| /rk3399_rockchip-uboot/arch/arm/dts/ |
| H A D | zynq-zc706.dts | 156 io-standard = <4>; 179 io-standard = <1>; 193 io-standard = <1>; 217 io-standard = <1>; 230 io-standard = <1>; 244 io-standard = <1>; 257 io-standard = <1>; 270 io-standard = <1>; 293 io-standard = <1>;
|
| H A D | zynq-zc702.dts | 210 io-standard = <1>; 233 io-standard = <4>; 256 io-standard = <1>; 274 io-standard = <1>; 298 io-standard = <1>; 311 io-standard = <1>; 325 io-standard = <1>; 338 io-standard = <1>; 351 io-standard = <1>; 374 io-standard = <1>;
|
| H A D | omap36xx.dtsi | 21 /* OMAP3630/OMAP37xx 'standard device' variants OPP50 to OPP130 */
|
| /rk3399_rockchip-uboot/drivers/tpm/ |
| H A D | Kconfig | 22 to the device using the standard TPM Interface Specification (TIS) 31 to the device using the standard TPM Interface Specification (TIS) 55 to the device using the standard TPM Interface Specification (TIS) 73 to the device using the standard TPM Interface Specification (TIS) 82 to the device using the standard TPM Interface Specification (TIS)
|
| /rk3399_rockchip-uboot/drivers/usb/cdns3/ |
| H A D | Kconfig | 29 standard XHCI driver. 50 standard XHCI driver.
|
| /rk3399_rockchip-uboot/drivers/ata/ |
| H A D | Kconfig | 6 types can use this, such as AHCI/SATA. It does not provide any standard 14 Attachment), a serial bus standard for connecting to hard drives and
|
| /rk3399_rockchip-uboot/drivers/usb/host/ |
| H A D | Kconfig | 13 The eXtensible Host Controller Interface (xHCI) is standard for USB 3.0 73 The Enhanced Host Controller Interface (EHCI) is standard for USB 2.0 179 The Open Host Controller Interface (OHCI) is a standard for accessing 216 The Universal Host Controller Interface is a standard by Intel for 219 standard, you may want to say Y, but see below. All recent boards 221 i810, i820) conform to this standard. Also all VIA PCI chipsets
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/exynos/ |
| H A D | soc.txt | 3 The "cpu-model" property is a non-standard extension for the device tree root
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/regulator/ |
| H A D | tps65090.txt | 10 standard binding for regulators; see regulator.txt. 25 Each regulator is defined using the standard binding for regulators.
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/net/ |
| H A D | ti,dp83867.txt | 12 Default child nodes are standard Ethernet PHY device
|
| H A D | ethernet.txt | 15 standard property;
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/usb/ |
| H A D | marvell.xhci-usb.txt | 10 - reg: should contain address and length of the standard XHCI
|
| /rk3399_rockchip-uboot/drivers/firmware/scmi/ |
| H A D | Kconfig | 8 protocol that defines standard interfaces for power, performance
|
| /rk3399_rockchip-uboot/board/toradex/apalis_imx6/ |
| H A D | Kconfig | 47 thus unusable on standard carrier boards.
|
| /rk3399_rockchip-uboot/board/armltd/integrator/ |
| H A D | README | 32 U-Boot has to carry out minimal configration before standard code is run. 57 Otherwise. for example, the standard CM reset via the CM control register would
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/pci/ |
| H A D | armada8k-pcie.txt | 11 - interrupt-map-mask and interrupt-map, standard PCI properties to
|
| /rk3399_rockchip-uboot/doc/ |
| H A D | README.NetConsole | 2 In U-Boot, we implemented the networked console via the standard 44 standard output. It will be built when compiling for a board which
|
| H A D | README.ti-secure | 66 image. The output binary images should be used in place of the standard 98 image. The output binary images should be used in place of the standard 125 The output binary images should be used in place of the standard 149 The output binary images should be used in place of the standard
|
| /rk3399_rockchip-uboot/board/freescale/ls1043ardb/ |
| H A D | README | 18 standard PCIe card
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/clock/ |
| H A D | rockchip,rk3288-cru.txt | 29 that they are defined using standard clock bindings with following
|
| H A D | rockchip,rk3188-cru.txt | 30 that they are defined using standard clock bindings with following
|
| /rk3399_rockchip-uboot/drivers/mtd/spi/ |
| H A D | Kconfig | 9 implemented by the SPI flash uclass. There is one standard 33 standard support for things like probing, read / write, and 88 tables as per JESD216 standard.
|
| /rk3399_rockchip-uboot/board/freescale/bsc9131rdb/ |
| H A D | README | 14 . A multi-standard baseband algorithm accelerator for Channel Decoding/Encoding, 32 . Antenna interface controller (AIC), supporting three industry standard
|
| /rk3399_rockchip-uboot/disk/ |
| H A D | Kconfig | 92 meant to allow less than the standard specifies for devices 96 If unsure, leave at 128 entries, which is the standard
|
| /rk3399_rockchip-uboot/doc/uImage.FIT/ |
| H A D | x86-fit-boot.txt | 55 outputs with the standard Makefile (as it is on ARM for example, at least at 70 'vmlinux'. This is a standard ELF file and you can look at it if you like: 247 2. It allows use of the standard U-Boot boot file format
|