Home
last modified time | relevance | path

Searched refs:IDE (Results 1 – 25 of 133) sorted by relevance

123456

/OK3568_Linux_fs/kernel/drivers/ide/
H A DKconfig3 # IDE ATA ATAPI Block device driver configuration
6 # Select HAVE_IDE if IDE is supported
10 menuconfig IDE config
16 If you say Y here, your kernel will be able to manage ATA/(E)IDE and
17 ATAPI units. The most common cases are IDE hard drives and ATAPI
32 if IDE
34 comment "Please see Documentation/ide/ide.rst for help/info on IDE drives"
60 The IDE driver (which you are currently configuring) supports
64 this config option enables the IDE driver's SATA support.
66 supports SATA controllers, and this (IDE) driver supports
[all …]
/OK3568_Linux_fs/kernel/Documentation/m68k/
H A Dbuddha-driver.rst2 Amiga Buddha and Catweasel IDE Driver
5 The Amiga Buddha and Catweasel IDE Driver (part of ide.c) was written by
10 Register map of the Buddha IDE controller and the
48 $800-$8ff IDE-Select 0 (Port 0, Register set 0)
50 $900-$9ff IDE-Select 1 (Port 0, Register set 1)
52 $a00-$aff IDE-Select 2 (Port 1, Register set 0)
54 $b00-$bff IDE-Select 3 (Port 1, Register set 1)
56 $c00-$cff IDE-Select 4 (Port 2, Register set 0,
59 $d00-$dff IDE-Select 5 (Port 3, Register set 1,
67 level of the IRQ-line of IDE port 0.
[all …]
/OK3568_Linux_fs/kernel/Documentation/ide/
H A Dide.rst2 Information regarding the Enhanced IDE drive
5 The hdparm utility can be used to control various IDE features on a
13 BUGGY IDE CHIPSETS CAN CORRUPT DATA!!
42 - 40-conductor IDE cables are capable of transferring data in DMA modes up to
54 This is the multiple IDE interface driver, as evolved from hd.c
57 It supports up to 9 IDE interfaces per default, on one or more IRQs (usually
71 This driver automatically probes for most IDE interfaces (including all PCI
77 The IDE driver automatically detects and handles this. However, this may
112 Note that when only one IDE device is attached to an interface, it should be
133 interface (/dev/hda) and an IDE cdrom drive on the secondary interface
[all …]
H A Dide-tape.rst2 IDE ATAPI streaming tape driver
17 ht0 major 37, minor 0 first IDE tape, rewind on close.
18 ht1 major 37, minor 1 second IDE tape, rewind on close.
20 nht0 major 37, minor 128 first IDE tape, no rewind on close.
21 nht1 major 37, minor 129 second IDE tape, no rewind on close.
40 Testing was done with a 2 GB CONNER CTMA 4000 IDE ATAPI Streaming Tape Drive.
62 same purpose - efficient use of the IDE bus, but is interrupt
H A DChangeLog.ide-tape.1995-200219 * 1. An IDE ATAPI TAPE shares the same interface
20 * and irq with an IDE ATAPI CDROM.
21 * 2. An IDE ATAPI TAPE shares the same interface
22 * and irq with a normal IDE disk.
25 * recommended to give the IDE TAPE its own interface
94 * typically results in better IDE bus efficiency and
117 * now sometimes be used with IDE tape drives as well.
H A Dindex.rst4 Integrated Drive Electronics (IDE)
/OK3568_Linux_fs/kernel/drivers/ata/
H A Data_piix.c109 IDE = -1, /* IDE */ enumerator
347 { P0, P1, IDE, IDE }, /* 100b */
348 { P1, P0, IDE, IDE }, /* 101b */
349 { IDE, IDE, P0, P1 }, /* 110b */
350 { IDE, IDE, P1, P0 }, /* 111b */
360 { IDE, IDE, P1, P3 }, /* 01b */
361 { P0, P2, IDE, IDE }, /* 10b */
377 { IDE, IDE, P1, P3 }, /* 01b */
378 { P0, P2, IDE, IDE }, /* 10b */
390 { P0, P2, IDE, IDE }, /* 10b (IDE mode) */
[all …]
H A DKconfig332 bool "ATA SFF support (for legacy IDE and PATA)"
338 SFF is the legacy IDE interface that has been around since
617 This option enables support for the integrated IDE controller on
683 IDE controller found on some older machines.
794 Enable support for the JMicron IDE controller, via the new
800 tristate "Apple PowerMac/PowerBook internal 'MacIO' IDE"
803 Most IDE capable PowerMacs have IDE busses driven by a variant
820 tristate "Freescale MPC52xx SoC internal IDE"
824 This option enables support for integrated IDE controller
853 NS87415 PCI-IDE controller.
[all …]
/OK3568_Linux_fs/kernel/drivers/zorro/
H A Dzorro.ids135 0800 Impact 3001 [IDE Interface]
152 0d00 Impact 3001 [IDE Interface]
190 0600 Tandem AT-2008/508 [IDE Interface]
217 0300 Advantage [IDE Interface]
238 0600 Tandem AT-2008/508 [IDE Interface]
311 0400 MasterCard MC702 [SCSI Host Adapter and IDE Interface]
314 0100 [IDE Interface]
342 0100 AT500 [IDE Interface]
348 2400 Viper Mk V/E-Matrix 530 [SCSI Host Adapter and IDE Interface]
365 0800 FastATA 1200 [IDE Interface]
[all …]
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/ata/
H A Dcortina,gemini-sata-bridge.txt20 ata0 slave interface brought out on IDE pads
23 ata1 slave interface brought out on IDE pads
27 on IDE pads
31 on IDE pads
34 - cortina,gemini-enable-ide-pins: enables the PATA to IDE connection.
/OK3568_Linux_fs/kernel/drivers/block/paride/
H A DKconfig9 comment "Parallel IDE high-level drivers"
13 tristate "Parallel port IDE disks"
16 This option enables the high-level driver for IDE-type disk devices
19 parallel port IDE driver, otherwise you should answer M to build
95 comment "Parallel IDE protocol modules"
102 This option enables support for the ATEN EH-100 parallel port IDE
116 parallel port Series 5 IDE protocol. (Most BACKPACK drives made
134 parallel port Series 6 IDE protocol. (Most BACKPACK drives made
152 This option enables support for the Commuter parallel port IDE
163 This option enables support for the EP-2000 parallel port IDE
[all …]
/OK3568_Linux_fs/u-boot/drivers/block/
H A DKconfig43 config IDE config
44 bool "Support IDE controllers"
46 Enables support for IDE (Integrated Drive Electronics) hard drives.
47 This allows access to raw blocks and filesystems on an IDE drive
49 performing various IDE operations.
/OK3568_Linux_fs/kernel/Documentation/cdrom/
H A Dide-cd.rst1 IDE-CD driver documentation
12 CDROM drives which attach to an IDE interface. Note that some CDROM vendors
19 (CyCDROM CR520ie) which attaches to the IDE port but is not ATAPI;
55 entitled "Floppy, IDE, and other block devices", say either `Y`
61 Include IDE/ATAPI CDROM support
63 Depending on what type of IDE interface you have, you may need to
72 3. The CDROM drive should be connected to the host on an IDE
82 on the primary IDE interface are called `hda` and `hdb`,
88 driver, you should make sure your IDE interface uses either the
90 the CDROM drive is the only device on the IDE interface, it should
[all …]
/OK3568_Linux_fs/u-boot/doc/device-tree-bindings/ata/
H A Dintel-sata.txt11 "combined" : Use combined IDE + legacy mode
12 "plain-ide" : Use plain IDE mode
/OK3568_Linux_fs/u-boot/arch/arm/mach-tegra/tegra20/
H A Dpinmux.c286 PIN(ATA, IDE, NAND, GMI, RSVD4),
287 PIN(ATB, IDE, NAND, GMI, SDIO4),
288 PIN(ATC, IDE, NAND, GMI, SDIO4),
289 PIN(ATD, IDE, NAND, GMI, SDIO4),
350 PIN(ATE, IDE, NAND, GMI, RSVD4),
354 PIN(GMB, IDE, NAND, GMI, GMI_INT),
/OK3568_Linux_fs/kernel/Documentation/admin-guide/blockdev/
H A Dparide.rst2 Linux and parallel port IDE devices
20 The adapter chip reproduces a small ISA or IDE bus in the external device
28 IDE type devices, which require no intermediate controller. If one
32 IDE cable. It is usually possible to exchange the CD-ROM device with
33 any other device using the IDE interface.
35 The document describes the support in Linux for parallel port IDE
38 parallel port IDE subsystem, including:
54 To support such a wide range of devices, PARIDE, the parallel port IDE
61 pd IDE disk
72 for each of the parallel port IDE adapter chips. Thanks to the interest
[all …]
/OK3568_Linux_fs/yocto/poky/meta/recipes-extended/hdparm/
H A Dhdparm_9.63.bb1 SUMMARY = "Utility for viewing/manipulating IDE disk drive/driver parameters"
4 and manipulating various IDE drive and driver parameters."
/OK3568_Linux_fs/kernel/Documentation/admin-guide/
H A Ddevices.txt115 3 block First MFM, RLL and IDE hard disk/CD-ROM interface
207 Partitions are handled in the same way as for IDE
519 Partitions are handled the same way as for IDE disks
526 22 block Second IDE hard disk/CD-ROM interface
638 Partitions are handled in the same way as for IDE
722 33 block Third IDE hard disk/CD-ROM interface
740 34 block Fourth IDE hard disk/CD-ROM interface
774 37 char IDE tape
775 0 = /dev/ht0 First IDE tape
776 1 = /dev/ht1 Second IDE tape
[all …]
/OK3568_Linux_fs/kernel/arch/sh/boards/mach-microdev/
H A Dirq.c58 # error Inconsistancy in defining the IRQ# for secondary IDE!
62 # error Inconsistancy in defining the IRQ# for primary IDE!
/OK3568_Linux_fs/kernel/Documentation/arm/samsung-s3c24xx/
H A Deb2410itx.rst46 IDE chapter
49 Both onboard IDE ports are supported, however there is no support for
/OK3568_Linux_fs/kernel/Documentation/userspace-api/ioctl/
H A Dhdio.rst10 the HD/IDE layer. These are by-and-large implemented (as of Linux 2.6)
21 HDIO_GET_MULTCOUNT get current IDE blockmode setting
30 HDIO_GET_IDENTITY get IDE identification info
46 HDIO_SET_MULTCOUNT change IDE blockmode
193 get current IDE blockmode setting
208 The value of the current IDE block mode setting. This
215 change IDE blockmode
225 New value for IDE block mode setting. This controls how many
278 get IDE identification info
458 bandwidth to other devices sharing the same IDE bus.
[all …]
/OK3568_Linux_fs/kernel/Documentation/arm/
H A Dixp4xx.rst112 Finally, there is an IDE port hanging off the expansion bus.
118 replaced with mini-PCI slots and a CF IDE interface hanging off
154 - Add support for Coyote IDE
156 - Add support for CF IDE on expansion bus
/OK3568_Linux_fs/buildroot/package/python3/
H A D0021-Add-an-option-to-disable-IDLE.patch6 IDLE is an IDE embedded into python, written using Tk, so it doesn't make
64 + AS_HELP_STRING([--disable-idle3], [disable idle3 IDE]),
/OK3568_Linux_fs/kernel/arch/m68k/atari/
H A Dconfig.c339 ATARIHW_SET(IDE); in config_atari()
636 ATARIHW_ANNOUNCE(IDE, "IDE Interface"); in atari_get_hardware_list()
935 if (ATARIHW_PRESENT(IDE)) { in atari_platform_init()
/OK3568_Linux_fs/yocto/poky/meta/recipes-core/meta/
H A Dmeta-ide-support.bb2 …kage for ensuring the build directory contains all appropriate toolchain packages for using an IDE"

123456