| /OK3568_Linux_fs/kernel/drivers/mtd/lpddr/ |
| H A D | Kconfig | 2 menu "LPDDR & LPDDR2 PCM memory drivers"
25 tristate "Support for LPDDR2-NVM flash chips"
27 This option enables support of PCM memories with a LPDDR2-NVM
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/ddr/ |
| H A D | lpddr2.txt | 1 * LPDDR2 SDRAM memories compliant to JEDEC JESD209-2
7 "ti,jedec-lpddr2-s2" should be listed if the memory part is LPDDR2-S2 type
9 "ti,jedec-lpddr2-s4" should be listed if the memory part is LPDDR2-S4 type
11 "ti,jedec-lpddr2-nvm" should be listed if the memory part is LPDDR2-NVM type
|
| H A D | lpddr3-timings.txt | 3 The structures are based on LPDDR2 and extended where needed.
|
| H A D | lpddr2-timings.txt | 1 * AC timing parameters of LPDDR2(JESD209-2) memories for a given speed-bin
|
| /OK3568_Linux_fs/kernel/Documentation/driver-api/memory-devices/ |
| H A D | ti-emif.rst | 30 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols.
31 This driver takes care of only LPDDR2 memories presently. The
63 - mr4 : last polled value of MR4 register in the LPDDR2 device. MR4
|
| /OK3568_Linux_fs/u-boot/arch/arm/include/asm/arch-rockchip/ |
| H A D | sdram.h | 14 LPDDR2 = 5, enumerator
|
| /OK3568_Linux_fs/u-boot/drivers/ram/rockchip/ |
| H A D | Kconfig | 32 3 for DDR3, 5 for LPDDR2, 6 for LPDDR3, 7 for LPDDR4, all other
|
| H A D | sdram-px30-lpddr2-detect-333.inc | 28 .dramtype = LPDDR2,
|
| H A D | sdram_px30.c | 217 sdram_params->base.dramtype == LPDDR2) && in set_ctl_address_map()
461 } else if (sdram_params->base.dramtype == LPDDR2) { in sdram_init_()
511 if (dram_type == LPDDR2) in dram_detect_cap()
|
| H A D | sdram_rk322x.c | 446 if (dramtype == LPDDR2) { in pctl_cfg()
488 case LPDDR2: in phy_cfg()
502 if (sdram_params->base.dramtype == LPDDR2) in phy_cfg()
|
| H A D | sdram_common.c | 22 case LPDDR2: in sdram_print_dram_type()
327 } else if (dram_type == LPDDR3 || dram_type == LPDDR2) { in sdram_detect_dbw()
|
| H A D | dmc_fsp.c | 393 else if (dram_type == LPDDR2) in dmc_fsp_probe()
|
| H A D | sdram_phy_px30.c | 65 if (dram_type == LPDDR2) in sdram_phy_set_ds_odt()
|
| H A D | sdram_rk3308.c | 527 if (params_priv->ddr_config_t.ddr_type == LPDDR2) { in set_ds_odt()
728 case LPDDR2: in modify_sdram_params()
|
| H A D | sdram_rv1108_pctl_phy.c | 387 case LPDDR2: in phy_cfg()
|
| H A D | sdram_rv1126.c | 2658 if (dram_type == LPDDR2) in dram_detect_cap()
|
| /OK3568_Linux_fs/kernel/drivers/cpufreq/ |
| H A D | s5pv210-cpufreq.c | 115 LPDDR2 = 0x2, enumerator
530 if ((mem_type != LPDDR) && (mem_type != LPDDR2)) { in s5pv210_cpu_init()
|
| /OK3568_Linux_fs/kernel/drivers/memory/ |
| H A D | Kconfig | 99 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols.
100 This driver takes care of only LPDDR2 memories presently. The
|
| /OK3568_Linux_fs/u-boot/board/freescale/mx6qarm2/ |
| H A D | imximage_mx6dl.cfg | 149 /*LPDDR2 ZQ params */
193 * a. DQS gating is not relevant for LPDDR2. DSQ gating calibration section
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/memory-controllers/ti/ |
| H A D | emif.txt | 5 DDR2/DDR3/LPDDR2 protocols. This binding describes a given instance
|
| /OK3568_Linux_fs/u-boot/board/ccv/xpress/ |
| H A D | imximage.cfg | 146 * a. better operation at low frequency, for LPDDR2 freq < 100MHz, change RALAT
|
| /OK3568_Linux_fs/kernel/arch/arm64/boot/dts/rockchip/ |
| H A D | rk1808-dram-default-timing.dtsi | 83 * DDR3 CA define is different from others(DDR4/LPDDR2/LPDDR3).
|
| /OK3568_Linux_fs/kernel/drivers/devfreq/event/ |
| H A D | rockchip-dfi.c | 90 LPDDR2 = 5, enumerator
384 if (info->dram_type == LPDDR3 || info->dram_type == LPDDR2) in rockchip_dfi_start_hardware_counter()
|
| /OK3568_Linux_fs/u-boot/drivers/power/ |
| H A D | Kconfig | 205 On A31 boards aldo2 may be used for LPDDR2 then it should be 1.8V.
209 LPDDR2, and the codec. It should be 1.8V.
|