| /rk3399_rockchip-uboot/doc/ |
| H A D | README.sata | 3 There are two ways to operate the hard disk
5 * Read/write raw blocks from/to SATA hard disk
8 1.0 How to read the SATA hard disk's information?
17 1.1 How to raw write the kernel, file system, dtb to a SATA hard disk?
34 1.2 How to raw read the kernel, file system, dtb from a SATA hard disk?
|
| H A D | README.nvme | 47 To use an NVMe hard disk from U-Boot shell, a 'nvme scan' command needs to
48 be executed for all NVMe hard disks attached to the NVMe controller to be
51 To list all of the NVMe hard disks, try:
69 Of course, file system command can be used on the NVMe hard disk as well:
|
| H A D | README.rksfc | 17 To list all of the rksfc hard disks, try:
|
| H A D | README.rknand | 16 To list all of the rknand hard disks, try:
|
| H A D | README.N1213 | 1 N1213 is a configurable hard/soft core of NDS32's N12 CPU family.
|
| H A D | README.esbc_validate | 28 5. In case of hard failure, SoC is issued RESET REQUEST after
|
| H A D | README.i2c | 9 transaction it is hard to know the state of the bus.
|
| H A D | README.falcon | 94 rather than the hard-coded value.
96 mode rather than the hard-coded value.
|
| H A D | README.unaligned-memory-access.txt | 63 resulting in a subtle code bug that is hard to detect!
73 At first, the concepts above may seem a little hard to relate to actual
|
| H A D | README.generic-board | 100 #ifdefs to select fields for a particular SOC, so it is hard to
|
| H A D | README.chromium | 241 beforehand. It can be quite hard to figure out between these two code bases
|
| H A D | README.trace | 165 best time to stop tracing is right at the end. In practice it is hard
|
| /rk3399_rockchip-uboot/fs/jffs2/ |
| H A D | Kconfig | 7 hard links and compression.
|
| /rk3399_rockchip-uboot/drivers/ata/ |
| H A D | Kconfig | 14 Attachment), a serial bus standard for connecting to hard drives and
47 This option enables Ceva Sata controller hard IP available on Xilinx
|
| /rk3399_rockchip-uboot/drivers/scsi/ |
| H A D | Kconfig | 6 hard drives and optical drives. The SCSI standards define physical
|
| /rk3399_rockchip-uboot/arch/arm/include/asm/ |
| H A D | processor.h | 31 struct fp_hard_struct hard; member
|
| /rk3399_rockchip-uboot/net/ |
| H A D | Kconfig | 32 If unset, timeout and maximum are hard-defined as 1 second
|
| /rk3399_rockchip-uboot/drivers/block/ |
| H A D | Kconfig | 46 Enables support for IDE (Integrated Drive Electronics) hard drives.
|
| /rk3399_rockchip-uboot/arch/mips/cpu/ |
| H A D | start.S | 51 li a0, 0 # Use hard register context
|
| /rk3399_rockchip-uboot/board/freescale/p2041rdb/ |
| H A D | README | 93 cpld reset - hard reset to default bank
|
| /rk3399_rockchip-uboot/board/buffalo/lsxl/ |
| H A D | README | 9 are loaded from the hard disk.
|
| /rk3399_rockchip-uboot/examples/standalone/ |
| H A D | README.smc91111_eeprom | 84 The Load point is a hard coded address from the
|
| /rk3399_rockchip-uboot/board/sbc8548/ |
| H A D | README | 68 The default configuration uses hard coded memory configuration settings
|
| /rk3399_rockchip-uboot/lib/ |
| H A D | Kconfig | 49 like SPL versions with hard memory limits. This version
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/pinctrl/ |
| H A D | pinctrl-bindings.txt | 162 "function" properties can quickly escalate and become hard to write and
|