| /OK3568_Linux_fs/u-boot/doc/uImage.FIT/ |
| H A D | update_uboot.its | 3 * Make sure the flashing addresses ('load' prop) is correct for your board!
|
| /OK3568_Linux_fs/kernel/drivers/net/ethernet/mellanox/mlxfw/ |
| H A D | Kconfig | 10 flashing common logic.
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/phy/ |
| H A D | phy-mapphone-mdm6600.txt | 9 normal mode versus USB flashing mode
|
| /OK3568_Linux_fs/buildroot/board/freescale/t1040_t2080/ |
| H A D | readme.txt | 48 3. If flashing is desired, a similar approach to the T1040 can be followed
|
| /OK3568_Linux_fs/buildroot/board/toradex/apalis-imx6/ |
| H A D | readme.txt | 40 http://developer.toradex.com/knowledge-base/flashing-linux-on-imx6-modules
|
| /OK3568_Linux_fs/buildroot/board/chromebook/elm/ |
| H A D | readme.txt | 55 The is no way to get rid of the white screen without re-flashing the bootloader.
|
| /OK3568_Linux_fs/kernel/drivers/net/ethernet/cavium/liquidio/ |
| H A D | liquidio_common.h | 697 u64 flashing:1; member
703 u64 flashing:1;
|
| /OK3568_Linux_fs/u-boot/board/sunxi/ |
| H A D | README.nand | 1 Allwinner NAND flashing
|
| /OK3568_Linux_fs/kernel/Documentation/admin-guide/ |
| H A D | svga.rst | 66 Enter mode number or ``scan``: <flashing-cursor-here>
78 <flashing-cursor-here> encourages you to enter the item number or mode ID
97 what happens then. The screen will be probably flashing wildly for some time and
|
| H A D | thunderbolt.rst | 240 functionality is flashing a new NVM image. When in this mode, reading
|
| /OK3568_Linux_fs/u-boot/cmd/fastboot/ |
| H A D | Kconfig | 26 downloading images, flashing and device control used on
|
| /OK3568_Linux_fs/u-boot/board/hisilicon/hikey/ |
| H A D | README | 102 flashing twice in the past to avoid an ATF error.
104 Note: To get USB host working, also disconnect the USB OTG cable used for flashing. Otherwise you
|
| /OK3568_Linux_fs/buildroot/board/lego/ev3/ |
| H A D | readme.txt | 78 memory (just flashing u-boot.bin is enough).
|
| /OK3568_Linux_fs/external/rknpu2/ |
| H A D | README.md | 75 - Support flashing cache for fd pointed to internal tensor memory which are allocated by users
|
| /OK3568_Linux_fs/buildroot/board/technexion/imx8mpico/ |
| H A D | readme.txt | 50 For flashing:
|
| /OK3568_Linux_fs/buildroot/board/technexion/imx8mmpico/ |
| H A D | readme.txt | 51 For flashing:
|
| /OK3568_Linux_fs/buildroot/board/beaglev/ |
| H A D | readme.txt | 100 (called "secondboot" and "ddrinit"). Re-flashing them is not necessary
|
| /OK3568_Linux_fs/u-boot/board/freescale/mx35pdk/ |
| H A D | README | 79 If something goes wrong flashing the bootloader, it is always possible to
|
| /OK3568_Linux_fs/u-boot/test/py/ |
| H A D | README.md | 207 This script should perform the entire flashing process synchronously; the
208 script should only exit once flashing is complete, and a board reset will
227 board-specific vendor flashing utility.
|
| /OK3568_Linux_fs/buildroot/board/chromebook/snow/ |
| H A D | readme.txt | 55 The is no way to get rid of the white screen without re-flashing the bootloader.
|
| /OK3568_Linux_fs/u-boot/doc/ |
| H A D | README.mpc85xxcds | 79 U-Boot commands for downloading an image via tftp and flashing
|
| H A D | README.nand | 70 NAND flash. This behaviour is required when flashing UBI images
|
| /OK3568_Linux_fs/u-boot/examples/standalone/ |
| H A D | README.smc91111_eeprom | 133 re-flashing U-Boot.
|
| /OK3568_Linux_fs/kernel/Documentation/networking/device_drivers/ethernet/mellanox/ |
| H A D | mlx5.rst | 105 - CONFIG_MLXFW: When chosen, mlx5 firmware flashing support will be enabled (via devlink and ethtoo…
|
| /OK3568_Linux_fs/kernel/Documentation/powerpc/ |
| H A D | cxl.rst | 417 Starts and controls flashing a new FPGA image. Partial
|