| c2e7e72b | 19-Jan-2017 |
Rick Altherr <raltherr@google.com> |
bootm: relocate ramdisk if CONFIG_SYS_BOOT_RAMDISK_HIGH set
In 35fc84f, bootm was refactored so plain 'bootm' and
'bootm <subcommand>' shared a common implementation.
The 'bootm ramdisk' command imp
bootm: relocate ramdisk if CONFIG_SYS_BOOT_RAMDISK_HIGH set
In 35fc84f, bootm was refactored so plain 'bootm' and
'bootm <subcommand>' shared a common implementation.
The 'bootm ramdisk' command implementation is now part of the common
implementation but not invoke by plain 'bootm' since the original
implementation never did ramdisk relocation. Instead, ramdisk
relocation happened in image_setup_linux() which is typically called
during the OS portion of 'bootm'.
On ARM, parameters to the Linux kernel can either be passed by FDT or
ATAGS. When using FDT, image_setup_linux() is called which also triggers
ramdisk relocation. When using ATAGS, image_setup_linux() is _not_
called because it mostly does FDT setup.
Instead of calling image_setup_linux() in both FDT and ATAGS cases,
include BOOTM_STATE_RAMDISK in the requested states during a plain
'bootm' if CONFIG_SYS_BOOT_RAMDISK_HIGH is set and remove the ramdisk
relocation from image_setup_linux(). This causes ramdisk relocation to
happen on any system where CONFIG_SYS_BOOT_RAMDISK_HIGH regardless of
the OS being booted. Also remove IMAGE_ENABLE_RAMDISK_HIGH as it was
only used by the now-removed code from image_setup_linux().
Signed-off-by: Rick Altherr <raltherr@google.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Joel Stanley <joel@jms.id.au>
show more ...
|
| b05bf6c7 | 09-Jan-2017 |
Andreas Färber <afaerber@suse.de> |
cmd/fdt: Make fdt get value endian-safe for single-cell properties
On a Raspberry Pi 2 disagreements on cell endianness can be observed:
U-Boot> fdt print /soc/gpio@7e200000 phandle
phandle = <
cmd/fdt: Make fdt get value endian-safe for single-cell properties
On a Raspberry Pi 2 disagreements on cell endianness can be observed:
U-Boot> fdt print /soc/gpio@7e200000 phandle
phandle = <0x0000000d>
U-Boot> fdt get value myvar /soc/gpio@7e200000 phandle; printenv myvar
myvar=0x0D000000
Fix this by always treating the pointer as BE and converting it in
fdt_value_setenv(), like its counterpart fdt_parse_prop() already does.
Consistently use fdt32_t, fdt32_to_cpu() and cpu_to_fdt32().
Fixes: bc80295 ("fdt: Add get commands to fdt")
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Gerald Van Baren <gvb@unssw.com>
Signed-off-by: Andreas Färber <afaerber@suse.de>
Acked-by: Simon Glass <sjg@chromium.org>
show more ...
|