| /OK3568_Linux_fs/u-boot/arch/arm/dts/ |
| H A D | tegra210-p2371-2180.dts | 14 i2c0 = "/i2c@7000d000";
61 "pcie-3", "pcie-4";
77 power-gpios = <&gpio TEGRA_GPIO(Z, 3) GPIO_ACTIVE_HIGH>;
88 i2c@7000d000 {
|
| H A D | tegra30-tamonten.dtsi | 20 i2c4 = "/i2c@7000d000";
51 i2c@7000d000 {
59 wp-gpios = <&gpio TEGRA_GPIO(I, 3) GPIO_ACTIVE_HIGH>;
|
| H A D | tegra20-colibri.dts | 14 i2c0 = "/i2c@7000d000";
81 i2c@7000d000 {
158 regulator-name = "+V3.3";
|
| H A D | tegra30-apalis.dts | 14 i2c0 = "/i2c@7000d000";
47 /* TS_DIFF1/2/3/4 left disabled */
56 pci@3,0 {
92 i2c@7000d000 {
157 * EN_+V3.3 switching via FET:
158 * +V3.3_AUDIO_AVDD_S, +V3.3 and +V1.8_VDD_LAN
260 cd-gpios = <&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_LOW>;
319 regulator-name = "3v3";
|
| H A D | tegra30-beaver.dts | 14 i2c0 = "/i2c@7000d000";
52 pci@3,0 {
78 i2c@7000d000 {
200 wp-gpios = <&gpio TEGRA_GPIO(T, 3) GPIO_ACTIVE_HIGH>;
274 vdd_5v_sata_reg: regulator@3 {
276 reg = <3>;
|
| H A D | tegra30-cardhu.dts | 14 i2c0 = "/i2c@7000d000";
49 pci@3,0 {
75 i2c@7000d000 {
189 wp-gpios = <&gpio TEGRA_GPIO(T, 3) GPIO_ACTIVE_HIGH>;
255 emmc_3v3_reg: regulator@3 {
257 reg = <3>;
|
| H A D | tegra124-jetson-tk1.dts | 14 i2c0 = "/i2c@7000d000";
73 i2c@7000d000 {
290 nvidia,lanes = "pcie-2", "pcie-3",
379 vdd_3v3_run: regulator@3 {
381 reg = <3>;
|
| H A D | tegra124-cei-tk1-som.dts | 14 i2c0 = "/i2c@7000d000";
74 i2c@7000d000 {
291 nvidia,lanes = "pcie-0", "pcie-1", "pcie-2", "pcie-3",
374 vdd_3v3_run: regulator@3 {
376 reg = <3>;
|
| H A D | rk3xxx.dtsi | 66 <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>;
107 gic: interrupt-controller@1013d000 {
110 #interrupt-cells = <3>;
247 i2c0: i2c@2002d000 {
|
| H A D | imx7d.dtsi | 66 etm@3007d000 {
126 fsl,num-tx-queues=<3>;
127 fsl,num-rx-queues=<3>;
|
| /OK3568_Linux_fs/kernel/Documentation/translations/zh_CN/ |
| H A D | oops-tracing.txt | 56 （3）使用Kdump（请参看Documentation/admin-guide/kdump/kdump.rst），
99 7e 04 40 89 42 54 8b 43 04 3b 05 00 f6 52 c0
132 地址解析的完整支持至少应该使用1.3-pl3的sysklogd包。
161 Aug 29 09:51:01 blizard kernel: current->tss.cr3 = 0062d000, %cr3 = 0062d000
197 3：'S'如果oops发生在SMP内核中，运行于没有证明安全运行多处理器的硬件。 当前这种
|
| /OK3568_Linux_fs/kernel/arch/arm/boot/dts/ |
| H A D | rk3xxx.dtsi | 70 <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>;
130 gic: interrupt-controller@1013d000 {
133 #interrupt-cells = <3>;
160 qos_gpu: qos@1012d000 {
264 dmas = <&dmac2 3>;
316 i2c0: i2c@2002d000 {
|
| H A D | bcm28155-ap.dts | 29 uart@3e000000 {
33 i2c@3e016000 {
38 i2c@3e017000 {
43 i2c@3e018000 {
48 i2c@3500d000 {
57 sdio2: sdio@3f190000 {
65 sdio4: sdio@3f1b0000 {
73 pwm: pwm@3e01a000 {
77 usbotg: usb@3f120000 {
83 usbphy: usb-phy@3f130000 {
|
| H A D | bcm953012hr.dts | 2 * SPDX-License-Identifier: BSD-3-Clause
77 m25p,default-addr-width = <3>;
86 partition@d000 {
|
| H A D | bcm953012k.dts | 87 m25p,default-addr-width = <3>;
96 partition@d000 {
|
| /OK3568_Linux_fs/u-boot/doc/device-tree-bindings/gpio/ |
| H A D | nvidia,tegra20-gpio.txt | 16 bits[3:0] trigger type and level flags:
21 Valid combinations are 1, 2, 3, 4, 8.
26 gpio: gpio@6000d000 {
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/gpio/ |
| H A D | nvidia,tegra20-gpio.txt | 16 bits[3:0] trigger type and level flags:
21 Valid combinations are 1, 2, 3, 4, 8.
26 gpio: gpio@6000d000 {
|
| /OK3568_Linux_fs/kernel/arch/arm64/boot/dts/nvidia/ |
| H A D | tegra210-p2180.dtsi | 11 rtc0 = "/i2c@7000d000/pmic@3c";
34 i2c@7000d000 {
38 pmic: pmic@3c {
323 cpu@3 {
|
| H A D | tegra210-p2530.dtsi | 27 i2c@7000d000 {
62 cpu@3 {
|
| /OK3568_Linux_fs/u-boot/doc/ |
| H A D | README.davinci.nand_spl | 97 step 3:
125 writeuboot nandrbl uboot;nand erase c0000 5d000;nand write 80003800 c0000 5d000
|
| /OK3568_Linux_fs/kernel/arch/arm64/boot/dts/freescale/ |
| H A D | qoriq-fman3-0-1g-5.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
10 fman0_rx_0x0d: port@8d000 {
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/thermal/ |
| H A D | max77620_thermal.txt | 27 i2c@7000d000 {
28 spmic: max77620@3c {
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/interrupt-controller/ |
| H A D | st,stm32-exti.yaml | 82 exti1: interrupt-controller@5000d000 {
95 interrupts = <1>, <2>, <3>, <6>, <7>, <8>, <9>, <10>, <23>, <40>, <41>, <42>, <62>, <76>;
|
| /OK3568_Linux_fs/kernel/arch/arm64/boot/dts/marvell/ |
| H A D | armada-37xx.dtsi | 90 cpu_misc: system-controller@d000 {
163 <&tbg 3>, <&xtalclk>;
171 <&tbg 3>, <&xtalclk>;
358 interrupts = <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>;
365 usb2_utmi_otg_phy: phy@5d000 {
467 #interrupt-cells = <3>;
483 #address-cells = <3>;
502 <0 0 0 3 &pcie_intc 2>,
503 <0 0 0 4 &pcie_intc 3>;
|
| /OK3568_Linux_fs/u-boot/doc/device-tree-bindings/clock/ |
| H A D | nvidia,tegra20-car.txt | 31 3 ac97
52 24 3d
191 i2c@7000d000 {
|