README
1How to use U-Boot on Engicam Is.IoT MX6UL Starter Kit:
2-----------------------------------------------------
3
4- Configure U-Boot for Engicam Is.IoT MX6UL
5
6$ make mrproper
7$ make imx6ul_isiot_mmc_defconfig
8$ make
9
10This will generate the SPL image called SPL and the u-boot-dtb.img.
11
12- Flash the SPL image into the micro SD card:
13
14sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
15
16- Flash the u-boot-dtb.img image into the micro SD card:
17
18sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync
19
20- Jumper settings:
21
22MMC Boot: JM3 Closed
23
24- Connect the Serial cable between the Starter Kit and the PC for the console.
25(J28 is the Linux Serial console connector)
26
27- Insert the micro SD card in the board, power it up and U-Boot messages should
28come up.
29