| /optee_os/core/drivers/counter/ |
| H A D | stm32_stgen.c | 109 panic("Could not get RTC calendar at suspend"); in stm32_stgen_pm_suspend()
133 panic("Could not get RTC calendar at resume"); in stm32_stgen_pm_resume()
139 panic(); in stm32_stgen_pm_resume()
143 panic("STGEN counter overflow"); in stm32_stgen_pm_resume()
147 panic("Couldn't modify STGEN clock rate"); in stm32_stgen_pm_resume()
180 panic(); in parse_dt()
189 panic("No stgen bus clock available in device tree"); in parse_dt()
195 panic("No stgen clock available in device tree"); in parse_dt()
218 panic(); in stgen_probe()
238 panic(); in stgen_probe()
[all …]
|
| /optee_os/core/drivers/ |
| H A D | stm32_omm.c | 103 panic(); in stm32_omm_parse_fdt()
110 panic(); in stm32_omm_parse_fdt()
154 panic(); in stm32_omm_parse_fdt()
159 panic(); in stm32_omm_parse_fdt()
163 panic(); in stm32_omm_parse_fdt()
175 panic(); in stm32_omm_parse_fdt()
180 panic(); in stm32_omm_parse_fdt()
184 panic(); in stm32_omm_parse_fdt()
230 panic(); in stm32_omm_set_mm()
239 panic(); in stm32_omm_set_mm()
[all …]
|
| H A D | aplic_msi.c | 65 panic(); in aplic_init_base_addr()
81 panic(); in aplic_op_configure()
85 panic(); in aplic_op_configure()
95 panic(); in aplic_op_enable()
105 panic(); in aplic_op_disable()
115 panic(); in aplic_op_raise_pi()
137 panic(); in aplic_init()
|
| H A D | microchip_pit.c | 33 panic(); in microchip_pit_probe()
38 panic(); in microchip_pit_probe()
46 panic(); in microchip_pit_probe()
50 panic(); in microchip_pit_probe()
|
| H A D | aplic_direct.c | 88 panic(); in aplic_init_base_addr()
104 panic(); in aplic_op_configure()
108 panic(); in aplic_op_configure()
117 panic(); in aplic_op_enable()
127 panic(); in aplic_op_disable()
137 panic(); in aplic_op_raise_pi()
159 panic(); in aplic_init()
|
| H A D | stm32_fmc.c | 148 panic("Cannot access FMC clock"); in apply_rif_config()
166 panic(); in apply_rif_config()
196 panic(); in apply_rif_config()
204 panic(); in apply_rif_config()
211 panic(); in apply_rif_config()
260 panic(); in parse_dt()
273 panic("Missing memory capacity for FMC RIF configuration"); in parse_dt()
316 panic("Cannot access FMC clock"); in check_fmc_rif_conf()
355 panic("Cannot access FMC clock"); in configure_fmc()
376 panic("Couldn't acquire controller 0 semaphore"); in configure_fmc()
[all …]
|
| H A D | stm32_uart.c | 128 panic(); in stm32_uart_init_from_dt_node()
136 panic(); in stm32_uart_init_from_dt_node()
141 panic(); in stm32_uart_init_from_dt_node()
149 panic(); in stm32_uart_init_from_dt_node()
153 panic(); in stm32_uart_init_from_dt_node()
157 panic(); in stm32_uart_init_from_dt_node()
|
| H A D | stm32_hpdma.c | 158 panic(); in apply_rif_config()
193 panic(); in apply_rif_config()
209 panic(); in apply_rif_config()
217 panic("HPDMA channel priv conf is incorrect"); in apply_rif_config()
222 panic("HPDMA channel sec conf is incorrect"); in apply_rif_config()
261 panic(); in parse_dt()
275 panic("Missing memory capacity for HPDMA RIF configuration"); in parse_dt()
287 panic("Failed to resume HPDMA"); in stm32_hpdma_pm_resume()
327 panic(); in stm32_hpdma_pm()
368 panic("Cannot access hpdma clock"); in stm32_hpdma_probe()
[all …]
|
| H A D | stm32_gpio.c | 250 panic(); in stm32_gpio_get_level()
263 panic(); in stm32_gpio_get_level()
284 panic(); in stm32_gpio_set_level()
303 panic(); in stm32_gpio_get_direction()
316 panic(); in stm32_gpio_get_direction()
336 panic(); in stm32_gpio_set_direction()
378 panic(); in stm32_gpio_configure()
445 panic(); in stm32_gpio_get_bank()
458 panic(); in pin_is_accessible()
522 panic(); in release_rif_semaphore_if_acquired()
[all …]
|
| H A D | openedges_omc.c | 151 panic("tzc.base is not registered"); in omc_configure_region()
153 panic("cfg is null"); in omc_configure_region()
155 panic("cfg->filters is overflowed"); in omc_configure_region()
157 panic("region is overflowed"); in omc_configure_region()
159 panic("region base or (top + 1) is not 4KB aligned"); in omc_configure_region()
186 panic("tzc.base is null"); in omc_set_action()
235 panic("tzc.base is null"); in omc_int_clear()
|
| /optee_os/core/drivers/crypto/se050/ |
| H A D | session.c | 75 panic(); in se050_early_init_default()
80 panic(); in se050_early_init_default()
86 panic(); in se050_early_init_default()
105 panic(); in se050_early_init_scp03()
110 panic(); in se050_early_init_scp03()
115 panic(); in se050_early_init_scp03()
|
| /optee_os/core/arch/arm/plat-stm32mp2/drivers/ |
| H A D | stm32mp25_syscfg.c | 84 panic(); in stm32mp25_syscfg_set_amcr()
90 panic(); in stm32mp25_syscfg_set_amcr()
96 panic(); in stm32mp25_syscfg_set_amcr()
102 panic(); in stm32mp25_syscfg_set_amcr()
108 panic(); in stm32mp25_syscfg_set_amcr()
113 panic(); in stm32mp25_syscfg_set_amcr()
|
| /optee_os/core/drivers/clk/sam/ |
| H A D | sama5d2_clk.c | 354 panic(); in pmc_setup()
361 panic(); in pmc_setup()
365 panic(); in pmc_setup()
374 panic(); in pmc_setup()
379 panic(); in pmc_setup()
388 panic(); in pmc_setup()
394 panic(); in pmc_setup()
403 panic(); in pmc_setup()
407 panic(); in pmc_setup()
417 panic(); in pmc_setup()
[all …]
|
| H A D | at91_cpu_opp.c | 27 panic("Invalid CPU OPP Rates Array"); in get_rates_array()
107 panic("Invalid offset of opp-table"); in opp_rates_setup()
110 panic("Invalid opp-table"); in opp_rates_setup()
114 panic("CPU OPP rate array shortage"); in opp_rates_setup()
117 panic("Get opp-hz failed"); in opp_rates_setup()
149 panic("CPU OPP clock alloc failed"); in at91_clk_register_cpu_opp()
159 panic("CPU clock should always enabled"); in at91_clk_register_cpu_opp()
|
| H A D | sama7g5_clk.c | 1283 panic(); in pmc_setup_sama7g5()
1305 panic(); in pmc_setup_sama7g5()
1312 panic(); in pmc_setup_sama7g5()
1321 panic(); in pmc_setup_sama7g5()
1328 panic(); in pmc_setup_sama7g5()
1378 panic(); in pmc_setup_sama7g5()
1400 panic(); in pmc_setup_sama7g5()
1410 panic(); in pmc_setup_sama7g5()
1427 panic(); in pmc_setup_sama7g5()
1448 panic(); in pmc_setup_sama7g5()
[all …]
|
| /optee_os/core/arch/arm/plat-stm32mp1/pm/ |
| H A D | psci.c | 76 panic(); in psci_affinity_info()
101 panic(); in stm32_pm_cpu_power_down_wfi()
116 panic(); in stm32mp_register_online_cpu()
180 panic(); in psci_cpu_on()
215 panic(); in psci_cpu_off()
219 panic(); in psci_cpu_off()
239 panic(); in psci_system_off()
247 panic(); in psci_system_reset()
|
| /optee_os/core/arch/arm/plat-stm32mp1/drivers/ |
| H A D | stm32mp1_pmic.c | 91 panic(); in priv_dt_properties()
147 panic(); in regu_lp_state2idx()
163 panic(); in dt_get_regu_low_power_config()
172 panic(); in dt_get_regu_low_power_config()
202 panic(); in dt_get_regu_low_power_config()
225 panic(); in stm32mp_pmic_apply_lp_config()
232 panic(); in stm32mp_pmic_apply_lp_config()
236 panic(); in stm32mp_pmic_apply_lp_config()
240 panic(); in stm32mp_pmic_apply_lp_config()
244 panic(); in stm32mp_pmic_apply_lp_config()
[all …]
|
| H A D | stm32mp1_pmic.h | 31 panic(); in stm32mp_get_pmic()
36 panic(); in stm32mp_put_pmic()
|
| H A D | stm32mp1_pwr.c | 89 panic(); in stm32mp1_pwr_regulator_set_state()
217 panic(); in set_fixed_vdd_hslv_mode()
221 panic(); in set_fixed_vdd_hslv_mode()
235 panic("Vdd too high for related IO domains"); in set_fixed_vdd_hslv_mode()
269 panic(); in stm32mp1_pwr_regu_probe()
275 panic(); in stm32mp1_pwr_regu_probe()
|
| /optee_os/core/arch/arm/plat-sam/ |
| H A D | freq.c | 25 panic(); in get_freq_from_dt()
33 panic(); in get_freq_from_dt()
36 panic(); in get_freq_from_dt()
|
| /optee_os/core/lib/scmi-server/ |
| H A D | scmi_reset_consumer.c | 75 panic("Unexpected init deferral"); in optee_scmi_server_init_resets()
95 panic(); in optee_scmi_server_init_resets()
115 panic(); in optee_scmi_server_init_resets()
121 panic(); in optee_scmi_server_init_resets()
128 panic(); in optee_scmi_server_init_resets()
|
| H A D | scmi_server_scpfw.c | 130 panic(); in optee_scmi_server_probe_agent()
142 panic(); in optee_scmi_server_probe_agent()
147 panic(); in optee_scmi_server_probe_agent()
171 panic(); in optee_scmi_server_probe_agent()
195 panic("Error during clocks init"); in optee_scmi_server_init_protocol()
200 panic("Error during resets init"); in optee_scmi_server_init_protocol()
205 panic(); in optee_scmi_server_init_protocol()
348 panic(); in optee_scmi_server_init()
352 panic(); in optee_scmi_server_init()
|
| /optee_os/core/arch/arm/include/kernel/ |
| H A D | arch_scall.h | 44 bool panic, uint32_t panic_code) in scall_set_sys_return_regs() argument
47 regs->r1 = panic; in scall_set_sys_return_regs()
51 regs->x1 = panic; in scall_set_sys_return_regs()
|
| /optee_os/core/arch/arm/plat-stm32mp1/ |
| H A D | plat_tzc400.c | 111 panic(); in tzc_it_handler()
282 panic(); in stm32mp_tzc_cfg_boot_region()
288 panic(); in stm32mp_tzc_cfg_boot_region()
366 panic("Error adding region"); in add_node_memory_regions()
369 panic("Not able to exclude region"); in add_node_memory_regions()
392 panic("Error adding region"); in add_carved_out_nsec()
438 panic("No memory reference for TZC DT node"); in stm32mp_tzc_parse_fdt()
481 panic(); in stm32mp1_tzc_probe()
493 panic(); in stm32mp1_tzc_probe()
496 panic(); in stm32mp1_tzc_probe()
[all …]
|
| /optee_os/core/arch/arm/kernel/ |
| H A D | boot.c | 132 panic(); in __panic_at_smc_return()
220 panic("HW doesn't support CE instructions"); in check_crypto_extensions()
419 panic("core_virt_mem_pool init failed"); in init_virt_pool()
554 panic(); in init_pager_runtime()
823 panic("Failed to add OP-TEE Device Tree node"); in update_external_dt()
826 panic("Failed to config PSCI"); in update_external_dt()
830 panic("Failed to config non-secure memory"); in update_external_dt()
834 panic("Failed to config secure memory"); in update_external_dt()
1010 panic(); in boot_init_primary_late()
1141 panic("Failed to map transfer list"); in boot_init_primary_early()
[all …]
|