| /OK3568_Linux_fs/kernel/drivers/net/ethernet/chelsio/cxgb3/ |
| H A D | vsc8211.c | 119 BMCR_PDOWN | BMCR_ISOLATE, in vsc8211_autoneg_enable()
126 BMCR_PDOWN | BMCR_ISOLATE, in vsc8211_autoneg_restart()
318 return t3_mdio_change_bits(cphy, 0, MII_BMCR, BMCR_PDOWN, in vsc8211_power_down()
319 enable ? BMCR_PDOWN : 0); in vsc8211_power_down()
|
| /OK3568_Linux_fs/kernel/drivers/net/phy/ |
| H A D | national.c | 96 phy_write(phydev, MII_BMCR, (bmcr | BMCR_PDOWN)); in ns_giga_speed_fallback()
102 phy_write(phydev, MII_BMCR, (bmcr & ~BMCR_PDOWN)); in ns_giga_speed_fallback()
|
| H A D | motorcomm.c | 632 phy_write(phydev, MII_BMCR, value | BMCR_PDOWN); in yt8521_suspend()
636 phy_write(phydev, MII_BMCR, value | BMCR_PDOWN); in yt8521_suspend()
663 phy_write(phydev, MII_BMCR, value & ~BMCR_PDOWN); in yt8521_resume()
669 phy_write(phydev, MII_BMCR, value & ~BMCR_PDOWN); in yt8521_resume()
|
| H A D | broadcom.c | 137 rc = phy_set_bits(phydev, MII_BMCR, BMCR_PDOWN); in bcm54616s_config_init()
151 rc = phy_clear_bits(phydev, MII_BMCR, BMCR_PDOWN); in bcm54616s_config_init()
162 return phy_clear_bits(phydev, MII_BMCR, BMCR_PDOWN); in bcm54616s_config_init()
|
| H A D | bcm54140.c | 479 ret = phy_modify(phydev, MII_BMCR, 0, BMCR_PDOWN); in bcm54140_b0_workaround()
483 ret = phy_modify(phydev, MII_BMCR, BMCR_PDOWN, 0); in bcm54140_b0_workaround()
|
| H A D | at803x.c | 309 value = BMCR_PDOWN; in at803x_suspend()
318 return phy_modify(phydev, MII_BMCR, BMCR_PDOWN | BMCR_ISOLATE, 0); in at803x_resume()
|
| /OK3568_Linux_fs/kernel/arch/arm/mach-imx/ |
| H A D | mach-imx6q.c | 142 if (val & BMCR_PDOWN) in ar8035_phy_fixup()
143 phy_write(dev, 0x0, val & ~BMCR_PDOWN); in ar8035_phy_fixup()
|
| /OK3568_Linux_fs/kernel/drivers/net/dsa/b53/ |
| H A D | b53_serdes.c | 153 reg &= ~BMCR_PDOWN; in b53_serdes_link_set()
155 reg |= BMCR_PDOWN; in b53_serdes_link_set()
|
| /OK3568_Linux_fs/kernel/drivers/net/dsa/mv88e6xxx/ |
| H A D | serdes.c | 109 new_val = val & ~BMCR_PDOWN; in mv88e6352_serdes_power()
111 new_val = val | BMCR_PDOWN; in mv88e6352_serdes_power()
569 new_val = val & ~(BMCR_RESET | BMCR_LOOPBACK | BMCR_PDOWN); in mv88e6390_serdes_power_sgmii()
571 new_val = val | BMCR_PDOWN; in mv88e6390_serdes_power_sgmii()
|
| /OK3568_Linux_fs/prebuilts/gcc/linux-x86/arm/gcc-arm-10.3-2021.07-x86_64-arm-none-linux-gnueabihf/arm-none-linux-gnueabihf/libc/usr/include/linux/ |
| H A D | mii.h | 47 #define BMCR_PDOWN 0x0800 /* Enable low power state */ macro
|
| H A D | mdio.h | 79 #define MDIO_CTRL1_LPOWER BMCR_PDOWN
|
| /OK3568_Linux_fs/prebuilts/gcc/linux-x86/aarch64/gcc-arm-10.3-2021.07-x86_64-aarch64-none-linux-gnu/aarch64-none-linux-gnu/libc/usr/include/linux/ |
| H A D | mii.h | 47 #define BMCR_PDOWN 0x0800 /* Enable low power state */ macro
|
| H A D | mdio.h | 79 #define MDIO_CTRL1_LPOWER BMCR_PDOWN
|
| /OK3568_Linux_fs/kernel/include/uapi/linux/ |
| H A D | mii.h | 47 #define BMCR_PDOWN 0x0800 /* Enable low power state */ macro
|
| H A D | mdio.h | 83 #define MDIO_CTRL1_LPOWER BMCR_PDOWN
|
| /OK3568_Linux_fs/kernel/drivers/net/ |
| H A D | sungem_phy.c | 77 val &= ~(BMCR_ISOLATE | BMCR_PDOWN); in reset_one_mii_phy()
224 sungem_phy_write(phy, MII_BMCR, BMCR_PDOWN); in bcm5400_suspend()
280 sungem_phy_write(phy, MII_BMCR, BMCR_PDOWN); in bcm5401_suspend()
417 sungem_phy_write(phy, MII_BMCR, BMCR_PDOWN); in generic_suspend()
|
| /OK3568_Linux_fs/u-boot/include/linux/ |
| H A D | mii.h | 44 #define BMCR_PDOWN 0x0800 /* Enable low power state */ macro
|
| H A D | mdio.h | 74 #define MDIO_CTRL1_LPOWER BMCR_PDOWN
|
| /OK3568_Linux_fs/u-boot/test/rockchip/ |
| H A D | test-net.c | 109 val &= ~(BMCR_ANENABLE | BMCR_PDOWN); in eth_setup_loopback_test()
|
| /OK3568_Linux_fs/u-boot/drivers/net/phy/ |
| H A D | mv88e61xx.c | 575 val &= ~(BMCR_PDOWN); in mv88e61xx_serdes_init()
785 val &= ~(BMCR_PDOWN); in mv88e61xx_phy_enable()
|
| /OK3568_Linux_fs/u-boot/drivers/usb/eth/ |
| H A D | r8152.c | 606 if (data & BMCR_PDOWN) { in r8152b_hw_phy_cfg()
607 data &= ~BMCR_PDOWN; in r8152b_hw_phy_cfg()
737 if (data & BMCR_PDOWN) { in r8153_hw_phy_cfg()
738 data &= ~BMCR_PDOWN; in r8153_hw_phy_cfg()
|
| /OK3568_Linux_fs/kernel/drivers/net/ethernet/stmicro/stmmac/ |
| H A D | dwmac-rk-tool.c | 168 phy_val &= ~BMCR_PDOWN; in dwmac_rk_enable_mac_loopback()
170 phy_val &= ~BMCR_PDOWN; in dwmac_rk_enable_mac_loopback()
253 val &= ~BMCR_PDOWN; in dwmac_rk_enable_phy_loopback()
|
| /OK3568_Linux_fs/kernel/drivers/net/ethernet/smsc/ |
| H A D | smc911x.c | 743 bmcr |= BMCR_PDOWN; in smc911x_phy_fixed()
761 bmcr &= ~BMCR_PDOWN; in smc911x_phy_fixed()
827 bmcr |= BMCR_PDOWN; in smc911x_phy_powerdown()
|
| /OK3568_Linux_fs/kernel/drivers/net/ethernet/sun/ |
| H A D | sunbmac.c | 500 bp->sw_bmcr = (BMCR_ISOLATE | BMCR_PDOWN | BMCR_LOOPBACK); in try_next_permutation()
593 bp->sw_bmcr = (BMCR_ISOLATE | BMCR_PDOWN | BMCR_LOOPBACK); in bigmac_begin_auto_negotiation()
|
| /OK3568_Linux_fs/kernel/drivers/net/ethernet/dec/tulip/ |
| H A D | media.c | 519 BMCR_PDOWN | BMCR_SPEED100 | BMCR_LOOPBACK | in tulip_find_mii()
|