Home
last modified time | relevance | path

Searched refs:switches (Results 1 – 25 of 27) sorted by relevance

12

/rk3399_rockchip-uboot/doc/
H A DREADME.mpc85xxcds97 Most switches on the carrier board should not be changed. The only
98 user-settable switches on the carrier board are used to configure
128 The default setting of all switches on the carrier board is:
141 Most switches on the CPU Card should not be changed. However, the
153 A safe default setting for all switches on the CPU board is:
165 And, just to be confusing, in this set of switches:
H A DREADME.mxs142 To boot a MXS based board from SD, set the boot mode DIP switches according to
191 To boot a MX28 based board from NAND, set the boot mode DIP switches according
287 Power off the board and set the boot mode DIP switches to boot from the SPI NOR
H A DREADME.davinci.nand_spl8 we need a command, which switches between this two read/write
H A DREADME.memory-test85 switches, network traffic (and thus DMA transfers from the network
H A DREADME.b4860qds78 RCW source is set by appropriate DIP-switches:
/rk3399_rockchip-uboot/board/freescale/mx28evk/
H A DREADME17 To boot MX28EVK from an SD card, set the boot mode DIP switches as:
26 To boot MX28EVK from SPI NOR flash, set the boot mode DIP switches as:
/rk3399_rockchip-uboot/board/freescale/mx35pdk/
H A DREADME14 switch the boot device with the switches SW1-SW2 on the Personality board,
76 The boot storage can be select using the switches on the personality board
102 To boot from NOR, you have to select the switches as follows:
/rk3399_rockchip-uboot/board/cadence/xtfpga/
H A DREADME80 Default MAC Address (DIP switches 1-6):
84 value whose least significant 6 bits come from DIP switches 1-6.
86 according to the DIP switches, where "on"==1 and "off"==0, and
93 used and the DIP switches no longer consulted. DIP swithes 1-6
/rk3399_rockchip-uboot/arch/arm/mach-sunxi/
H A Drmr_switch.S14 @ This code below switches to AArch64 and starts execution at the specified
/rk3399_rockchip-uboot/drivers/i2c/muxes/
H A DKconfig29 tristate "TI PCA954x I2C Mux/switches"
/rk3399_rockchip-uboot/board/freescale/mpc837xemds/
H A DREADME6 in terms of 0 and 1, and then map that to physical switches where
/rk3399_rockchip-uboot/cmd/
H A Dcros_ec.c145 printf("switches = %#x\n", info.switches); in do_cros_ec()
/rk3399_rockchip-uboot/board/freescale/mpc832xemds/
H A DREADME6 in terms of 0 and 1, and then map that to physical switches where
/rk3399_rockchip-uboot/board/freescale/ls2080ardb/
H A DREADME102 cfg_rcw_src switches needs to be changed for booting from different option.
/rk3399_rockchip-uboot/board/sbc8548/
H A DREADME238 any hardware settings (i.e. user configuration switches).
267 10_0000 1fff 4 user switches
/rk3399_rockchip-uboot/include/
H A Dec_commands.h1129 uint8_t switches; member
/rk3399_rockchip-uboot/drivers/power/regulator/
H A DKconfig185 effectively switches) which are supported by this driver as
/rk3399_rockchip-uboot/board/sunxi/
H A DREADME.sunxi64145 firmware parts, then switches the core into AArch64 mode.
/rk3399_rockchip-uboot/drivers/power/pmic/
H A DKconfig140 an RTC and two low Rds (resistance (drain to source)) switches. It is
/rk3399_rockchip-uboot/board/freescale/t102xrdb/
H A DREADME7 applications such as enterprise WLAN access points, routers, switches, firewall
/rk3399_rockchip-uboot/board/freescale/t102xqds/
H A DREADME7 applications such as enterprise WLAN access points, routers, switches, firewall
/rk3399_rockchip-uboot/lib/lzma/
H A Dlzma.txt167 Usage: LZMA <e|d> inputFile outputFile [<switches>...]
/rk3399_rockchip-uboot/arch/x86/
H A DKconfig41 runs through the 16-bit and 32-bit init, then switches to 64-bit
/rk3399_rockchip-uboot/scripts/kconfig/
H A Dzconf.lex.c_shipped309 /* Flag which is used to allow zconfwrap()'s to do buffer switches
/rk3399_rockchip-uboot/scripts/dtc/
H A Ddtc-lexer.lex.c_shipped280 /* Flag which is used to allow yywrap()'s to do buffer switches

12