| /OK3568_Linux_fs/kernel/drivers/net/mdio/ |
| H A D | Kconfig | 3 # MDIO Layer Configuration 7 tristate "MDIO bus device drivers" 9 MDIO devices and driver infrastructure code. 28 OpenFirmware MDIO bus (Ethernet PHY) accessors 36 tristate "Allwinner sun4i MDIO interface support" 39 This driver supports the MDIO interface found in the network 44 tristate "APM X-Gene SoC MDIO bus controller" 47 This module provides a driver for the MDIO busses found in the 51 tristate "ASPEED MDIO bus controller" 55 This module provides a driver for the independent MDIO bus [all …]
|
| /OK3568_Linux_fs/kernel/Documentation/ABI/testing/ |
| H A D | sysfs-bus-mdio | 7 MDIO bus address statistics. 14 Total number of transfers for this MDIO bus. 21 Total number of transfer errors for this MDIO bus. 28 Total number of write transactions for this MDIO bus. 35 Total number of read transactions for this MDIO bus. 42 Total number of transfers for this MDIO bus address. 49 Total number of transfer errors for this MDIO bus address. 56 Total number of write transactions for this MDIO bus address. 63 Total number of read transactions for this MDIO bus address.
|
| /OK3568_Linux_fs/u-boot/doc/ |
| H A D | README.bitbangMII | 16 MDIO_DECLARE - Declaration needed to access to the MDIO pin (optional) 17 MDIO_ACTIVE - Activate the MDIO pin as out pin 18 MDIO_TRISTATE - Activate the MDIO pin as input/tristate pin 19 MDIO_READ - Read the MDIO pin 20 MDIO(v) - Write v on the MDIO pin 37 int (*mdio_active)() - Activate the MDIO pin as output 38 int (*mdio_tristate)() - Activate the MDIO pin as input/tristate pin 39 int (*set_mdio)() - Write the MDIO pin 40 int (*get_mdio)() - Read the MDIO pin
|
| /OK3568_Linux_fs/kernel/arch/powerpc/boot/dts/ |
| H A D | kmeter1.dts | 148 0 1 3 0 2 0 /* MDIO */ 174 0 1 3 0 2 0 /* MDIO */ 200 0 1 3 0 2 0 /* MDIO */ 220 0 1 3 0 2 0 /* MDIO */ 238 0 1 3 0 2 0 /* MDIO */ 256 0 1 3 0 2 0 /* MDIO */ 274 0 1 3 0 2 0 /* MDIO */ 314 /* ESTAR-1 (UCC1, MDIO 0x10, RGMII) */ 330 /* ESTAR-2 (UCC2, MDIO 0x11, RGMII) */ 346 /* Piggy2 (UCC4, MDIO 0x00, RMII) */ [all …]
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/net/ |
| H A D | marvell-orion-mdio.txt | 1 * Marvell MDIO Ethernet Controller interface 5 identical unit that provides an interface with the MDIO bus. 12 - reg: address and length of the MDIO registers. When an interrupt is 19 - clocks: phandle for up to four required clocks for the MDIO instance 21 The child nodes of the MDIO driver are the individual PHY devices 22 connected to this MDIO bus. They must have a "reg" property given the 23 PHY address on the MDIO bus.
|
| H A D | cavium-mdio.txt | 1 * System Management Interface (SMI) / MDIO 11 - reg: The base address of the MDIO bus controller register bank. 15 - #size-cells: Must be <0>. MDIO addresses have no size component. 17 Typically an MDIO bus might have several children. 33 * System Management Interface (SMI) / MDIO Nexus 48 - ranges: As needed for mapping of the MDIO bus device registers. 50 - assigned-addresses: As needed for mapping of the MDIO bus device registers.
|
| H A D | brcm,unimac-mdio.txt | 1 * Broadcom UniMAC MDIO bus controller 9 larger than 16-bits MDIO transactions 16 Ethernet switch this MDIO block is integrated from, or must be two, if there 22 - clocks: A reference to the clock supplying the MDIO bus controller 23 - clock-frequency: the MDIO bus clock that must be output by the MDIO bus 26 Child nodes of this MDIO bus controller node are standard Ethernet PHY device
|
| H A D | brcm,mdio-mux-iproc.txt | 1 Properties for an MDIO bus multiplexer found in Broadcom iProc based SoCs. 3 This MDIO bus multiplexer defines buses that could be internal as well as 4 external to SoCs and could accept MDIO transaction compatible to C-22 or 6 properties as well to generate desired MDIO transaction on appropriate bus. 10 MDIO multiplexer node:
|
| H A D | mscc-miim.txt | 1 Microsemi MII Management Controller (MIIM) / MDIO 6 - reg: The base address of the MDIO bus controller register bank. Optionally, a 10 - #size-cells: Must be <0>. MDIO addresses have no size component. 13 Typically an MDIO bus might have several children.
|
| H A D | hisilicon-hns-mdio.txt | 1 Hisilicon MDIO bus controller 10 - reg: The base address of the MDIO bus controller register bank. 12 - #size-cells: Must be <0>. MDIO addresses have no size component. 14 Typically an MDIO bus might have several children.
|
| H A D | mdio-mux-multiplexer.txt | 1 Properties for an MDIO bus multiplexer consumer device 3 This is a special case of MDIO mux when MDIO mux is defined as a consumer 7 Required properties in addition to the MDIO Bus multiplexer properties: 11 - mdio-parent-bus : phandle to the parent MDIO bus.
|
| H A D | fsl-fman.txt | 10 - FMan MDIO Node 369 FMan MDIO Node 373 The MDIO is a bus to which the PHY devices are connected. 381 Must include "fsl,fman-mdio" for 1 Gb/s MDIO from FMan v2. 382 Must include "fsl,fman-xmdio" for 10 Gb/s MDIO from FMan v2. 383 Must include "fsl,fman-memac-mdio" for 1/10 Gb/s MDIO from 394 Definition: Specifies the external MDIO bus clock speed to 401 Usage: required for external MDIO 403 Definition: Event interrupt of external MDIO controller. 406 Usage: required for internal MDIO [all …]
|
| H A D | mdio-gpio.txt | 1 MDIO on GPIOs 6 MDC and MDIO lines connected to GPIO controllers are listed in the 9 MDC, MDIO.
|
| H A D | mdio-mux.txt | 1 Common MDIO bus multiplexer/switch properties. 3 An MDIO bus multiplexer/switch will have several child busses that are 4 numbered uniquely in a device dependent manner. The nodes for an MDIO 12 - mdio-parent-bus : phandle to the parent MDIO bus. 24 /* The parent MDIO bus. */
|
| H A D | brcm,iproc-mdio.txt | 1 * Broadcom iProc MDIO bus controller 5 - reg: address and length of the register set for the MDIO interface 9 Child nodes of this MDIO bus controller node are standard Ethernet PHY device
|
| H A D | apm-xgene-mdio.txt | 1 APM X-Gene SoC MDIO node 3 MDIO node is defined to describe on-chip MDIO controller.
|
| H A D | nixge.txt | 11 "ctrl": MDIO and PHY control and status region 19 - mdio subnode to indicate presence of MDIO controller 49 Examples (10G generic PHY, no MDIO): 65 Examples (1G generic fixed-link + MDIO):
|
| H A D | mdio-mux-mmioreg.txt | 1 Properties for an MDIO bus multiplexer controlled by a memory-mapped device 3 This is a special case of a MDIO bus multiplexer. A memory-mapped device, 24 For the "EMI2" MDIO bus, register 9 (BRDCFG1) controls the mux on that bus. 68 /* The parent MDIO bus. */
|
| H A D | mdio-mux-meson-g12a.txt | 1 Properties for the MDIO bus multiplexer/glue of Amlogic G12a SoC family. 3 This is a special case of a MDIO bus multiplexer. It allows to choose between 5 MDIO bus.
|
| H A D | fsl-enetc.txt | 14 1. The ENETC external port is connected to a MDIO configurable phy 16 1.1. Using the local ENETC Port MDIO interface 26 - phy-handle : Phandle to a PHY on the MDIO bus. 52 1.2. Using the central MDIO PCIe endpoint device
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/phy/ |
| H A D | brcm,mdio-mux-bus-pci.txt | 4 - reg: MDIO Bus number for the MDIO interface 10 - reg: MDIO Phy ID for the MDIO interface
|
| /OK3568_Linux_fs/u-boot/doc/device-tree-bindings/net/ |
| H A D | fsl-tsec-phy.txt | 22 connected via the MDIO bus (sometimes the MDIO bus controller is separate). 24 * MDIO IO device 26 The MDIO is a bus to which the PHY devices are connected. For each 45 * TBI Internal MDIO bus 48 This PHY is accessed through the local MDIO bus. These buses are defined
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/net/dsa/ |
| H A D | realtek-smi.txt | 5 bit-banged GPIO that while it reuses the MDIO lines MCK and MDIO does 6 not use the MDIO protocol. This binding defines how to specify the 23 - mdio-gpios: GPIO line for the MDIO data line. 50 This defines the internal MDIO bus of the SMI device, mostly for the 58 See net/mdio.txt for additional MDIO bus properties. 67 /* 22 = MDIO (has input reads), 21 = MDC (clock, output only) */
|
| /OK3568_Linux_fs/u-boot/arch/arm/dts/ |
| H A D | am335x-draco.dts | 92 /* MDIO */ 100 /* MDIO reset value */ 108 /* MDIO via GPIO */ 128 gpios = <&gpio0 1 GPIO_ACTIVE_HIGH /* MDIO-CLK */ 129 &gpio0 0 GPIO_ACTIVE_HIGH>; /* MDIO-DATA */
|
| /OK3568_Linux_fs/kernel/drivers/net/ethernet/freescale/ |
| H A D | Kconfig | 47 bool "FEC MPC52xx MDIO bus driver" 62 tristate "Freescale PQ MDIO" 65 This driver supports the MDIO bus used by the gianfar and UCC drivers. 68 tristate "Freescale XGMAC MDIO" 73 This driver supports the MDIO bus on the Fman 10G Ethernet MACs, and
|