| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/mfd/ |
| H A D | twl6040.txt | 4 vibra and GPO functionality on OMAP4+ platforms.
13 - #gpio-cells = <1>: twl6040 provides GPO lines.
|
| /OK3568_Linux_fs/kernel/drivers/pinctrl/nuvoton/ |
| H A D | pinctrl-npcm7xx.c | 913 #define GPO 0x2 /* Not GPI */ macro
967 …7XX_PINCFG(42, bmcuart0a, MFSEL1, 9, none, NONE, 0, none, NONE, 0, DSTR(2, 4) | GPO),
973 NPCM7XX_PINCFG(48, uart2, MFSEL1, 11, bmcuart0b, MFSEL4, 1, none, NONE, 0, GPO),
976 NPCM7XX_PINCFG(51, uart2, MFSEL1, 11, none, NONE, 0, none, NONE, 0, GPO),
978 NPCM7XX_PINCFG(53, uart2, MFSEL1, 11, none, NONE, 0, none, NONE, 0, GPO),
986 NPCM7XX_PINCFG(61, uart1, MFSEL1, 10, none, NONE, 0, none, NONE, 0, GPO),
987 NPCM7XX_PINCFG(62, uart1, MFSEL1, 10, bmcuart1, MFSEL3, 24, none, NONE, 0, GPO),
988 NPCM7XX_PINCFG(63, uart1, MFSEL1, 10, bmcuart1, MFSEL3, 24, none, NONE, 0, GPO),
1113 …X_PINCFG(184, spi3, MFSEL4, 16, none, NONE, 0, none, NONE, 0, DSTR(8, 12) | SLEW | GPO),
1114 …X_PINCFG(185, spi3, MFSEL4, 16, none, NONE, 0, none, NONE, 0, DSTR(8, 12) | SLEW | GPO),
[all …]
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/gpio/ |
| H A D | gpio_lpc32xx.txt | 14 5: GPO P3
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/mux/ |
| H A D | adi,adgs1408.txt | 12 - First cell is the GPO line number, i.e. 0 to 3
|
| H A D | adi,adg792a.txt | 13 - First cell is the GPO line number, i.e. 0 or 1
|
| /OK3568_Linux_fs/kernel/drivers/gpio/ |
| H A D | Kconfig | 1016 tristate "PCA9570 4-Bit I2C GPO expander"
1018 Say yes here to enable the GPO driver for the NXP PCA9570 chip.
1049 tristate "TPIC2810 8-Bit I2C GPO expander"
1051 Say yes here to enable the GPO driver for the TI TPIC2810 chip.
1211 tristate "TI LP873X GPO"
1214 This driver supports the GPO on TI Lp873x PMICs. 2 GPOs are present
1313 tristate "TI TPS65086 GPO"
1316 This driver supports the GPO on TI TPS65086x PMICs.
1376 tristate "TWL6040 GPO"
1379 Say yes here to access the GPO signals of twl6040
|
| /OK3568_Linux_fs/kernel/drivers/net/wan/ |
| H A D | hd64572.h | 96 #define GPO 0x131 /* General Purpose Output Pin Ctl Reg */ macro
|
| /OK3568_Linux_fs/kernel/drivers/staging/rtl8192e/rtl8192e/ |
| H A D | r8192E_hw.h | 432 #define GPO 0x109 macro
|
| /OK3568_Linux_fs/u-boot/board/keymile/km_arm/ |
| H A D | kwbimage.cfg | 22 # bit 31-28: MPPSel7 0, GPO[7]
|
| H A D | kwbimage-memphis.cfg | 25 # bit 31-28: MPPSel7 0, GPO[7]
|
| H A D | kwbimage_128M16_1.cfg | 27 # bit 31-28: 0, MPPSel7 GPO[7]
|
| H A D | kwbimage_256M8_1.cfg | 29 # bit 31-28: 0, MPPSel7 GPO[7]
|
| /OK3568_Linux_fs/kernel/arch/arm/boot/dts/ |
| H A D | dove-cm-a510.dtsi | 100 /* Set upper NAND data bit to GPO */
|
| H A D | vf610-bk4.dts | 343 /* GPO */
|
| /OK3568_Linux_fs/kernel/Documentation/hwmon/ |
| H A D | ucd9000.rst | 54 (MARx), 16 for logical GPO, and 32 GPIs for cascading, and system function.
|
| /OK3568_Linux_fs/kernel/drivers/hid/ |
| H A D | Kconfig | 841 bool "GPO via leds class" if EXPERT
846 Provide access to PicoLCD's GPO pins via leds class.
|
| /OK3568_Linux_fs/kernel/drivers/mfd/ |
| H A D | Kconfig | 1653 General Purpose Outputs (GPO) that are used in portable devices.
1667 General Purpose Outputs (GPO) that are used in portable devices.
|