| /OK3568_Linux_fs/u-boot/board/freescale/mpc8572ds/ |
| H A D | README | 14 locations can be swapped using the dip-switch SW9[1:2]. 92 tftp c00000 mpc8572ds.dtb 93 bootm 1000000 - c00000 109 2. Build kernel image for core1: 147 => tftp 20c00000 8572/mpc8572ds_core1.dtb 149 => bootm start 21000000 22000000 20c00000 162 => tftp c00000 8572/mpc8572ds_core0.dtb 163 => bootm 1000000 2000000 c00000
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/mtd/ |
| H A D | ingenic,nand.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 62 #address-cells = <2>; 65 <2 0 0x1a000000 0x1000000>, 104 #address-cells = <2>; 105 #size-cells = <2>; 122 partition@c00000 { 127 partition@4c00000 {
|
| /OK3568_Linux_fs/u-boot/include/configs/ |
| H A D | sunxi-common.h | 113 #define PHYS_SDRAM_0_SIZE 0x80000000 /* 2 GiB */ 158 /* 2MB of malloc() pool */ 159 #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + (2 << 20)) 246 #define OF_STDOUT_PATH "/soc@01c00000/serial@01c28000:115200" 248 #elif CONFIG_CONS_INDEX == 2 && defined(CONFIG_MACH_SUN5I) 249 #define OF_STDOUT_PATH "/soc@01c00000/serial@01c28400:115200" 251 #define OF_STDOUT_PATH "/soc@01c00000/serial@01c28800:115200" 253 #define OF_STDOUT_PATH "/soc@01c00000/serial@01f02800:115200" 330 * Align the initrd to a 2MB page. 354 * 64M RAM minus 2MB heap + 16MB for u-boot, stack, fb, etc.
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/display/exynos/ |
| H A D | samsung-fimd.txt | 74 in [2]. The following are properties specific to those nodes: 78 2 - for CAMIF2 input, 83 [2]: Documentation/devicetree/bindings/media/video-interfaces.txt 89 fimd@11c00000 { 94 interrupts = <11 0>, <11 1>, <11 2>; 103 fimd@11c00000 {
|
| /OK3568_Linux_fs/u-boot/board/freescale/bsc9132qds/ |
| H A D | README | 48 - 512 KB, 8-way, level 2 unified instruction/data cache (L2 cache/M2 memory) 56 2Gbyte DDR3 (on board DDR), Dual Ranki 58 128Mbyte 2K page size NAND Flash 76 2. CPU0/CPU1/CCB/DDR: 1200MHz/1200MHz/600MHz/1330MHz 82 2. NAND Flash 96 2. NAND Flash : It is currently not supported 106 0x0000_0000 0x7FFF_FFFF DDR 2G cacheable 114 0xC100_0000 0xC13F_FFFF MAPLE-2F 4M 149 tftp c00000 bsc9132qds.dtb 150 bootm 1000000 2000000 c00000
|
| /OK3568_Linux_fs/u-boot/board/freescale/bsc9131rdb/ |
| H A D | README | 29 . eTSEC 2 supports RGMII 56 . 512 Kbyte 8-way level 2 unified instruction/data cache (M2 memory) 65 128Mbyte 2K page size NAND Flash 78 2. 800/400/667 83 2. SPI Flash 94 2. NAND Flash with sysclk 100MHz(J16 on RDB open) 105 0xC100_0000 0xC13F_FFFF MAPLE-2F 4M 150 tftp c00000 bsc9131rdb.dtb 151 bootm 1000000 2000000 c00000
|
| /OK3568_Linux_fs/kernel/arch/microblaze/boot/dts/ |
| H A D | system.dts | 124 bank-width = <2>; 130 xlnx,include-datawidth-matching-2 = <0x0>; 160 xlnx,synch-mem-2 = <0x0>; 164 xlnx,synch-pipedelay-2 = <0x2>; 168 xlnx,tavdv-ps-mem-2 = <0x3a98>; 172 xlnx,tcedv-ps-mem-2 = <0x3a98>; 176 xlnx,thzce-ps-mem-2 = <0x1b58>; 180 xlnx,thzoe-ps-mem-2 = <0x1b58>; 184 xlnx,tlzwe-ps-mem-2 = <0x0>; 188 xlnx,twc-ps-mem-2 = <0x3a98>; [all …]
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/rng/ |
| H A D | xiphera,xip8001b-trng.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 30 rng@43c00000 {
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/rpmsg/ |
| H A D | rpmsg-rockchip.txt | 32 #address-cells = <2>; 33 #size-cells = <2>; 36 rpmsg_reserved: rpmsg@7c00000 {
|
| /OK3568_Linux_fs/kernel/arch/arm64/boot/dts/nvidia/ |
| H A D | tegra186-p3310.dtsi | 59 memory-controller@2c00000 { 88 channel@2 { 113 channel@2 { 160 hsp@3c00000 { 202 cpu@2 { 229 #interrupt-cells = <2>; 232 #gpio-cells = <2>; 414 vdd_1v8_ap: regulator@2 {
|
| /OK3568_Linux_fs/kernel/arch/arm/boot/dts/ |
| H A D | qcom-msm8660-surf.dts | 19 gsbi@19c00000 { 57 MATRIX_KEY(0, 2, KEY_LEFT) 61 MATRIX_KEY(1, 2, KEY_DOWN) 63 MATRIX_KEY(2, 3, KEY_ENTER) 66 MATRIX_KEY(4, 2, KEY_LEFT) 71 MATRIX_KEY(5, 2, KEY_DOWN)
|
| H A D | imx1-apf9328.dts | 51 bank-width = <2>; 57 eth: eth@4,c00000 {
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/gpio/ |
| H A D | xylon,logicvc-gpio.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) 38 const: 2 56 logicvc: logicvc@43c00000 { 67 #gpio-cells = <2>;
|
| /OK3568_Linux_fs/u-boot/doc/device-tree-bindings/mailbox/ |
| H A D | nvidia,tegra186-hsp.txt | 30 - #mbox-cells : Should be 2. 41 hsp_top0: hsp@3c00000 { 46 #mbox-cells = <2>;
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/mfd/ |
| H A D | xylon,logicvc.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) 57 logicvc: logicvc@43c00000 {
|
| H A D | syscon.yaml | 56 minItems: 2 67 enum: [1, 2, 4, 8] 82 syscon: syscon@1c00000 {
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/mailbox/ |
| H A D | nvidia,tegra186-hsp.txt | 33 - #mbox-cells : Should be 2. 61 hsp_top0: hsp@3c00000 { 66 #mbox-cells = <2>;
|
| /OK3568_Linux_fs/kernel/arch/mips/boot/dts/ingenic/ |
| H A D | ci20.dts | 53 gpios = <&gpc 2 GPIO_ACTIVE_HIGH>; 337 #address-cells = <2>; 338 #size-cells = <2>; 355 partition@c00000 { 360 partition@4c00000 { 376 6 2 1>; /* data */
|
| /OK3568_Linux_fs/u-boot/arch/arm/dts/ |
| H A D | uniphier-pxs3.dtsi | 14 #address-cells = <2>; 15 #size-cells = <2>; 19 #address-cells = <2>; 57 cpu2: cpu@2 { 170 clocks = <&peri_clk 2>; 190 #interrupt-cells = <2>; 192 #gpio-cells = <2>; 264 system_bus: system-bus@58c00000 { 268 #address-cells = <2>; 322 cdns,phy-input-delay-mmc-highspeed = <2>; [all …]
|
| H A D | sun5i-r8.dtsi | 14 * published by the Free Software Foundation; either version 2 of the 61 soc@01c00000 {
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/memory-controllers/ |
| H A D | nvidia,tegra186-mc.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 42 const: 2 45 const: 2 101 #address-cells = <2>; 102 #size-cells = <2>; 104 memory-controller@2c00000 { 109 #address-cells = <2>; 110 #size-cells = <2>; 120 external-memory-controller@2c60000 {
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/display/ |
| H A D | arm,komeda.txt | 41 dp0: display@c00000 { 49 iommus = <&smmu 0>, <&smmu 1>, <&smmu 2>, <&smmu 3>,
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/net/ |
| H A D | xilinx_axienet.txt | 24 - interrupts : Should be a list of 2 or 3 interrupts: TX DMA, RX DMA, 39 2 to enable full TX checksum offload 56 axi_ethernet_eth: ethernet@40c00000 { 60 interrupts = <2 0 1>;
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/bus/ |
| H A D | socionext,uniphier-system-bus.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause 34 const: 2 82 system-bus@58c00000 { 85 #address-cells = <2>;
|
| /OK3568_Linux_fs/u-boot/doc/device-tree-bindings/firmware/ |
| H A D | nvidia,tegra186-bpmp.txt | 69 hsp_top0: hsp@03c00000 { 71 #mbox-cells = <2>; 77 #address-cells = <2>; 78 #size-cells = <2>;
|