GPIO_LGP3 | in badge4_init()
194 GPDR |= (BADGE4_GPIO_SDSDA | BADGE4_GPIO_SDSCL); in badge4_init()
198 GPDR |= (BADGE4_GPIO_UART_HS1 | BADGE4_GPIO_UART_HS2); in badge4_init()
202 GPDR |= BADGE4_GPIO_MUXSEL0; in badge4_init()
205 GPDR &= ~(BADGE4_GPIO_TESTPT_J5 | BADGE4_GPIO_TESTPT_J6); in badge4_init()
207 GPDR |= BADGE4_GPIO_TESTPT_J7; in badge4_init()
211 GPDR |= BADGE4_GPIO_PCMEN5V; in badge4_init()
|
| H A D | assabet.c | 158 GPDR &= ~SDA; in adv7171_send()
166 GPDR |= SDA; in adv7171_send()
172 unsigned gpdr = GPDR; in adv7171_write()
179 GPDR = (GPDR | SCK | MOD) & ~SDA; in adv7171_write()
183 GPDR |= SDA; in adv7171_write()
194 GPDR = gpdr; in adv7171_write()
550 GPDR |= GPIO_GPIO16; in assabet_init()
559 GPDR |= GPIO_SSP_TXD | GPIO_SSP_SCLK | GPIO_SSP_SFRM; in assabet_init()
567 GPDR |= GPIO_GPIO27; in assabet_init()
657 GPDR |= 0x3fc; /* Configure GPIO 9:2 as outputs */ in get_assabet_scr()
[all …]
|
| H A D | pleb.c | 120 GPDR |= GPIO_UART_TXD; in pleb_map_io()
121 GPDR &= ~GPIO_UART_RXD; in pleb_map_io()
132 GPDR |= GPIO_ETH0_EN; /* set to output */ in pleb_map_io()
135 GPDR &= ~GPIO_ETH0_IRQ; in pleb_map_io()
|
| H A D | pm.c | 62 SAVE(GPDR); in sa11x0_pm_enter()
96 RESTORE(GPDR); in sa11x0_pm_enter()
|
| H A D | generic.c | 441 GPDR = (GPDR & ~GPIO_MBREQ) | GPIO_MBGNT; in sa1110_mb_disable()
460 GPDR = (GPDR & ~GPIO_MBREQ) | GPIO_MBGNT; in sa1110_mb_enable()
|
| H A D | shannon.c | 139 GPDR |= GPIO_UART_TXD | SHANNON_GPIO_CODEC_RESET; in shannon_map_io()
140 GPDR &= ~GPIO_UART_RXD; in shannon_map_io()
|
| H A D | pci-nanoengine.c | 169 GPDR = (GPDR & ~GPIO_MBREQ) | GPIO_MBGNT; in pci_nanoengine_setup()
|
| H A D | clock.c | 33 GPDR |= GPIO_32_768kHz; in clk_gpio27_enable()
44 GPDR &= ~GPIO_32_768kHz; in clk_gpio27_disable()
|
| H A D | lart.c | 161 GPDR |= GPIO_UART_TXD; in lart_map_io()
162 GPDR &= ~GPIO_UART_RXD; in lart_map_io()
|
| H A D | simpad.c | 216 GPDR |= GPIO_UART_TXD | GPIO_LDD13 | GPIO_LDD15; in simpad_map_io()
217 GPDR &= ~GPIO_UART_RXD; in simpad_map_io()
|
| H A D | jornada720.c | 265 GPDR |= GPIO_GPIO20; /* Clear gpio20 pin as input */ in jornada720_init()
|
| H A D | h3xxx.c | 286 GPDR = 0; /* Configure all GPIOs as input */ in h3xxx_map_io()
|
| H A D | collie.c | 372 GPDR = GPIO_LDD8 | GPIO_LDD9 | GPIO_LDD10 | GPIO_LDD11 | GPIO_LDD12 | in collie_init()
|
| /OK3568_Linux_fs/kernel/arch/arm/mach-pxa/ |
| H A D | mfp-pxa2xx.c | 32 #define GPDR(x) __REG2(0x40E00000, BANK_OFF((x) >> 5) + 0x0c) macro
74 GPDR(gpio) |= mask; in __mfp_config_gpio()
76 GPDR(gpio) &= ~mask; in __mfp_config_gpio()
358 (GPDR(i) & GPIO_bit(i))) { in pxa2xx_mfp_suspend()
369 saved_gpdr[i] = GPDR(i * 32); in pxa2xx_mfp_suspend()
382 GPDR(i) |= GPIO_bit(i); in pxa2xx_mfp_suspend()
384 GPDR(i) &= ~GPIO_bit(i); in pxa2xx_mfp_suspend()
399 GPDR(i * 32) = saved_gpdr[i]; in pxa2xx_mfp_resume()
432 gpdr_lpm[i] = GPDR(i * 32); in pxa2xx_mfp_init()
|
| /OK3568_Linux_fs/kernel/drivers/gpio/ |
| H A D | gpio-merrifield.c | 20 #define GPDR 0x01c /* pin direction */ macro
126 void __iomem *gpdr = gpio_reg(chip, offset, GPDR); in mrfld_gpio_direction_input()
145 void __iomem *gpdr = gpio_reg(chip, offset, GPDR); in mrfld_gpio_direction_output()
163 void __iomem *gpdr = gpio_reg(chip, offset, GPDR); in mrfld_gpio_get_direction()
|
| H A D | gpio-intel-mid.c | 45 GPDR, /* pin direction */ enumerator
123 void __iomem *gpdr = gpio_reg(chip, offset, GPDR); in intel_gpio_direction_input()
146 void __iomem *gpdr = gpio_reg(chip, offset, GPDR); in intel_gpio_direction_output()
|
| /OK3568_Linux_fs/u-boot/drivers/usb/gadget/ |
| H A D | pxa27x_udc.c | 596 writel(readl(GPDR(CONFIG_USB_DEV_PULLUP_GPIO)) in udc_connect()
598 GPDR(CONFIG_USB_DEV_PULLUP_GPIO)); in udc_connect()
|
| H A D | pxa25x_udc.c | 1865 setbits_le32(GPDR(CONFIG_USB_DEV_PULLUP_GPIO), in udc_command()
1881 clrbits_le32(GPDR(CONFIG_USB_DEV_PULLUP_GPIO), in udc_command()
|
| /OK3568_Linux_fs/u-boot/arch/arm/include/asm/arch-pxa/ |
| H A D | pxa-regs.h | 1251 #define GPDR(x) (((((x) & 0x7f) < 96) ? _GPDR(x) : GPDR3)) macro
1261 #define GPDR(x) _GPDR(x) macro
|
| /OK3568_Linux_fs/u-boot/include/ |
| H A D | SA-1100.h | 1503 #define GPDR /* GPIO Pin Direction Reg. */ \ macro
1520 #define GPDR (io_p2v (_GPDR)) macro
|
| /OK3568_Linux_fs/kernel/arch/arm/mach-sa1100/include/mach/ |
| H A D | SA-1100.h | 1106 #define GPDR __REG(0x90040004) /* GPIO Pin Direction Reg. */ macro
|
| /OK3568_Linux_fs/kernel/drivers/video/fbdev/ |
| H A D | sa1100fb.c | 774 GPDR |= mask; in sa1100fb_setup_gpio()
|