Home
last modified time | relevance | path

Searched refs:SGMII (Results 1 – 25 of 45) sorted by relevance

12

/OK3568_Linux_fs/kernel/drivers/net/dsa/sja1105/
H A DKconfig15 - SJA1105P (Gen. 2, No SGMII, No TT-Ethernet)
16 - SJA1105Q (Gen. 2, No SGMII, TT-Ethernet)
17 - SJA1105R (Gen. 2, SGMII, No TT-Ethernet)
18 - SJA1105S (Gen. 2, SGMII, TT-Ethernet)
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/net/
H A Dmediatek-net.txt37 SGMII setup which is required for those SoCs equipped with SGMII such
38 as MT7622 and MT7629 SoC. And MT7622 have only one set of SGMII shared
39 by GMAC1 and GMAC2; MT7629 have two independent sets of SGMII directed
H A Dapm-xgene-enet.txt9 - "apm,xgene1-sgenet": SGMII based 1G interface
20 This is supported only on SGMII based 1GbE and 10GbE interfaces.
/OK3568_Linux_fs/kernel/Documentation/hwmon/
H A Dbcm54140.rst3 Broadcom BCM54140 Quad SGMII/QSGMII PHY
17 The Broadcom BCM54140 is a Quad SGMII/QSGMII PHY which supports monitoring
/OK3568_Linux_fs/u-boot/board/freescale/ls2080aqds/
H A DREADME18 - SGMII, SGMII 2.5
143 - Card can operate with up to 8 SGMII lane simultaneously
152 Supported PHY addresses during SGMII:
162 Mapping DPMACx to PHY during SGMII
/OK3568_Linux_fs/u-boot/board/freescale/ls1012ardb/
H A DREADME18 - SGMII, SGMII 2.5
/OK3568_Linux_fs/u-boot/board/freescale/ls1012aqds/
H A DREADME18 - SGMII, SGMII 2.5
/OK3568_Linux_fs/u-boot/board/freescale/ls1043aqds/
H A DREADME18 - SGMII, SGMII 2.5
/OK3568_Linux_fs/u-boot/doc/
H A DREADME.b4860qds74 - A Vitesse dual SGMII phy VSC8662 links the B4860 SGMII lines to 2xRJ-45 copper connectors
102 controllers, less serdes lanes, less SGMII interfaces and reduced target frequencies.
112 5. 3 SGMII interfaces
310 When using [DEFAULT] RCW, which including 2 * 1G SGMII on board and 2 * 1G
311 SGMII on SGMII riser card.
/OK3568_Linux_fs/u-boot/board/freescale/ls1046ardb/
H A DREADME19 - Lane2: SGMII.5
20 - Lane3: SGMII.6
/OK3568_Linux_fs/u-boot/board/freescale/ls1046aqds/
H A DREADME18 - SGMII, SGMII 2.5
/OK3568_Linux_fs/u-boot/board/freescale/t102xqds/
H A DREADME40 - Four SGMII interface supporting 1000 Mbps
41 - Three SGMII interfaces supporting up to 2500 Mbps
80 - SGMII 1G and SGMII 2.5G
102 - Four SGMII interface supporting 1Gbps
103 - Three SGMII interfaces supporting 2.5Gbps
/OK3568_Linux_fs/u-boot/board/freescale/ls1021aiot/
H A Dls102xa_rcw_sd.cfg5 #Default with 2 x SGMII (no SATA)
/OK3568_Linux_fs/u-boot/board/freescale/t1040qds/
H A DREADME36 - Upto six SGMII interface supporting 1000 Mbps
37 - One SGMII interface supporting upto 2500 Mbps
57 — SGMII
/OK3568_Linux_fs/u-boot/arch/arm/cpu/armv8/fsl-layerscape/doc/
H A DREADME.soc32 - Up to 4 x SGMII supporting 1000Mbps
33 - Up to 2 x SGMII supporting 2500Mbps
159 - Up to 4 x SGMII supporting 1000Mbps (MAC 5, 6, 9, 10)
160 - Up to 3 x SGMII supporting 2500Mbps (MAC 5, 9, 10)
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/phy/
H A Dti,phy-am654-serdes.txt14 2 - ICSS2 SGMII Lane0
18 2 - ICSS2 SGMII Lane1
/OK3568_Linux_fs/u-boot/board/freescale/t208xqds/
H A DREADME59 - 1Gbps/2.5Gbps SGMII Riser card
65 - Supports Aurora debug, PEX, SATA, SGMII, sRIO, HiGig, XFI and XAUI
108 - T2080QDS can support 1G-KX by using SGMII protocol, but serdes lane
109 runs in 1G-KX mode. By default, the lane runs in SGMII mode, to set a lane
/OK3568_Linux_fs/kernel/Documentation/networking/
H A Dsfp-phylink.rst37 In-band mode is used with 802.3z, SGMII and similar interface modes,
50 does not use in-band SGMII signalling. The PHY is expected to follow
64 to the MAC through the SGMII control word, and the MAC is expected to
211 methods such as 1000base-X and SGMII.
/OK3568_Linux_fs/kernel/arch/arm/boot/dts/
H A Dls1021a-tsn.dts234 /* SGMII PCS for enet0 */
242 /* SGMII PCS for enet1 */
/OK3568_Linux_fs/u-boot/board/freescale/t102xrdb/
H A DREADME40 - Four SGMII interface supporting 1000 Mbps
41 - Three SGMII interfaces supporting up to 2500 Mbps
111 - one 1G SGMII port on-board(RTL8211FS PHY)
112 - one 2.5G SGMII port on-board(AQR105 PHY)
/OK3568_Linux_fs/u-boot/board/freescale/t104xrdb/
H A DREADME24 - 3 SGMII on DTSEC1, DTSEC2 & DTSEC3
67 - Upto six SGMII interface supporting 1000 Mbps
68 - One SGMII interface supporting upto 2500 Mbps
98 2: SGMII
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/net/dsa/
H A Dsja1105.txt17 For example, SGMII can only be specified on port 4 of R and S devices,
18 and the non-SGMII devices, while pin-compatible, are not equal in terms
/OK3568_Linux_fs/u-boot/board/freescale/ls1021atwr/
H A DREADME41 - MII, RMII, RGMII, and SGMII support
47 - Two SGMII interfaces supporting 1000 Mbps
/OK3568_Linux_fs/u-boot/board/freescale/ls1021aqds/
H A DREADME41 - MII, RMII, RGMII, and SGMII support
47 - Two SGMII interfaces supporting 1000 Mbps
/OK3568_Linux_fs/u-boot/arch/arm/mach-mvebu/serdes/a38x/
H A Dhigh_speed_env_spec.c1002 serdes_seq_db[SGMII_POWER_UP_SEQ].data_arr_idx = SGMII; in hws_serdes_seq_db_init()
1010 serdes_seq_db[SGMII_1_25_SPEED_CONFIG_SEQ].data_arr_idx = SGMII; in hws_serdes_seq_db_init()
1034 serdes_seq_db[SGMII_ELECTRICAL_CONFIG_SEQ].data_arr_idx = SGMII; in hws_serdes_seq_db_init()
1041 serdes_seq_db[SGMII_TX_CONFIG_SEQ1].data_arr_idx = SGMII; in hws_serdes_seq_db_init()
1057 serdes_seq_db[SGMII_TX_CONFIG_SEQ2].data_arr_idx = SGMII; in hws_serdes_seq_db_init()

12