Home
last modified time | relevance | path

Searched full:routed (Results 1 – 25 of 411) sorted by relevance

12345678910>>...17

/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/leds/
H A Dleds-bcm6328.txt207 /* USB link/activity routed to USB LED */
213 /* INET activity routed to INET LED */
219 /* EPHY0 link routed to EPHY0 LED */
225 /* EPHY1 link routed to EPHY1 LED */
231 /* EPHY2 link routed to EPHY2 LED */
237 /* EPHY3 link routed to EPHY3 LED */
259 /* USB/INET link/activity routed to USB LED */
265 /* EPHY0/1/2/3 link routed to EPHY0 LED */
287 /* USB link/act and INET act routed to USB LED */
293 /* EPHY3 link routed to EPHY0 LED */
[all …]
/OK3568_Linux_fs/kernel/Documentation/networking/devlink/
H A Ddevlink-trap.rst180 routed and they have a unicast destination IP and a multicast destination
185 routed and their destination IP is the loopback address (i.e., 127.0.0.0/8
190 routed and their source IP is multicast (i.e., 224.0.0.0/8 and ff::/8)
194 routed and their source IP is the loopback address (i.e., 127.0.0.0/8 and ::1/128)
198 routed and their IP header is corrupted: wrong checksum, wrong IP version
203 routed and their source IP is limited broadcast (i.e., 255.255.255.255/32)
207 be routed and their IPv6 multicast destination IP has a reserved scope
212 be routed and their IPv6 multicast destination IP has an interface-local scope
216 - Traps packets that should have been routed by the device, but were bigger
237 supposed to be routed. For example, IGMP queries can be flooded by the
[all …]
H A Dmlxsw.rst73 routed from a disabled router interface (RIF). This can happen during
79 routed through a disabled router interface (RIF). This can happen during
/OK3568_Linux_fs/u-boot/arch/x86/include/asm/
H A Dpirq_routing.h32 u8 link; /* IRQ line ID, 0=not routed */
68 * pirq_check_irq_routed() - Check whether an IRQ is routed to 8259 PIC
70 * This function checks whether an IRQ is routed to 8259 PIC for a given link.
78 * @return: true if the irq is already routed to 8259 for a given link,
102 * This function assigns the IRQ to a PIRQ link so that the PIRQ is routed to
110 * @irq: IRQ to which the PIRQ is routed
118 * PIRQs and finally 8259 PIC. The routed irq number is written to interrupt
/OK3568_Linux_fs/kernel/include/linux/bcma/
H A Dbcma_driver_mips.h6 /* which sbflags get routed to mips interrupt 1 */
9 /* which sbflags get routed to mips interrupt 2 */
12 /* which sbflags get routed to mips interrupt 3 */
15 /* which sbflags get routed to mips interrupt 4 */
/OK3568_Linux_fs/kernel/Documentation/ABI/testing/
H A Dsysfs-bus-pci-drivers-ehci_hcd10 high-speed device is plugged in, the connection is routed
12 is plugged in, the connection is routed to the companion
17 connection to be routed to the companion controller.
19 file causes connections on that port to be routed to the
/OK3568_Linux_fs/u-boot/arch/x86/lib/
H A Dpirq_routing.c29 /* Have we already routed it? */ in pirq_get_next_free_irq()
40 /* If it's not yet routed, use it */ in pirq_get_next_free_irq()
46 /* But if it was already routed, try the next one */ in pirq_get_next_free_irq()
77 debug("not routed\n"); in pirq_route_irqs()
85 /* yet not routed */ in pirq_route_irqs()
/OK3568_Linux_fs/kernel/arch/arm/boot/dts/
H A Darmada-385-turris-omnia.dts161 /* routed to PCIe0/mSATA connector (CN7A) */
169 /* routed to PCIe1/USB2 connector (CN61A) */
177 /* routed to PCIe2 connector (CN62A) */
185 /* routed to SFP+ */
345 /* MISO, MOSI, SCLK and CS2 are routed to pin header CN11 */
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/connector/
H A Dusb-connector.yaml241 # Micro-USB connector with HS lines routed via controller (MUIC).
251 # USB-C connector attached to CC controller (s2mm005), HS lines routed
253 # DisplayPort video lines are routed to the connector via SS mux in USB3 PHY.
304 # with SS 2:1 MUX. HS lines routed to SoC, SS lines routed to the MUX and
343 # Micro-USB connector with HS lines routed via controller (MUIC) and MHL
/OK3568_Linux_fs/kernel/Documentation/admin-guide/media/
H A Dimx.rst150 containing each virtual channel that are routed to CSIs or video
153 On i.MX6 solo/dual-lite, all four virtual channel buses are routed to
157 On i.MX6 Quad, virtual channel 0 is routed to IPU1-CSI0 (after selected
159 and IPU2-CSI0, respectively, and virtual channel 3 is routed to
194 When the direct source pad is routed to the ipuX_ic_prp entity, frames
198 When the direct source pad is routed to the ipuX_vdic entity, the VDIC
204 source pad is routed to a capture device node, with a node name of the
315 routed to a capture device node, with a node name of the format
330 pad from ipuX_ic_prp, and a single source pad. The source pad is routed
427 routed as follows: vc0 to the IPU1 CSI0 mux, vc1 directly to IPU1 CSI1,
[all …]
/OK3568_Linux_fs/kernel/arch/mips/pci/
H A Dfixup-sni.c30 * Device 0: PCI EISA Bridge (directly routed)
31 * Device 1: NCR53c810 SCSI (directly routed)
32 * Device 2: PCnet32 Ethernet (directly routed)
33 * Device 3: VGA (routed to INTB)
/OK3568_Linux_fs/u-boot/arch/arm/dts/
H A Darmada-385-turris-omnia.dts194 /* routed to PCIe0/mSATA connector (CN7A) */
202 /* routed to PCIe1/USB2 connector (CN61A) */
210 /* routed to PCIe2 connector (CN62A) */
218 /* routed to SFP+ */
377 /* MISO, MOSI, SCLK and CS1 are routed to pin header CN11 */
/OK3568_Linux_fs/u-boot/board/freescale/corenet_ds/
H A Deth_superhydra.c24 * exist, and also which Fman's MACs are routed to which PHYs. So for a given
25 * Fman MAC, there is one and only PHY it connects to. MACs cannot be routed
44 * 1) An alias for each PHY node that an Ethernet node could be routed to.
560 * FM1 DTSEC5 is routed via EC1 to the first on-board in board_eth_init()
561 * RGMII port. FM2 DTSEC5 is routed via EC2 to the in board_eth_init()
563 * be routed to RGMII. in board_eth_init()
707 * FM1 DTSEC5 is routed via EC1 to the first on-board in board_eth_init()
708 * RGMII port. FM2 DTSEC5 is routed via EC2 to the in board_eth_init()
710 * be routed to RGMII. in board_eth_init()
H A Deth_hydra.c24 * exist, and also which Fman MACs are routed to which PHYs. So for a given
25 * Fman MAC, there is one and only PHY it connects to. MACs cannot be routed
44 * 1) An alias for each PHY node that an Ethernet node could be routed to.
453 * If DTSEC4 is RGMII, then it's routed via via EC1 to in board_eth_init()
455 * then it's routed via via EC2 to the second on-board in board_eth_init()
456 * RGMII port. The other DTSECs cannot be routed to in board_eth_init()
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/mailbox/
H A Domap-mailbox.txt11 interrupt lines. An output interrupt line is routed to an interrupt controller
25 routed to different processor sub-systems on DRA7xx as they are routed through
29 all these clusters are multiplexed and routed to different processor subsystems
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/interrupt-controller/
H A Dinterrupts.txt13 which the interrupts are routed; see section 2 below for details.
20 interrupts are routed and contains a single phandle referring to the interrupt
116 interrupts routed to them, so that they can wakeup the SoC from suspend. These
H A Driscv,cpu-intc.txt7 Every interrupt is ultimately routed through a hart's HLIC before it
15 interrupts connect all other device interrupts to the HLIC, which are routed
H A Dqcom,pdc.txt11 wakeup capabilities of their device interrupts routed through the PDC, must
29 need to be configured for wakeup capable GPIOs routed to
/OK3568_Linux_fs/external/xserver/Xi/
H A Dallowev.c49 * Function to allow frozen events to be routed from extension input devices.
68 * This procedure allows frozen events to be routed.
84 * This procedure allows frozen events to be routed.
/OK3568_Linux_fs/kernel/include/sound/
H A Dseq_virmidi.h55 * ATTACH = input/output events from midi device are routed to the
60 * DISPATCH = input/output events are routed to subscribers.
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/thermal/
H A Dti_soc_thermal.txt20 the talert signal is routed to;
23 line the tshut signal is routed to. The informed GPIO will
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/clock/
H A Dlpc1850-ccu.txt22 Shall contain a list of phandles for the base clocks routed
26 Shall contain a list of names for the base clock routed
/OK3568_Linux_fs/kernel/arch/arm/mach-mmp/
H A Dregs-icu.h34 * IRQ0/FIQ0 is routed to SP IRQ/FIQ.
35 * IRQ1 is routed to PJ4 IRQ, and IRQ2 is routes to PJ4 FIQ.
/OK3568_Linux_fs/u-boot/doc/device-tree-bindings/misc/
H A Dintel,irq-router.txt26 8259 PIC. Bit N is 1 means IRQ N is available to be routed.
31 is which PIRQ line the PCI interrupt pin is routed to.
/OK3568_Linux_fs/kernel/drivers/net/wireless/rockchip_wlan/rkwifi/bcmdhd_indep_power/include/
H A Dsbconfig.h133 #define SBIPS_INT1_MASK 0x3f /**< which sbflags get routed to mips interrupt 1 */
135 #define SBIPS_INT2_MASK 0x3f00 /**< which sbflags get routed to mips interrupt 2 */
137 #define SBIPS_INT3_MASK 0x3f0000 /**< which sbflags get routed to mips interrupt 3 */
139 #define SBIPS_INT4_MASK 0x3f000000 /**< which sbflags get routed to mips interrupt 4 */

12345678910>>...17