| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/leds/ |
| H A D | leds-lm3532.txt | 31 Optional properties if ALS mode is used: 32 - ti,als-vmin - Minimum ALS voltage defined in Volts 33 - ti,als-vmax - Maximum ALS voltage defined in Volts 34 Per the data sheet the max ALS voltage is 2V and the min is 0V 42 average the two ALS inputs. This is only used if 45 - ti,als-input-mode - Determines how the device uses the attached ALS 56 if the LED strings are controlled by the ALS. 59 0x01 - LED strings are ALS controlled
|
| /OK3568_Linux_fs/kernel/drivers/iio/light/ |
| H A D | Kconfig | 77 tristate "Avago APDS9960 gesture/RGB/ALS/proximity sensor" 84 APDS9960 gesture/RGB/ALS/proximity sensor. 188 tristate "Sharp GP2AP002 Proximity/ALS sensor" 192 Say Y here if you have a Sharp GP2AP002 proximity/ALS combo-chip 199 tristate "Sharp GP2AP020A00F Proximity/ALS sensor" 206 Say Y here if you have a Sharp GP2AP020A00F proximity/ALS combo-chip 240 This driver supports the sysfs interface to get the ALS, IR intensity, 261 tristate "HID ALS" 283 tristate "JSA1212 ALS and proximity sensor driver" 288 proximity & ALS sensor device. [all …]
|
| H A D | tsl2772.c | 299 ALS, enumerator 307 [tsl2571] = ALS, 312 [tsl2572] = ALS, 1461 [ALS] = { 1491 TSL2772_DEVICE_INFO(ALS), 1516 [ALS] = { 1566 .info = &tsl2772_device_info[ALS],
|
| /OK3568_Linux_fs/kernel/Documentation/ABI/testing/ |
| H A D | sysfs-class-backlight-driver-lm3533 | 6 Get the ALS output channel used as input in 7 ALS-current-control mode (0, 1), where: 19 Enable ALS-current-control mode (0, 1).
|
| H A D | sysfs-class-led-driver-lm3533 | 6 Set the ALS output channel to use as input in 7 ALS-current-control mode (1, 2), where: 19 Enable ALS-current-control mode (0, 1).
|
| H A D | sysfs-bus-iio-light-lm3533-als | 60 These values correspond to the ALS-mapper target registers for 61 ALS-mapper Y + 1.
|
| /OK3568_Linux_fs/kernel/Documentation/misc-devices/ |
| H A D | bh1770glc.rst | 21 ALS and proximity parts operates on their own, but they shares common I2C 23 but ALS side results are used to estimate reliability of the proximity sensor. 25 ALS produces 16 bit lux values. The chip contains interrupt logic to produce 30 8 bit. Driver supports only one channel. Driver uses ALS results to estimate 31 reliability of the proximity results. Thus ALS is always running while
|
| H A D | apds990x.rst | 19 APDS990x is a combined ambient light and proximity sensor. ALS and proximity 20 functionality are highly connected. ALS measurement path must be running 23 ALS produces raw measurement values for two channels: Clear channel 34 ALS contains 4 different gain steps. Driver automatically
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/iio/light/ |
| H A D | us5182d.txt | 1 * UPISEMI us5182d I2C ALS and Proximity sensor 33 There will be no dark-gain compensation by default when ALS > thresh 34 (0 * dark-gain), and a 1.35 compensation factor when ALS < thresh.
|
| H A D | cm3605.txt | 7 This ALS and proximity sensor was one of the very first deployed in mobile 14 to activate the ALS, should be flagged GPIO_ACTIVE_LOW)
|
| H A D | apds9960.txt | 1 * Avago APDS9960 gesture/RGB/ALS/proximity sensor
|
| H A D | gp2ap020a00f.txt | 1 * Sharp GP2AP020A00F I2C Proximity/ALS sensor
|
| H A D | vl6180.txt | 1 STMicro VL6180 - ALS, range and proximity sensor
|
| /OK3568_Linux_fs/kernel/drivers/misc/ |
| H A D | Kconfig | 305 tristate "Medfield Avago APDS9802 ALS Sensor module" 308 If you say yes here you get support for the ALS APDS9802 ambient 345 tristate "BH1770GLC / SFH7770 combined ALS - Proximity sensor"
|
| /OK3568_Linux_fs/kernel/arch/arm/boot/dts/ |
| H A D | tegra20-ventana.dts | 349 /* ALS and proximity sensor */
|
| H A D | tegra30-cardhu.dtsi | 196 /* ALS and Proximity sensor */
|
| H A D | tegra20-seaboard.dts | 352 /* ALS and proximity sensor */
|
| H A D | qcom-apq8060-dragonboard.dts | 400 /* Connected to AOUT of ALS sensor */
|
| /OK3568_Linux_fs/u-boot/arch/arm/dts/ |
| H A D | tegra20-ventana.dts | 370 /* ALS and proximity sensor */
|
| H A D | tegra20-seaboard.dts | 394 /* ALS and proximity sensor */
|
| /OK3568_Linux_fs/kernel/drivers/leds/ |
| H A D | Kconfig | 196 LM3530 ambient light sensor chip. This ALS chip can be 207 LM3532 ambient light sensor chip. This ALS chip can be
|
| /OK3568_Linux_fs/yocto/poky/meta/files/common-licenses/ |
| H A D | CC-BY-ND-3.0-DE | 9 …DEN LIZENZBEDINGUNGEN RECHTSVERBINDLICH EINVERSTANDEN. SOWEIT DIESE LIZENZ ALS LIZENZVERTRAG ANZUS…
|
| H A D | CC-BY-NC-ND-3.0-DE | 9 …DEN LIZENZBEDINGUNGEN RECHTSVERBINDLICH EINVERSTANDEN. SOWEIT DIESE LIZENZ ALS LIZENZVERTRAG ANZUS…
|
| H A D | CC-BY-NC-3.0-DE | 9 …DEN LIZENZBEDINGUNGEN RECHTSVERBINDLICH EINVERSTANDEN. SOWEIT DIESE LIZENZ ALS LIZENZVERTRAG ANZUS…
|
| H A D | CC-BY-3.0-DE | 9 …DEN LIZENZBEDINGUNGEN RECHTSVERBINDLICH EINVERSTANDEN. SOWEIT DIESE LIZENZ ALS LIZENZVERTRAG ANZUS…
|