| /OK3568_Linux_fs/kernel/drivers/net/wireless/marvell/libertas/ |
| H A D | rx.c | 81 lbs_deb_hex(LBS_DEB_RX, "RX Data: Before chop rxpd", skb->data, in lbs_process_rxed_packet()
125 /* Chop off the rxpd + the excess memory from the 802.2/llc/snap header in lbs_process_rxed_packet()
134 /* Chop off the rxpd */ in lbs_process_rxed_packet()
138 /* Chop off the leading header bytes so the skb points to the start of in lbs_process_rxed_packet()
219 /* lbs_deb_hex(LBS_DEB_RX, "RX Data: Before chop rxpd", skb->data, min(skb->len, 100)); */ in process_rxed_802_11_packet()
243 /* chop the rxpd */ in process_rxed_802_11_packet()
|
| /OK3568_Linux_fs/kernel/drivers/staging/wlan-ng/ |
| H A D | p80211conv.c | 344 /* chop off the IV */ in skb_p80211_to_ether()
346 /* chop off the ICV. */ in skb_p80211_to_ether()
375 /* Chop off the 802.11 header. it's already sane. */ in skb_p80211_to_ether()
377 /* chop off the 802.11 CRC */ in skb_p80211_to_ether()
404 /* chop 802.11 header from skb. */ in skb_p80211_to_ether()
413 /* chop off the 802.11 CRC */ in skb_p80211_to_ether()
439 /* chop 802.11 header from skb. */ in skb_p80211_to_ether()
442 /* chop llc header from skb. */ in skb_p80211_to_ether()
445 /* chop snap header from skb. */ in skb_p80211_to_ether()
454 /* chop off the 802.11 CRC */ in skb_p80211_to_ether()
[all …]
|
| /OK3568_Linux_fs/kernel/sound/soc/codecs/ |
| H A D | rk730.c | 422 SOC_ENUM("DAC Ref Buf Chop Freq", dac_ref_buf_chop_freq_enum),
423 SOC_ENUM("MIC Chop Freq", mic_chop_freq_enum),
424 SOC_ENUM("ADC PGA Chop Freq", adc_pga_chop_freq_enum),
425 SOC_ENUM("Out Mux Chop Freq", mux_out_chop_freq_enum),
426 SOC_ENUM("Mixer Chop Freq", mix_chop_freq_enum),
427 SOC_ENUM("HP / Lineout Chop Freq", hp_lo_chop_freq_enum),
786 /* PF: Use the chop 400kHz for better ADC noise performance */ in rk730_reset()
|
| /OK3568_Linux_fs/kernel/drivers/rapidio/ |
| H A D | rio_cm.c | 1206 riocm_debug(CHOP, "(ch_%d)", ch_id); in riocm_ch_listen()
1234 riocm_debug(CHOP, "ch_%d to mport_%d", ch_id, mport_id); in riocm_ch_bind()
1351 riocm_debug(CHOP, "Failed to allocate channel %d (err=%ld)", in riocm_ch_create()
1368 riocm_debug(CHOP, "(ch_%d)", ch->id); in riocm_ch_free()
1441 riocm_debug(CHOP, "ch_%d by %s(%d)", in riocm_ch_close()
1457 riocm_debug(CHOP, "%s(%d) timed out waiting for ch %d", in riocm_ch_close()
1462 riocm_debug(CHOP, "%s(%d) wait for ch %d was interrupted", in riocm_ch_close()
1468 riocm_debug(CHOP, "ch_%d resources released", ch->id); in riocm_ch_close()
1471 riocm_debug(CHOP, "failed to release ch_%d resources", ch->id); in riocm_ch_close()
1665 riocm_debug(CHOP, "ch_%d requested by %s(%d)", in cm_chan_create()
[all …]
|
| /OK3568_Linux_fs/kernel/drivers/net/wireless/marvell/mwifiex/ |
| H A D | sta_rx.c | 129 /* Chop off the rxpd + the excess memory from the 802.2/llc/snap in mwifiex_process_rx_packet()
133 /* Chop off the rxpd */ in mwifiex_process_rx_packet()
138 /* Chop off the leading header bytes so the it points to the start of in mwifiex_process_rx_packet()
|
| H A D | uap_txrx.c | 145 /* Chop off the rxpd + the excess memory from in mwifiex_uap_queue_bridged_pkt()
150 /* Chop off the rxpd */ in mwifiex_uap_queue_bridged_pkt()
154 /* Chop off the leading header bytes so that it points in mwifiex_uap_queue_bridged_pkt()
|
| /OK3568_Linux_fs/kernel/tools/perf/trace/beauty/tracepoints/ |
| H A D | x86_msr.sh | 12 # Support all later, with some hash table, for now chop off
|
| /OK3568_Linux_fs/u-boot/include/ |
| H A D | fsl_ddr_sdram.h | 23 #define DDR_BC4 DDR_BL4 /* burst chop for ddr3 */
362 /* On-The-Fly Burst Chop enable */
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/iio/adc/ |
| H A D | adi,ad7192.yaml | 79 and when chop is disabled.
|
| /OK3568_Linux_fs/yocto/meta-openembedded/meta-oe/recipes-benchmark/lmbench/lmbench-3.0-a9/ |
| H A D | lmbench_result_html_report.patch | 56 chop;
|
| /OK3568_Linux_fs/kernel/drivers/net/wireless/rockchip_wlan/mvl88w8977/mlan/ |
| H A D | mlan_sta_rx.c | 378 /* Chop off the RxPD + the excess memory from the 802.2/llc/snap in wlan_process_rx_packet()
394 /* Chop off the RxPD */ in wlan_process_rx_packet()
398 /* Chop off the leading header bytes so the it points to the start of in wlan_process_rx_packet()
|
| /OK3568_Linux_fs/kernel/Documentation/target/ |
| H A D | tcmu-design.rst | 316 buf[ret-1] = '\0'; /* null-terminate and chop off the \n */
327 str_buf[ret-1] = '\0'; /* null-terminate and chop off the \n */
|
| /OK3568_Linux_fs/u-boot/board/Seagate/nas220/ |
| H A D | kwbimage.cfg | 112 # bit3 : 1 , MBUS Burst Chop disabled
|
| /OK3568_Linux_fs/u-boot/board/iomega/iconnect/ |
| H A D | kwbimage.cfg | 108 # bit3: 0x1, MBUS Burst Chop disabled
|
| /OK3568_Linux_fs/u-boot/board/Marvell/guruplug/ |
| H A D | kwbimage.cfg | 108 # bit3 : 1 , MBUS Burst Chop disabled
|
| /OK3568_Linux_fs/u-boot/board/LaCie/net2big_v2/ |
| H A D | kwbimage.cfg | 108 # bit3 : 1 , MBUS Burst Chop disabled
|
| /OK3568_Linux_fs/u-boot/board/Seagate/dockstar/ |
| H A D | kwbimage.cfg | 111 # bit3 : 1 , MBUS Burst Chop disabled
|
| /OK3568_Linux_fs/u-boot/board/Synology/ds109/ |
| H A D | kwbimage.cfg | 112 # bit3 : 1 , MBUS Burst Chop disabled
|
| /OK3568_Linux_fs/u-boot/board/Marvell/dreamplug/ |
| H A D | kwbimage.cfg | 109 # bit3 : 1 , MBUS Burst Chop disabled
|
| /OK3568_Linux_fs/u-boot/board/Seagate/goflexhome/ |
| H A D | kwbimage.cfg | 114 # bit3 : 1 , MBUS Burst Chop disabled
|
| /OK3568_Linux_fs/u-boot/board/Marvell/sheevaplug/ |
| H A D | kwbimage.cfg | 108 # bit3 : 1 , MBUS Burst Chop disabled
|
| /OK3568_Linux_fs/u-boot/board/LaCie/netspace_v2/ |
| H A D | kwbimage-ns2l.cfg | 108 # bit3 : 1 , MBUS Burst Chop disabled
|
| H A D | kwbimage-is2.cfg | 108 # bit3 : 1 , MBUS Burst Chop disabled
|
| H A D | kwbimage.cfg | 108 # bit3 : 1 , MBUS Burst Chop disabled
|
| /OK3568_Linux_fs/u-boot/board/cloudengines/pogo_e02/ |
| H A D | kwbimage.cfg | 112 # bit3 : 1 , MBUS Burst Chop disabled
|