| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/misc/ |
| H A D | atmel-ssc.txt | 1 * Atmel SSC driver.
7 - reg: Should contain SSC registers location and length
8 - interrupts: Should contain SSC interrupt
16 the memory interface and SSC DMA channel ID (for tx and rx).
22 - When SSC works in slave mode, according to the hardware design, the
28 - This property makes the SSC into an automatically registered DAI.
|
| /OK3568_Linux_fs/kernel/sound/soc/atmel/ |
| H A D | Kconfig | 7 the ATMEL SSC interface. You will also need
25 tristate "SoC PCM DAI support for AT91 SSC controller using PDC"
30 Say Y or M if you want to add support for Atmel SSC interface
34 tristate "SoC PCM DAI support for AT91 SSC controller using DMA"
39 Say Y or M if you want to add support for Atmel SSC interface
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/clock/ |
| H A D | ti,cdce925.txt | 32 - spread-spectrum: SSC mode as defined in the data sheet.
48 /* PLL options to get SSC 1% centered */
|
| /OK3568_Linux_fs/yocto/meta-openembedded/meta-oe/recipes-extended/sedutil/ |
| H A D | sedutil_git.bb | 2 to the Trusted Computing Group OPAL 2.0 SSC specification."
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/sound/ |
| H A D | atmel-at91sam9g20ek-wm8731-audio.txt | 7 - atmel,ssc-controller: The phandle of the SSC controller
|
| H A D | atmel-sam9x5-wm8731-audio.txt | 6 - atmel,ssc-controller: The phandle of the SSC controller
|
| H A D | atmel-wm8904.txt | 31 - atmel,ssc-controller: The phandle of the SSC controller
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/spi/ |
| H A D | spi-st-ssc.txt | 1 STMicroelectronics SSC (SPI) Controller
|
| H A D | spi-lantiq-ssc.txt | 1 Lantiq Synchronous Serial Controller (SSC) SPI master driver
|
| /OK3568_Linux_fs/kernel/sound/spi/ |
| H A D | Kconfig | 21 This driver requires the Atmel SSC driver for sound sink, a
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/i2c/ |
| H A D | i2c-st.txt | 1 ST SSC binding, for I2C mode operation
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/phy/ |
| H A D | brcm-sata-phy.txt | 28 - brcm,enable-ssc: use spread spectrum clocking (SSC) on this port
|
| /OK3568_Linux_fs/u-boot/arch/arm/dts/ |
| H A D | exynos5420-peach-pit.dts | 190 /* Enable SSC set by register */
193 * Set SSC enabled and +/-1% central
|
| H A D | exynos5250-spring.dts | 622 0x02 0xb1 0x20 /* Enable SSC set by register */
623 /* Set SSC enabled and +/-1% central spreading */
|
| H A D | stih407-family.dtsi | 501 /* SBC SSC */
|
| /OK3568_Linux_fs/u-boot/arch/arm/include/asm/arch-omap5/ |
| H A D | mux_dra7xx.h | 16 #define SSC (0 << 19) macro
|
| /OK3568_Linux_fs/kernel/drivers/misc/ |
| H A D | Kconfig | 185 tristate "Device driver for Atmel SSC peripheral"
189 Serial Communication peripheral (SSC).
191 The SSC peripheral supports a wide variety of serial frame based
|
| /OK3568_Linux_fs/kernel/arch/x86/include/asm/ |
| H A D | perf_event_p4.h | 613 P4_GEN_ESCR_EMASK(P4_EVENT_MEMORY_COMPLETE, SSC, 1),
|
| /OK3568_Linux_fs/kernel/drivers/spi/ |
| H A D | Kconfig | 532 tristate "Lantiq SSC SPI controller"
535 This driver supports the Lantiq SSC SPI controller in master
827 tristate "STMicroelectronics SPI SSC-based driver"
831 this option, support will be included for the SSC driven SPI.
|
| /OK3568_Linux_fs/kernel/arch/x86/events/intel/ |
| H A D | p4.c | 115 P4_ESCR_EMASK_BIT(P4_EVENT_MEMORY_COMPLETE, SSC),
|
| /OK3568_Linux_fs/kernel/arch/arm/boot/dts/ |
| H A D | stih407-family.dtsi | 526 /* SBC SSC */
|
| /OK3568_Linux_fs/kernel/drivers/i2c/busses/ |
| H A D | Kconfig | 1021 tristate "STMicroelectronics SSC I2C support"
1025 hardware SSC (Synchronous Serial Controller) as an I2C controller.
|
| /OK3568_Linux_fs/kernel/ |
| H A D | MAINTAINERS | 11618 MICROCHIP SSC DRIVER
|
| /OK3568_Linux_fs/device/rockchip/common/images/userdata/userdata_normal/media/ |
| H A D | yuv420_p352x288.yuv | 2428 …xxwuttuusrqnkfa]VTSQQQOIF?:3*++)./,*)())*,,++,-+,-,+,-../..-,,,,,,,-,,.-+*6SSC=61*''((%"" '% …
|