Home
last modified time | relevance | path

Searched refs:ports (Results 1 – 25 of 152) sorted by relevance

1234567

/rk3399_rockchip-uboot/arch/arm/mach-aspeed/ast2500/
H A DKconfig10 It has 512M of RAM, 32M of SPI flash, two Ethernet ports,
11 4 Serial ports, 4 USB ports, VGA port, PCIe, SD card slot,
/rk3399_rockchip-uboot/arch/mips/mach-bmips/
H A DKconfig95 ethernet ports, 1 USB port, 1 UART, GPIO buttons and LEDs, and
106 ethernet ports, 1 USB port, 1 UART, GPIO buttons and LEDs, and a
117 ethernet ports, 1 USB port, 1 UART, GPIO buttons and LEDs,
128 ethernet ports, 3 USB ports, 1 UART, GPIO buttons and LEDs, and
139 ethernet ports, 1 UART, GPIO buttons and LEDs, and a BCM43225
150 ethernet ports, 1 UART, GPIO buttons and LEDs, and a BCM4312
161 ethernet ports, 2 USB ports, 1 UART, GPIO buttons and LEDs, and
/rk3399_rockchip-uboot/arch/arm/cpu/armv7/ls102xa/
H A DKconfig42 ports. If some ports are reserved but higher ports are used for
43 cores, count the reserved ports. This will allocate enough memory
/rk3399_rockchip-uboot/drivers/gpio/
H A Dtegra186_gpio.c28 const struct tegra186_gpio_port_data *ports; member
193 plat->name = ctlr_data->ports[port].name; in tegra186_gpio_bind()
194 plat->regs = &(regs[ctlr_data->ports[port].offset / 4]); in tegra186_gpio_bind()
248 .ports = tegra186_gpio_main_ports,
264 .ports = tegra186_gpio_aon_ports,
/rk3399_rockchip-uboot/arch/arm/mach-rockchip/rk3288/
H A DKconfig7 Jerry is a RK3288-based clamshell device with 2 USB 3.0 ports,
27 ports, micro HDMI, a 10.1-inch 1280x800 EDP display, micro-SD card,
37 EVB-RK3288 is a RK3288-based development board with 2 USB ports,
49 ports, MIPI, micro-SD card, WiFi and Gigabit Ethernet, It also
57 Fennec is a RK3288-based development board with 2 USB ports,
66 Firefly is a RK3288-based development board with 2 USB ports,
76 ports, HDMI, micro-SD card, 16 GB eMMC and Gigabit Ethernet. It
92 PopMetal is a RK3288-based development board with 3 USB host ports,
118 Vyasa is a RK3288-based development board with 2 USB ports,
136 Tinker is a RK3288-based development board with 2 USB ports, HDMI,
/rk3399_rockchip-uboot/doc/
H A DREADME.t1040-l2switch20 - 8 Gigabit switch ports (ports 0 to 7) are external and are connected to external PHYs
21 - 2 switch ports (ports 8 and 9) of 2.5 G are connected (fixed links)
22 to FMan ports (FM1@DTSEC1 and FM1@DTSEC2)
H A DREADME.N121344 - Synchronous/Asynchronous AHB bus: 0, 1 or 2 ports.
46 (HSMP): 0, 1 or 2 ports.
/rk3399_rockchip-uboot/board/advantech/
H A DKconfig19 4x USB ports
21 SATA ports
/rk3399_rockchip-uboot/board/freescale/ls1021aiot/
H A DREADME16 - Two on-board SGMII 10/100/1G ethernet ports
17 - One Gbit Etherent RGMII interface to 4-ports switch
18 with 4x 10/100/1000 RJ145 ports
/rk3399_rockchip-uboot/drivers/video/drm/
H A Drockchip_crtc.c263 ofnode ports, node; in rockchip_vop_bind() local
266 ports = dev_read_subnode(dev, "ports"); in rockchip_vop_bind()
267 if (!ofnode_valid(ports)) in rockchip_vop_bind()
270 ofnode_for_each_subnode(node, ports) { in rockchip_vop_bind()
/rk3399_rockchip-uboot/arch/arm/dts/
H A Darmada-385-turris-omnia.dts285 ports {
289 ports@0 {
294 ports@1 {
299 ports@2 {
304 ports@3 {
309 ports@4 {
314 ports@5 {
/rk3399_rockchip-uboot/board/freescale/ls1043aqds/
H A DREADME30 - Three high speed USB 3.0 ports
32 - The other two USB 3.0 ports configured as OTG with micro-AB connector
41 - Two 4-pin serial ports at up to 115.2 Kbit/s
/rk3399_rockchip-uboot/board/freescale/t4qds/
H A DREADME5 optimized to support the high-bandwidth DDR3 memory ports, as well as the
6 highly-configurable SerDes ports. The system is lead-free and RoHS-compliant.
47 Support two on-board RGMII 10/100/1G ethernet ports.
73 Supports two USB 2.0 ports with integrated PHYs
81 Four I2C ports
97 hwconfig, then both four XFI ports will use copper cable.
99 XFI ports will use copper cable, the other two XFI ports will use fiber
/rk3399_rockchip-uboot/doc/device-tree-bindings/gpio/
H A Dnvidia,tegra186-gpio.txt36 The number of ports implemented by each GPIO controller varies. The number of
43 describes the port-level mapping. In that file, the naming convention for ports
49 represents the aggregate status for all GPIOs within a set of ports. Thus, the
51 of the number of ports it implements. Note that the HW documentation refers to
52 both the overall controller HW module and the sets-of-ports as "controllers".
55 of ports. Each GPIO may be configured to feed into a specific one of the
56 interrupt signals generated by a set-of-ports. The intent is for each generated
89 The interrupt outputs from the HW block, one per set of ports, in the
/rk3399_rockchip-uboot/board/freescale/ls1046aqds/
H A DREADME30 - Three high speed USB 3.0 ports
32 - The other two USB 3.0 ports configured as OTG with micro-AB connector
41 - Two 4-pin serial ports at up to 115.2 Kbit/s
/rk3399_rockchip-uboot/arch/arm/mach-rockchip/rk3399/
H A DKconfig11 with full function and phisical connectors support like type-C ports,
12 usb2.0 host ports, LVDS, JTAG, MAC, SDcard, HDMI, USB-2-serial...
/rk3399_rockchip-uboot/board/freescale/t104xrdb/
H A DREADME112 - Two on-board RGMII 10/100/1G ethernet ports.
119 - Supports two USB 2.0 ports with integrated PHYs
120 - Two type A ports with 5V@1.5A per port.
126 - Two Serial ports
127 - Four I2C ports
144 - Two on-board RGMII 10/100/1G ethernet ports.
153 - Supports two USB 2.0 ports with integrated PHYs
154 - Two type A ports with 5V@1.5A per port.
160 - Two Serial ports
161 - Four I2C ports
/rk3399_rockchip-uboot/board/freescale/t208xqds/
H A DREADME24 - Two Serial RapidIO 2.0 controllers/ports running at up to 5 GHz
57 - Two 1Gbps RGMII on-board ports
71 - Two USB2.0 ports with internal PHY (one Type-A + one micro Type-AB)
75 - Two SATA 2.0 ports on-board
77 - Two Serial RapidIO 2.0 ports up to 5 GHz
83 - Dual 4-pins UART serial ports
103 hwconfig, then both four XFI ports will use copper cable.
105 XFI ports will use copper cable, the other two XFI ports will use fiber
/rk3399_rockchip-uboot/board/freescale/t208xrdb/
H A DREADME24 - Two Serial RapidIO 2.0 controllers/ports running at up to 5 GHz
59 - Two on-board 10M/100M/1G RGMII ethernet ports
60 - Two on-board 10Gbps XFI fiber ports
61 - Two on-board 10Gbps Base-T copper ports
75 - Supports two USB 2.0 ports with integrated PHYs
76 - Two type A ports with 5V@1.5A per port.
82 - Two Serial ports
83 - Four I2C ports
/rk3399_rockchip-uboot/drivers/pci/
H A DKconfig62 Tegra. Tegra20 has 2 root ports with a total of 4 lanes, Tegra30 has
63 3 root ports with a total of 6 lanes and Tegra124 has 2 root ports
/rk3399_rockchip-uboot/board/freescale/ls1012aqds/
H A DREADME7 a full complement of high-speed SerDes ports.
42 - Three SAI Tx/Rx ports terminated at 2x3 headers
/rk3399_rockchip-uboot/board/freescale/ls1021aqds/
H A DREADME58 - Eight FlexTimers four supporting PWM and four FlexCAN ports
86 - Three on-board RGMII 10/100/1G ethernet ports.
95 - Two Serial ports
96 - Three I2C ports
/rk3399_rockchip-uboot/arch/arm/mach-rockchip/rk3328/
H A DKconfig12 usb2.0 host ports, LVDS, JTAG, MAC, SDcard, HDMI, USB-2-serial...
/rk3399_rockchip-uboot/arch/arm/mach-rockchip/rk3128/
H A DKconfig12 usb2.0 host ports, LVDS, JTAG, MAC, SDcard, HDMI, USB-2-serial...
/rk3399_rockchip-uboot/board/freescale/t1040qds/
H A DREADME70 - Two on-board RGMII 10/100/1G ethernet ports.
80 - Supports two USB 2.0 ports with integrated PHYs
81 — Two type A ports with 5V@1.5A per port.
90 - Two Serial ports
92 - Four I2C ports

1234567