Home
last modified time | relevance | path

Searched refs:EEPROM (Results 1 – 25 of 168) sorted by relevance

1234567

/OK3568_Linux_fs/kernel/drivers/misc/eeprom/
H A DKconfig2 menu "EEPROM support"
48 tristate "Old I2C EEPROM reader (DEPRECATED)"
51 If you say yes here you get read-only access to the EEPROM data
65 If you say yes here you get read-only support for the user EEPROM of
66 the Maxim MAX6874/5 EEPROM-programmable, quad power-supply
76 tristate "EEPROM 93CX6 support"
78 This is a driver for the EEPROM chipsets 93c46 and 93c66.
84 tristate "Microwire EEPROM 93XX46 support"
90 Driver for the microwire EEPROM chipsets 93xx46x. The driver
92 erase the whole EEPROM.
[all …]
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/nvmem/
H A Dlpc1857-eeprom.txt1 * NXP LPC18xx EEPROM memory NVMEM driver
8 - reg: EEPROM registers.
9 - mem: EEPROM address space.
12 - eeprom: EEPROM operating clock.
14 the EEPROM in reset.
15 - interrupts: Should contain EEPROM interrupt.
H A Dzii,rave-sp-eeprom.txt1 Zodiac Inflight Innovations RAVE EEPROM Bindings
3 RAVE SP EEPROM device is a "MFD cell" device exposing physical EEPROM
15 - zii,eeprom-name: Unique EEPROM identifier describing its function in the
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/misc/
H A Didt_89hpesx.txt1 EEPROM / CSR SMBus-slave interface of IDT 89HPESx devices
22 Optionally there can be EEPROM-compatible subnode:
23 - compatible: There are five EEPROM devices supported: 24c32, 24c64, 24c128,
25 - reg: Custom address of EEPROM device (If not specified IDT 89HPESx
26 (optional) device will try to communicate with EEPROM sited by default
28 - read-only : Parameterless property disables writes to the EEPROM
H A Deeprom-93xx46.txt10 - read-only : parameter-less property which disables writes to the EEPROM
12 each access to the EEPROM (e.g. for SPI bus multiplexing)
/OK3568_Linux_fs/kernel/Documentation/misc-devices/
H A Dmax6875.rst21 The Maxim MAX6875 is an EEPROM-programmable power-supply sequencer/supervisor.
23 It also provides 512 bytes of user EEPROM.
25 At reset, the MAX6875 reads the configuration EEPROM into its configuration
45 eeprom - 512 bytes of user-defined EEPROM space.
93 The configuration EEPROM is at addresses 0x8000 - 0x8045.
95 The user EEPROM is at addresses 0x8100 - 0x82ff.
97 Use i2c_smbus_write_word_data() to write a byte to EEPROM.
112 Reading data from the EEPROM is a little more complicated.
H A Deeprom.rst7 * Any EEPROM chip in the designated address range
57 This is a simple EEPROM module meant to enable reading the first 256 bytes
58 of an EEPROM (on a SDRAM DIMM for example). However, it will access serial
74 Recent Sony Vaio laptops have an EEPROM at 0x57. We couldn't get the
105 should have some EEPROM directories in ``/sys/bus/i2c/devices/*`` of names such
107 contains the binary data from EEPROM.
/OK3568_Linux_fs/u-boot/examples/standalone/
H A DREADME.smc91111_eeprom137 LAN91C111 EEPROM <- Non-volatile
143 To set the EEPROM MAC address to 12:34:56:78:9A:BC
147 Writing EEPROM register 20 with 3412
150 Writing EEPROM register 21 with 7856
153 Writing EEPROM register 22 with bc9a
154 EEPROM contents copied to MAC
158 Current MAC Address in EEPROM 12:34:56:78:9a:bc
178 - D : Dump the LAN91C111 EEPROM contents
180 - C : Copies the MAC address from the EEPROM to the LAN91C111
181 - W : Write a register in the EEPROM or in the MAC
[all …]
/OK3568_Linux_fs/kernel/drivers/w1/slaves/
H A DKconfig70 tristate "112-byte EEPROM support (DS28E05)"
73 is a 112-byte user-programmable EEPROM is
78 tristate "256b EEPROM family support (DS2430)"
80 Say Y here if you want to use a 1-wire 256bit EEPROM
82 This EEPROM is organized as one page of 32 bytes for random
86 tristate "1kb EEPROM family support (DS2431)"
89 1kb EEPROM family device (DS2431)
92 tristate "4kb EEPROM family support (DS2433)"
95 4kb EEPROM family device (DS2433).
144 tristate "4096-Bit Addressable 1-Wire EEPROM with PIO (DS28E04-100)"
[all …]
/OK3568_Linux_fs/u-boot/doc/
H A DI2C_Edge_Conditions5 and the CPU was reset. This may result in EEPROM data corruption.
18 The EEPROM sees:
22 4) device address "EEPROM interprets this as offset"
23 5) Offset in device, "EEPROM interprets this as data to write"
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/rtc/
H A Disil,isl12026.txt1 ISL12026 I2C RTC/EEPROM
3 ISL12026 is an I2C RTC/EEPROM combination device. The RTC and control
4 registers respond at bus address 0x6f, and the EEPROM array responds
/OK3568_Linux_fs/u-boot/board/ti/common/
H A DKconfig5 Evaluation Boards which have I2C based EEPROM detection
8 int "Board EEPROM's I2C bus address"
13 hex "Board EEPROM's I2C chip address"
/OK3568_Linux_fs/u-boot/board/boundary/nitrogen6x/
H A D6x_upgrade.txt34 echo "Error re-reading EEPROM" ;
38 echo "Error reading boot loader from EEPROM" ;
41 echo "Error initializing EEPROM" ;
/OK3568_Linux_fs/kernel/Documentation/w1/slaves/
H A Dw1_ds28e04.rst7 * Maxim DS28E04-100 4096-Bit Addressable 1-Wire EEPROM with PIO
28 from the EEPROM of the DS28E04.
31 to the EEPROM of the DS28E04. If CRC checking mode is enabled only
/OK3568_Linux_fs/kernel/Documentation/ABI/testing/
H A Dsysfs-driver-w1_therm22 device data to its embedded EEPROM, either restore data
23 embedded in device EEPROM. Be aware that devices support
24 limited EEPROM writing cycles (typical 50k)
26 * 'save': save device RAM to EEPROM
27 * 'restore': restore EEPROM data in device RAM
54 power is lost. Trigger a 'save' to EEPROM command to keep
99 * '0' : save the 2 or 3 bytes to the device EEPROM
/OK3568_Linux_fs/kernel/Documentation/networking/device_drivers/ethernet/cirrus/
H A Dcs89x0.rst155 stored in an on-board EEPROM. You must use the DOS-based CS8900/20 Setup
156 Utility if you want to change the adapter's configuration in EEPROM.
159 configuration parameters on the command-line to override the EEPROM's settings
160 or for interface configuration when an EEPROM is not used. (CS8920-based
161 adapters must use an EEPROM.) See Section 3.0 LOADING THE DRIVER AS A MODULE.
221 provides a means to override the EEPROM's settings or for interface
222 configuration when an EEPROM is not used.
250 a) If an EEPROM is present, any specified command-line parameter
252 EEPROM.
271 e) The minimum command-line configuration required if an EEPROM is
[all …]
/OK3568_Linux_fs/u-boot/drivers/misc/
H A DKconfig166 integrated 64-byte EEPROM, four programmable non-volatile I/O pins
266 hex "Chip address of the EEPROM device"
270 int "I2C bus of the EEPROM device."
274 int "Size in bytes of the EEPROM device"
281 The EEPROM page size is 2^SYS_EEPROM_PAGE_WRITE_BITS.
289 int "Length in bytes of the EEPROM memory array address"
295 hex "EEPROM Address Overflow"
298 EEPROM chips that implement "address overflow" are ones
/OK3568_Linux_fs/kernel/Documentation/i2c/
H A Dslave-eeprom-backend.rst2 Linux I2C slave EEPROM backend
7 This backend simulates an EEPROM on the connected I2C bus. Its memory contents
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/net/
H A Dmicrochip,lan78xx.txt4 an external EEPROM, but some platforms (e.g. Raspberry Pi 3 B+) have neither.
5 The Device Tree properties, if present, override the OTP and EEPROM.
/OK3568_Linux_fs/u-boot/board/freescale/mpc8349itx/
H A DREADME11 A) One 8MB on-board flash EEPROM chip, instead of two.
29 E BOOT1 ON (0) Flash EEPROM boot device
31 G I2C-WP ON (0) I2C EEPROM write protection
32 H F_WP OFF (1) Flash EEPROM write protection
58 3.2 Flash EEPROM layout.
/OK3568_Linux_fs/kernel/Documentation/networking/device_drivers/ethernet/davicom/
H A Ddm9000.rst95 the availability of an external configuration EEPROM.
118 EEPROM, or that the EEPROM should be hidden from the user.
171 state information, the PHY state and the EEPROM.
/OK3568_Linux_fs/yocto/poky/meta/recipes-devtools/i2c-tools/
H A Di2c-tools_4.3.bb3 …ng tool, a chip dumper, register-level SMBus access helpers, EEPROM decoding scripts, EEPROM progr…
/OK3568_Linux_fs/kernel/Documentation/spi/
H A Dspi-sc18is602.rst33 to initiate longer transfers will fail with -EINVAL. EEPROM read operations and
37 sizes to access a device, can not be used directly to read data from EEPROM.
/OK3568_Linux_fs/kernel/drivers/ntb/hw/idt/
H A DKconfig11 initialization of EEPROM connected to master SMbus of the switch or
27 techniques like BIOS using SMBus interface or EEPROM should be
/OK3568_Linux_fs/kernel/Documentation/networking/
H A Dregulatory.rst90 check that can be used to ensure compliance based on custom EEPROM
96 internal EEPROM data. Devices drivers wishing to be capable of world
109 by having a mapping of your device's EEPROM country/regulatory
121 Then you can define a routine to map your read EEPROM value to an alpha2,
162 Your implementation may vary (read EEPROM cache instead, for example).

1234567