| /OK3568_Linux_fs/kernel/drivers/clk/ti/ |
| H A D | mux.c | 89 ti_clk_latch(&mux->reg, mux->latch); in ti_clk_mux_set_parent()
133 s8 latch, u8 clk_mux_flags, u32 *table) in _register_mux() argument
154 mux->latch = latch; in _register_mux()
182 s32 latch = -EINVAL; in of_mux_clk_setup() local
201 of_property_read_u32(node, "ti,latch-bit", &latch); in of_mux_clk_setup()
217 flags, ®, shift, mask, latch, clk_mux_flags, in of_mux_clk_setup()
241 mux->latch = -EINVAL; in ti_clk_build_component_mux()
|
| H A D | clk.c | 299 u32 latch; in ti_clk_latch() local
304 latch = 1 << shift; in ti_clk_latch()
306 ti_clk_ll_ops->clk_rmw(latch, latch, reg); in ti_clk_latch()
307 ti_clk_ll_ops->clk_rmw(0, latch, reg); in ti_clk_latch()
|
| H A D | divider.c | 269 ti_clk_latch(÷r->reg, divider->latch); in ti_clk_divider_set_rate()
498 div->latch = val; in ti_clk_divider_populate()
500 div->latch = -EINVAL; in ti_clk_divider_populate()
|
| H A D | clock.h | 24 s8 latch; member
40 s8 latch; member
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/gpio/ |
| H A D | gpio-eic-sprd.txt | 6 controller contains 4 sub-modules: EIC-debounce, EIC-latch, EIC-async and
19 The EIC-latch sub-module is used to latch some special power down signals
20 and generate interrupts, since the EIC-latch does not depend on the APB
33 "sprd,sc9860-eic-latch",
59 compatible = "sprd,sc9860-eic-latch";
|
| /OK3568_Linux_fs/kernel/drivers/pcmcia/ |
| H A D | tcic.c | 532 u_char latch, sstat; in tcic_interrupt() local
550 latch = sstat ^ socket_table[psock].last_sstat; in tcic_interrupt()
556 if (latch == 0) in tcic_interrupt()
558 events = (latch & TCIC_SSTAT_CD) ? SS_DETECT : 0; in tcic_interrupt()
559 events |= (latch & TCIC_SSTAT_WP) ? SS_WRPROT : 0; in tcic_interrupt()
561 events |= (latch & TCIC_SSTAT_LBAT1) ? SS_STSCHG : 0; in tcic_interrupt()
563 events |= (latch & TCIC_SSTAT_RDY) ? SS_READY : 0; in tcic_interrupt()
564 events |= (latch & TCIC_SSTAT_LBAT1) ? SS_BATDEAD : 0; in tcic_interrupt()
565 events |= (latch & TCIC_SSTAT_LBAT2) ? SS_BATWARN : 0; in tcic_interrupt()
|
| /OK3568_Linux_fs/kernel/drivers/clocksource/ |
| H A D | timer-ixp4xx.c | 59 u32 latch; member
149 val = tmr->latch & ~IXP4XX_OST_RELOAD_MASK; in ixp4xx_set_periodic()
192 tmr->latch = DIV_ROUND_CLOSEST(timer_freq, in ixp4xx_timer_register()
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/clock/ |
| H A D | armada3700-xtal-clock.txt | 4 reading the gpio latch register.
7 of the GPIO block where the gpio latch is located.
|
| /OK3568_Linux_fs/kernel/arch/x86/kernel/ |
| H A D | tsc.c | 388 static unsigned long pit_calibrate_tsc(u32 latch, unsigned long ms, int loopmin) in pit_calibrate_tsc() argument
417 outb(latch & 0xff, 0x42); in pit_calibrate_tsc()
418 outb(latch >> 8, 0x42); in pit_calibrate_tsc()
720 unsigned long flags, latch, ms; in pit_hpet_ptimer_calibrate_cpu() local
749 latch = CAL_LATCH; in pit_hpet_ptimer_calibrate_cpu()
764 tsc_pit_khz = pit_calibrate_tsc(latch, ms, loopmin); in pit_hpet_ptimer_calibrate_cpu()
810 latch = CAL2_LATCH; in pit_hpet_ptimer_calibrate_cpu()
|
| /OK3568_Linux_fs/kernel/kernel/time/ |
| H A D | clockevents.c | 32 static u64 cev_delta2ns(unsigned long latch, struct clock_event_device *evt, in cev_delta2ns() argument
35 u64 clc = (u64) latch << evt->shift; in cev_delta2ns()
46 if ((clc >> evt->shift) != (u64)latch) in cev_delta2ns()
85 u64 clockevent_delta2ns(unsigned long latch, struct clock_event_device *evt) in clockevent_delta2ns() argument
87 return cev_delta2ns(latch, evt, false); in clockevent_delta2ns()
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/mtd/ |
| H A D | fsl-upm-nand.txt | 6 - fsl,upm-addr-offset : UPM pattern offset for the address latch.
7 - fsl,upm-cmd-offset : UPM pattern offset for the command latch.
|
| H A D | cadence-quadspi.txt | 20 - cdns,rclk-en : Flag to indicate that QSPI return clock is used to latch
|
| H A D | atmel-nand.txt | 135 - atmel,nand-addr-offset : offset for the address latch.
136 - atmel,nand-cmd-offset : offset for the command latch.
|
| /OK3568_Linux_fs/kernel/arch/arm/boot/dts/ |
| H A D | dra76x.dtsi | 99 ti,latch-bit=<26>;
110 ti,latch-bit=<26>;
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/clock/ti/ |
| H A D | mux.txt | 51 - ti,latch-bit : latch the mux value to HW, only needed if the register
|
| H A D | divider.txt | 78 - ti,latch-bit : latch the divider value to HW, only needed if the register
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/mmc/ |
| H A D | mtk-sd.txt | 49 - mediatek,latch-ck: Some SoCs do not support enhance_rx, need set correct latch-ck to avoid data c…
|
| /OK3568_Linux_fs/kernel/Documentation/hwmon/ |
| H A D | adm9240.rst | 178 a 20 ms active low pulse to reset an external Chassis Intrusion latch.
180 Clear the CI latch by writing value 0 to the sysfs intrusion0_alarm file.
200 that alarm bits may be cleared on read, user-space may latch alarms and
|
| /OK3568_Linux_fs/kernel/Documentation/virt/kvm/devices/ |
| H A D | arm-vgic-v3.rst | 149 here is that of the latch which is set by ISPENDR and cleared by ICPENDR or
151 ISPENDR is the logical OR of the latch value and the input line level.
153 Raw access to the latch state is provided to userspace so that it can save
155 combination of the current input line level and the latch state, and cannot
|
| /OK3568_Linux_fs/kernel/include/linux/ |
| H A D | clockchips.h | 182 extern u64 clockevent_delta2ns(unsigned long latch, struct clock_event_device *evt);
|
| /OK3568_Linux_fs/kernel/drivers/md/ |
| H A D | dm.c | 156 int latch = READ_ONCE(swap_bios); in get_swap_bios() local
157 if (unlikely(latch <= 0)) in get_swap_bios()
158 latch = DEFAULT_SWAP_BIOS; in get_swap_bios()
159 return latch; in get_swap_bios()
1282 static noinline void __set_swap_bios_limit(struct mapped_device *md, int latch) in __set_swap_bios_limit() argument
1285 while (latch < md->swap_bios) { in __set_swap_bios_limit()
1290 while (latch > md->swap_bios) { in __set_swap_bios_limit()
1319 int latch = get_swap_bios(); in __map_bio() local
1320 if (unlikely(latch != md->swap_bios)) in __map_bio()
1321 __set_swap_bios_limit(md, latch); in __map_bio()
|
| /OK3568_Linux_fs/prebuilts/gcc/linux-x86/arm/gcc-arm-10.3-2021.07-x86_64-arm-none-linux-gnueabihf/lib/gcc/arm-none-linux-gnueabihf/10.3.1/plugin/include/ |
| H A D | sese.h | 162 && bb_in_sese_p (loop->latch, region)); in loop_in_sese_p()
|
| /OK3568_Linux_fs/kernel/drivers/input/sensors/accel/ |
| H A D | da223_core.h | 140 unsigned char latch; /* >0: latch time, 0: no latch */ member
|
| /OK3568_Linux_fs/prebuilts/gcc/linux-x86/aarch64/gcc-arm-10.3-2021.07-x86_64-aarch64-none-linux-gnu/lib/gcc/aarch64-none-linux-gnu/10.3.1/plugin/include/ |
| H A D | sese.h | 162 && bb_in_sese_p (loop->latch, region)); in loop_in_sese_p()
|
| /OK3568_Linux_fs/kernel/drivers/usb/phy/ |
| H A D | phy-isp1301-omap.c | 1080 u8 latch = isp1301_get_u8(isp, ISP1301_INTERRUPT_LATCH); in isp1301_clear_latch() local
1081 isp1301_clear_bits(isp, ISP1301_INTERRUPT_LATCH, latch); in isp1301_clear_latch()
1082 return latch; in isp1301_clear_latch()
|