| /OK3568_Linux_fs/u-boot/drivers/usb/ulpi/ |
| H A D | ulpi.c | 39 err = ulpi_write(ulpi_vp, &ulpi->scratch, tval); in ulpi_integrity_check()
98 return ulpi_write(ulpi_vp, &ulpi->function_ctrl, val); in ulpi_select_transceiver()
109 return ulpi_write(ulpi_vp, reg, flags); in ulpi_set_vbus()
119 val = ulpi_write(ulpi_vp, reg, ULPI_OTG_EXTVBUSIND); in ulpi_set_vbus_indicator()
132 val = ulpi_write(ulpi_vp, &ulpi->iface_ctrl, val); in ulpi_set_vbus_indicator()
144 return ulpi_write(ulpi_vp, reg, val); in ulpi_set_pd()
171 return ulpi_write(ulpi_vp, &ulpi->function_ctrl, val); in ulpi_opmode_sel()
186 return ulpi_write(ulpi_vp, &ulpi->iface_ctrl_set, smode); in ulpi_serial_mode_enable()
193 err = ulpi_write(ulpi_vp, &ulpi->function_ctrl_clear, in ulpi_suspend()
237 err = ulpi_write(ulpi_vp, in ulpi_reset()
|
| H A D | omap-ulpi-viewport.c | 52 int ulpi_write(struct ulpi_viewport *ulpi_vp, u8 *reg, u32 value) in ulpi_write() function
|
| H A D | ulpi-viewport.c | 93 int ulpi_write(struct ulpi_viewport *ulpi_vp, u8 *reg, u32 value) in ulpi_write() function
|
| /OK3568_Linux_fs/u-boot/drivers/usb/host/ |
| H A D | ehci-zynq.c | 61 ulpi_write(&ulpi_vp, &ulpi->otg_ctrl, in ehci_zynq_probe()
64 ulpi_write(&ulpi_vp, &ulpi->function_ctrl, in ehci_zynq_probe()
67 ulpi_write(&ulpi_vp, &ulpi->iface_ctrl, 0); in ehci_zynq_probe()
70 ulpi_write(&ulpi_vp, &ulpi->otg_ctrl_set, in ehci_zynq_probe()
|
| H A D | ehci-msm.c | 48 ulpi_write(&priv->ulpi_vp, (u8 *)ULPI_MISC_A_SET, in setup_usb_phy()
55 ulpi_write(&priv->ulpi_vp, (u8 *)ULPI_MISC_A_CLEAR, in reset_usb_phy()
|
| /OK3568_Linux_fs/kernel/drivers/phy/ti/ |
| H A D | phy-tusb1210.c | 37 ulpi_write(tusb->ulpi, TUSB1210_VENDOR_SPECIFIC2, in tusb1210_power_on()
68 ulpi_write(tusb->ulpi, ULPI_OTG_CTRL, ret); in tusb1210_set_mode()
75 ulpi_write(tusb->ulpi, ULPI_OTG_CTRL, ret); in tusb1210_set_mode()
83 return ulpi_write(tusb->ulpi, ULPI_OTG_CTRL, ret); in tusb1210_set_mode()
134 ulpi_write(ulpi, TUSB1210_VENDOR_SPECIFIC2, reg); in tusb1210_probe()
|
| /OK3568_Linux_fs/kernel/drivers/phy/qualcomm/ |
| H A D | phy-qcom-usb-hs.c | 63 ret = ulpi_write(uphy->ulpi, ULPI_USB_INT_EN_RISE, val); in qcom_usb_hs_phy_set_mode()
66 ret = ulpi_write(uphy->ulpi, ULPI_USB_INT_EN_FALL, val); in qcom_usb_hs_phy_set_mode()
80 ret = ulpi_write(uphy->ulpi, ULPI_SET(ULPI_PWR_CLK_MNG_REG), in qcom_usb_hs_phy_set_mode()
84 ret = ulpi_write(uphy->ulpi, addr, ULPI_MISC_A_VBUSVLDEXTSEL); in qcom_usb_hs_phy_set_mode()
104 return ulpi_write(uphy->ulpi, addr, ULPI_MISC_A_VBUSVLDEXT); in qcom_usb_hs_phy_vbus_notifier()
144 ret = ulpi_write(ulpi, ULPI_EXT_VENDOR_SPECIFIC + seq->addr, in qcom_usb_hs_phy_power_on()
|
| H A D | phy-qcom-usb-hsic.c | 46 ret = ulpi_write(ulpi, ULPI_HSIC_IO_CAL, 0xff); in qcom_usb_hsic_phy_power_on()
51 ret = ulpi_write(ulpi, ULPI_HSIC_CFG, 0xa8); in qcom_usb_hsic_phy_power_on()
67 ret = ulpi_write(ulpi, ULPI_SET(ULPI_HSIC_CFG), 0x01); in qcom_usb_hsic_phy_power_on()
72 ret = ulpi_write(ulpi, ULPI_CLR(ULPI_IFC_CTRL), in qcom_usb_hsic_phy_power_on()
|
| /OK3568_Linux_fs/kernel/drivers/usb/common/ |
| H A D | ulpi.c | 28 int ulpi_write(struct ulpi *ulpi, u8 addr, u8 val) in ulpi_write() function
32 EXPORT_SYMBOL_GPL(ulpi_write);
209 ret = ulpi_write(ulpi, ULPI_SCRATCH, 0xaa); in ulpi_read_id()
|
| /OK3568_Linux_fs/kernel/include/linux/ulpi/ |
| H A D | driver.h | 63 int ulpi_write(struct ulpi *ulpi, u8 addr, u8 val);
|
| /OK3568_Linux_fs/u-boot/include/usb/ |
| H A D | ulpi.h | 131 int ulpi_write(struct ulpi_viewport *ulpi_vp, u8 *reg, u32 value);
|