| /rk3399_rockchip-uboot/fs/yaffs2/ |
| H A D | yaffs_verify.c | 502 int difference; in yaffs_verify_free_chunks() local
509 difference = dev->n_free_chunks - counted; in yaffs_verify_free_chunks()
511 if (difference) { in yaffs_verify_free_chunks()
514 dev->n_free_chunks, counted, difference); in yaffs_verify_free_chunks()
|
| /rk3399_rockchip-uboot/board/congatec/conga-qeval20-qa3-e3845/ |
| H A D | README | 6 configurations (defconfig files). The only difference is the UART that
|
| /rk3399_rockchip-uboot/arch/arm/cpu/armv8/fsl-layerscape/doc/ |
| H A D | README.soc | 220 1)LS2048A, few difference w.r.t. LS2088A:
223 2)LS2084A, few difference w.r.t. LS2088A:
229 3)LS2044A, few difference w.r.t. LS2084A:
239 1)LS2041A, few difference w.r.t. LS2081A:
|
| H A D | README.qspi | 17 The difference between QSPI boot RCW image and NOR boot image is the PBI
|
| H A D | README.lsch3 | 156 The difference between NAND boot RCW image and NOR boot image is the PBI
201 Notice the difference from QDS is SRC, SRC_ADDR and the offset of u-boot image
|
| /rk3399_rockchip-uboot/doc/ |
| H A D | README.fsl_iim | 38 immediately, but this does not make any difference for a user reading
|
| H A D | README.ramboot-ppc85xx | 41 The main difference among all of them is the way the pre-environment is getting
73 The main difference between the above two methods from technical perspective is
|
| H A D | README.dfutftp | 100 (./doc/README.update) with one notable difference:
|
| H A D | README.generic-board | 127 just the difference between __bss_end and __bss_end__.
|
| H A D | README.mxsimage | 83 one difference. The CALL instruction does allow returning into the
|
| H A D | README.pxe | 209 The biggest difference between U-Boot's pxe and PXELINUX is that since
|
| H A D | README.trace | 308 2. Build U-Boot with tracing and run it. Note the difference in boot time
|
| H A D | README.nand | 169 the difference between a U-Boot driver and its Linux counterpart.
|
| /rk3399_rockchip-uboot/arch/arm/dts/ |
| H A D | armada-388.dtsi | 41 * The main difference with the Armada 385 is that the 388 can handle two more
|
| H A D | sun4i-a10-pcduino2.dts | 45 * LinkSprite pcDuino1 board. The only software visible difference
|
| /rk3399_rockchip-uboot/doc/uImage.FIT/ |
| H A D | command_syntax_extensions.txt | 106 Ad. 13. Similar to case 12, the difference being that <addr3> is the address
115 Ad. 15. Similar to case 14, the difference being that <addr3> is the address
|
| /rk3399_rockchip-uboot/drivers/mtd/ubi/ |
| H A D | Kconfig | 28 This parameter defines the maximum difference between the highest
|
| /rk3399_rockchip-uboot/board/sbc8349/ |
| H A D | README | 14 difference in the two is the level of PCI functionality.
|
| /rk3399_rockchip-uboot/board/freescale/mx6qarm2/ |
| H A D | imximage_mx6dl.cfg | 161 /* values of 20,40,50,60,7f tried. no difference seen */
|
| /rk3399_rockchip-uboot/board/freescale/t104xrdb/ |
| H A D | README | 26 Basic difference's among T1040RDB, T1042RDB_PI, T1042RDB
|
| /rk3399_rockchip-uboot/drivers/gpio/ |
| H A D | Kconfig | 85 GPIO feature set. The difference is large enough to merit a separate
|
| /rk3399_rockchip-uboot/arch/x86/ |
| H A D | Kconfig | 427 here does not make any difference.
|
| /rk3399_rockchip-uboot/Licenses/ |
| H A D | lgpl-2.1.txt | 110 modification follow. Pay close attention to the difference between a
|
| H A D | lgpl-2.0.txt | 94 modification follow. Pay close attention to the difference between a
|
| /rk3399_rockchip-uboot/common/ |
| H A D | dlmalloc.src | 1421 for the sake of speed. This makes no difference elsewhere.
|