| /OK3568_Linux_fs/u-boot/doc/device-tree-bindings/gpio/ |
| H A D | nvidia,tegra186-gpio.txt | 17 varies between the different GPIO controllers.
36 The number of ports implemented by each GPIO controller varies. The number of
37 implemented GPIOs within each port varies. GPIO registers within a controller
50 number of interrupt signals generated by a controller varies as a rough function
90 order the HW manual describes them. The number of entries required varies
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/gpio/ |
| H A D | nvidia,tegra186-gpio.txt | 17 varies between the different GPIO controllers.
36 The number of ports implemented by each GPIO controller varies. The number of
37 implemented GPIOs within each port varies. GPIO registers within a controller
50 number of interrupt signals generated by a controller varies as a rough function
92 order the HW manual describes them. The number of entries required varies
|
| /OK3568_Linux_fs/u-boot/arch/arm/mach-omap2/ |
| H A D | abb.c | 33 * settling time of ldo in micro-seconds (varies per OMAP family), in abb_setup_timings()
34 * of clock cycles per SYS_CLK period (varies per OMAP family), in abb_setup_timings()
35 * the SYS_CLK frequency in MHz (varies per board) in abb_setup_timings()
|
| /OK3568_Linux_fs/kernel/Documentation/sound/soc/ |
| H A D | dai.rst | 30 usually varies depending on the sample rate and the master system clock
53 receive the audio data. Bit clock usually varies depending on sample rate
|
| /OK3568_Linux_fs/kernel/tools/perf/bench/ |
| H A D | futex.h | 20 * @val: typically expected value of uaddr, but varies by op
24 * @val3: varies by op
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/net/ |
| H A D | cavium-pip.txt | 41 Value range is 1-31, and mapping to the actual delay varies depending on HW.
44 Value range is 1-31, and mapping to the actual delay varies depending on HW.
|
| /OK3568_Linux_fs/kernel/Documentation/input/devices/ |
| H A D | iforce-protocol.rst | 63 LEN= Varies from device to device
80 LEN= Varies
218 Query command. Length varies according to the query type.
|
| /OK3568_Linux_fs/kernel/drivers/w1/slaves/ |
| H A D | w1_ds2438.c | 393 static BIN_ATTR_RO(temperature, 0/* real length varies */);
394 static BIN_ATTR_RO(vad, 0/* real length varies */);
395 static BIN_ATTR_RO(vdd, 0/* real length varies */);
|
| /OK3568_Linux_fs/u-boot/arch/arm/include/asm/arch-mx6/ |
| H A D | mx6-ddr.h | 365 /* Device Information: Varies per DDR3 part number and speed grade */
380 /* Device Information: Varies per LPDDR2 part number and speed grade */
395 /* System Information: Varies per board design, layout, and term choices */
|
| /OK3568_Linux_fs/kernel/drivers/opp/ |
| H A D | Kconfig | 9 of OPP varies over silicon within the same family of devices.
|
| /OK3568_Linux_fs/kernel/Documentation/ABI/testing/ |
| H A D | sysfs-class-leds-gt683r | 18 Breathing: LEDs brightness varies at human breathing rate
|
| /OK3568_Linux_fs/u-boot/arch/arm/include/asm/arch-tegra/ |
| H A D | xusb-padctl.h | 10 * The type of PHY varies between SoC generations. Typically there are XUSB,
|
| /OK3568_Linux_fs/kernel/security/ |
| H A D | Kconfig.hardening | 220 heap content exposures. The performance impact varies by
236 The performance impact varies by workload, but is more expensive
|
| /OK3568_Linux_fs/kernel/lib/pldmfw/ |
| H A D | pldmfw_private.h | 100 /* This is not a struct type because the size of each record varies */
131 /* This is not a struct type because the component size varies */
|
| /OK3568_Linux_fs/kernel/tools/testing/selftests/futex/include/ |
| H A D | futextest.h | 54 * @val: typically expected value of uaddr, but varies by op
58 * @val3: varies by op
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/input/ |
| H A D | atmel,maxtouch.txt | 27 Note: the numbering of the GPIOs and the bit they start at varies between
|
| /OK3568_Linux_fs/yocto/poky/meta/recipes-devtools/rpm/files/ |
| H A D | 0001-build-pack.c-do-not-insert-payloadflags-into-.rpm-me.patch | 7 (deterministic), and 56 is the amount of threads (varies from one
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/pinctrl/ |
| H A D | brcm,bcm4708-pinmux.txt | 8 A list of pins varies across chipsets so few bindings are available.
|
| /OK3568_Linux_fs/kernel/arch/x86/kernel/ |
| H A D | head_32.S | 389 pushl %fs /* pt_regs->fs (__fsh varies by model) */
390 pushl %es /* pt_regs->es (__esh varies by model) */
391 pushl %ds /* pt_regs->ds (__dsh varies by model) */
|
| /OK3568_Linux_fs/yocto/poky/meta/recipes-devtools/ruby/ruby/ |
| H A D | 0004-lib-mkmf.rb-sort-list-of-object-files-in-generated-M.patch | 7 When the list of object files varies between builds, they are linked
|
| /OK3568_Linux_fs/kernel/Documentation/userspace-api/media/dvb/ |
| H A D | fe-read-status.rst | 43 varies according with the architecture. This needs to be fixed in the
|
| /OK3568_Linux_fs/kernel/drivers/net/ethernet/3com/ |
| H A D | typhoon.h | 313 * parm1: use varies by command
314 * parm2: use varies by command
315 * parm3: use varies by command
|
| /OK3568_Linux_fs/kernel/arch/x86/include/asm/ |
| H A D | processor-flags.h | 15 * CR3's layout varies depending on several things.
|
| /OK3568_Linux_fs/u-boot/drivers/reset/ |
| H A D | tegra-car-reset.c | 18 /* PERIPH_ID_COUNT varies per SoC */ in tegra_car_reset_request()
|
| /OK3568_Linux_fs/kernel/Documentation/arm64/ |
| H A D | hugetlbpage.rst | 31 pte (last) level. The number of supported contiguous entries varies by page size
|