Home
last modified time | relevance | path

Searched full:mbits (Results 1 – 25 of 62) sorted by relevance

123

/OK3568_Linux_fs/kernel/drivers/net/wireless/ti/wl1251/
H A Dtx.h106 * 0x0001 - 1Mbits
107 * 0x0002 - 2Mbits
108 * 0x0004 - 5.5Mbits
109 * 0x0008 - 6Mbits
110 * 0x0010 - 9Mbits
111 * 0x0020 - 11Mbits
112 * 0x0040 - 12Mbits
113 * 0x0080 - 18Mbits
114 * 0x0100 - 22Mbits
115 * 0x0200 - 24Mbits
[all …]
/OK3568_Linux_fs/kernel/drivers/net/wireless/zydas/zd1211rw/
H A Dzd_mac.c85 * "11 Mbits : 4, 3, 2, 1, 0" means :
87 * - 1st rate is index 3 (ie 11 Mbits)
88 * - 2nd rate is index 2 (ie 5.5 Mbits)
89 * - 3rd rate is index 1 (ie 2 Mbits)
90 * - 4th rate is index 0 (ie 1 Mbits)
94 { /* 1 Mbits */ 1, { 0 }},
95 { /* 2 Mbits */ 2, { 1, 0 }},
96 { /* 5.5 Mbits */ 3, { 2, 1, 0 }},
97 { /* 11 Mbits */ 4, { 3, 2, 1, 0 }},
98 { /* 6 Mbits */ 5, { 4, 3, 2, 1, 0 }},
[all …]
/OK3568_Linux_fs/kernel/samples/vfs/
H A Dtest-statx.c151 unsigned char bits, mbits; in dump_statx() local
170 mbits = stx->stx_attributes_mask >> byte; in dump_statx()
174 if (!(mbits & 0x80)) in dump_statx()
181 mbits <<= 1; in dump_statx()
/OK3568_Linux_fs/kernel/drivers/spi/
H A Dspi-fsl-spi.c575 int mbits; in fsl_spi_grlib_probe() local
581 mbits = SPCAP_MAXWLEN(capabilities); in fsl_spi_grlib_probe()
582 if (mbits) in fsl_spi_grlib_probe()
583 mpc8xxx_spi->max_bits_per_word = mbits + 1; in fsl_spi_grlib_probe()
/OK3568_Linux_fs/kernel/drivers/regulator/
H A Dda9055-regulator.c361 #define DA9055_BUCK(_id, step, min, max, vbits, voffset, mbits, sbits) \ argument
380 .csel_mask = (mbits),\
395 .mask = (mbits),\
/OK3568_Linux_fs/kernel/drivers/iio/magnetometer/
H A Drm3100-spi.c33 /* Data rates cannot exceed 1Mbits. */ in rm3100_probe()
/OK3568_Linux_fs/kernel/drivers/infiniband/hw/hfi1/
H A Dqsfp.h96 /* byte 140 is nominal bit-rate, in units of 100Mbits/sec */
167 /* Byte 222 indicates nominal bitrate in units of 250Mbits/sec */
/OK3568_Linux_fs/prebuilts/gcc/linux-x86/aarch64/gcc-arm-10.3-2021.07-x86_64-aarch64-none-linux-gnu/aarch64-none-linux-gnu/libc/usr/include/linux/
H A Ddcbnl.h99 *@rpg_max_rate: the maxinun rate, in Mbits per second,
101 *@rpg_ai_rate: The rate, in Mbits per second,
103 *@rpg_hai_rate: The rate, in Mbits per second,
/OK3568_Linux_fs/kernel/include/uapi/linux/
H A Ddcbnl.h99 *@rpg_max_rate: the maxinun rate, in Mbits per second,
101 *@rpg_ai_rate: The rate, in Mbits per second,
103 *@rpg_hai_rate: The rate, in Mbits per second,
/OK3568_Linux_fs/prebuilts/gcc/linux-x86/arm/gcc-arm-10.3-2021.07-x86_64-arm-none-linux-gnueabihf/arm-none-linux-gnueabihf/libc/usr/include/linux/
H A Ddcbnl.h99 *@rpg_max_rate: the maxinun rate, in Mbits per second,
101 *@rpg_ai_rate: The rate, in Mbits per second,
103 *@rpg_hai_rate: The rate, in Mbits per second,
/OK3568_Linux_fs/kernel/drivers/gpu/drm/amd/pm/inc/
H A Dsmu11_driver_if_arcturus.h282 I2C_SPEED_FAST_PLUS_1M, //1 Mbits/s (in fast mode)
283 I2C_SPEED_HIGH_1M, //1 Mbits/s (in high speed mode)
284 I2C_SPEED_HIGH_2M, //2.3 Mbits/s
H A Dsmu11_driver_if_navi10.h286 I2C_SPEED_FAST_PLUS_1M, //1 Mbits/s (in fast mode)
287 I2C_SPEED_HIGH_1M, //1 Mbits/s (in high speed mode)
288 I2C_SPEED_HIGH_2M, //2.3 Mbits/s
H A Dsmu11_driver_if_sienna_cichlid.h340 I2C_SPEED_FAST_PLUS_1M, //1 Mbits/s (in fast mode)
341 I2C_SPEED_HIGH_1M, //1 Mbits/s (in high speed mode)
342 I2C_SPEED_HIGH_2M, //2.3 Mbits/s
/OK3568_Linux_fs/u-boot/board/keymile/km_arm/
H A Dkm_arm.c368 * first the fix for the 1000Mbits Autoneg, this is from
457 * LED0 (Speed): 0x7 (On 1000 MBits, Off Else) in reset_phy()
/OK3568_Linux_fs/kernel/samples/bpf/
H A Ddo_hbm_test.sh336 rates=`grep receiver iperf.$id | grep -o "[0-9.]* Mbits" | grep -o "^[0-9]*"`
357 …( iperf3 -c $host -p $port -i 0 -P 1 -f m -t $dur | grep receiver | grep -o "[0-9.]* Mbits" | grep…
/OK3568_Linux_fs/kernel/drivers/net/wireless/rockchip_wlan/rtl8822be/hal/
H A Dhal_mcc.c83 * target tx byte(bytes) = target tx tp(Mbits/sec) * 1024 * 1024 / 8 * (duration(ms) / 1024) in rtw_hal_config_mcc_role_setting()
84 * = target tx tp(Mbits/sec) * 128 * duration(ms) in rtw_hal_config_mcc_role_setting()
86 * target tx tp(Mbits/sec) * 1024 * 1024 / 8 ==> Mbits to bytes in rtw_hal_config_mcc_role_setting()
879 /* check other interface tx busy traffic or not under every 2 switch channel notify(Mbits/100ms) */ in rtw_hal_mcc_sw_ch_fw_notify_hdl()
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/net/
H A Dethernet-controller.yaml181 Link speed in Mbits/sec.
H A Dethernet-phy.yaml78 Maximum PHY supported speed in Mbits / seconds.
/OK3568_Linux_fs/kernel/tools/testing/selftests/net/forwarding/
H A Dsch_tbf_core.sh225 # Note: TBF uses 10^6 Mbits, not 2^20 ones.
/OK3568_Linux_fs/kernel/drivers/net/wireless/rockchip_wlan/rtl8723bs/hal/
H A Dhal_mcc.c342 * target tx byte(bytes) = target tx tp(Mbits/sec) * 1024 * 1024 / 8 * (duration(ms) / 1024) in rtw_hal_config_mcc_role_setting()
343 * = target tx tp(Mbits/sec) * 128 * duration(ms) in rtw_hal_config_mcc_role_setting()
345 * target tx tp(Mbits/sec) * 1024 * 1024 / 8 ==> Mbits to bytes in rtw_hal_config_mcc_role_setting()
1155 /* check other interface tx busy traffic or not under every 2 switch channel notify(Mbits/100ms) */ in rtw_hal_mcc_sw_ch_fw_notify_hdl()
/OK3568_Linux_fs/kernel/drivers/infiniband/hw/qib/
H A Dqib_qsfp.h70 /* byte 140 is nominal bit-rate, in units of 100Mbits/sec Not QLogic req'd */
/OK3568_Linux_fs/kernel/Documentation/driver-api/soundwire/
H A Dsummary.rst32 ~19.2..24.576Mbits/s don't however allow for 11*13*8 channels to be
/OK3568_Linux_fs/kernel/drivers/net/wireless/intel/iwlegacy/
H A D4965-rs.c148 * 1, 2, 5.5, 11, 6, 9, 12, 18, 24, 36, 48, 54, 60 MBits
2311 * active_siso_rate mask includes 9 MBits (bit 5), and CCK (bits 0-3), in il4965_rs_rate_init()
2312 * supp_rates[] does not; shift to convert format, force 9 MBits off. in il4965_rs_rate_init()
2551 lq_sta->active_legacy_rate = 0x0FFF; /* 1 - 54 MBits, includes CCK */ in il4965_rs_sta_dbgfs_scale_table_write()
2552 lq_sta->active_siso_rate = 0x1FD0; /* 6 - 60 MBits, no 9, no CCK */ in il4965_rs_sta_dbgfs_scale_table_write()
2553 lq_sta->active_mimo2_rate = 0x1FD0; /* 6 - 60 MBits, no 9, no CCK */ in il4965_rs_sta_dbgfs_scale_table_write()
/OK3568_Linux_fs/kernel/drivers/net/wireless/intel/iwlwifi/dvm/
H A Drs.c157 * 1, 2, 5.5, 11, 6, 9, 12, 18, 24, 36, 48, 54, 60 MBits
334 lq_sta->active_legacy_rate = 0x0FFF; /* 1 - 54 MBits, includes CCK */ in rs_program_fix_rate()
335 lq_sta->active_siso_rate = 0x1FD0; /* 6 - 60 MBits, no 9, no CCK */ in rs_program_fix_rate()
336 lq_sta->active_mimo2_rate = 0x1FD0; /* 6 - 60 MBits, no 9, no CCK */ in rs_program_fix_rate()
337 lq_sta->active_mimo3_rate = 0x1FD0; /* 6 - 60 MBits, no 9, no CCK */ in rs_program_fix_rate()
2812 * active_siso_rate mask includes 9 MBits (bit 5), and CCK (bits 0-3), in iwl_rs_rate_init()
2813 * supp_rates[] does not; shift to convert format, force 9 MBits off. in iwl_rs_rate_init()
/OK3568_Linux_fs/u-boot/include/
H A Dflash.h180 /* 32 Mbit, 4Mbits x 8, */
183 /* 64 Mbit, 8Mbits x 8, */

123