Home
last modified time | relevance | path

Searched refs:enough (Results 1 – 25 of 59) sorted by relevance

123

/rk3399_rockchip-uboot/drivers/mtd/ubi/
H A Dfastmap-wl.c123 int enough; in ubi_refill_pools() local
134 enough = 0; in ubi_refill_pools()
146 enough++; in ubi_refill_pools()
161 enough++; in ubi_refill_pools()
163 if (enough == 2) in ubi_refill_pools()
/rk3399_rockchip-uboot/doc/
H A DREADME.fdt-overlays76 overlay. Make sure you have enough space to grow the base tree without
91 4. Grow it enough so it can 'fit' all the applied overlays
H A DREADME.mpc74xx7 Currently the support for these CPUs is pretty minimal, but enough to
H A DREADME.displaying-bmps7 a 32 bit aligned address is enough to ensure proper alignment. This is not
H A DREADME.sched47 - There NOT enough safety checks as are probably in the other
H A DREADME.memory-test84 compile a Linux kernel on the system) - this will cause enough context
95 Note 2: Ironically enough, the "test_burst" did not catch any RAM
H A DREADME.generic-board87 with the generic approach, and enough boards run.
91 relatively small and simple, but different enough that it introduces a
H A DREADME.multi-dtb-fit34 for platforms that don't provide a HEAP big enough to contain the uncompressed
H A DREADME.dfutftp92 possible to set large enough default buffer (8 MiB @ BBB)
H A DREADME.android-fastboot-protocol114 will reply with "DATA%08x" if it has enough
H A DREADME.imx6108 to the board. For boards without SPL support, it is enough to
/rk3399_rockchip-uboot/arch/arm/cpu/armv7/ls102xa/
H A DKconfig43 cores, count the reserved ports. This will allocate enough memory
/rk3399_rockchip-uboot/board/lego/ev3/
H A DREADME30 If you are booting from the microSD card, it is enough to just write uboot.bin
/rk3399_rockchip-uboot/board/freescale/mx6sabreauto/
H A DREADME55 The SD card must have enough space for raw "args" and "kernel".
/rk3399_rockchip-uboot/arch/arm/lib/
H A Dmemset.S120 6: subs r2, r2, #4 @ 1 do we have enough
H A Ddiv64.S191 @ eq -> division by 1: obvious enough...
/rk3399_rockchip-uboot/board/freescale/mx6sabresd/
H A DREADME82 The SD card must have enough space for raw "args" and "kernel".
/rk3399_rockchip-uboot/arch/xtensa/cpu/
H A Du-boot.lds99 * boards (such as xtav60) the region is small enough that U-Boot will not
/rk3399_rockchip-uboot/dts/
H A DKconfig55 which is not enough to support device tree. Enable this option to
73 which is not enough to support device tree. Enable this option to
242 SPL_SYS_MALLOC_F_LEN is big enough to contain it.
/rk3399_rockchip-uboot/drivers/tpm/
H A DKconfig12 such as reading and writing TPM private data. This is enough to
/rk3399_rockchip-uboot/common/
H A Ddlmalloc.src352 versions are often enough faster than libc versions on many
635 enough so that your overall system performance would improve by
668 The default trim value is high enough to cause trimming only in
719 (If enough normal freed space already exists it is used instead.)
1243 order almost never requires enough traversal to warrant using
2007 /* If not enough space to do this, then user did something very wrong */
2057 enough. This is a form of (roving) first fit, used only in
2066 chunk big enough to fulfill the request, and splitting off
2071 4. If large enough, the chunk bordering the end of memory
2079 system supports mmap, and there are few enough currently
[all …]
/rk3399_rockchip-uboot/doc/device-tree-bindings/pinctrl/
H A Drockchip,pinctrl.txt35 It should be large enough to contain also separate pull registers.
/rk3399_rockchip-uboot/doc/uImage.FIT/
H A Doverlay-fdt-boot.txt8 platforms can support this easily enough by providing a DT blob upon boot
/rk3399_rockchip-uboot/arch/arm/dts/
H A Drk3288-phycore-rdk.dts203 * Default drive strength isn't enough to achieve even
H A Drk3288-miqi.dtsi346 * Default drive strength isn't enough to achieve even

123