Home
last modified time | relevance | path

Searched refs:BT (Results 1 – 25 of 263) sorted by relevance

1234567891011

/OK3568_Linux_fs/buildroot/package/armbian-firmware/
H A DConfig.in12 bool "AP6212 WiFi/BT"
14 Firmware files for AP6212 WiFi/BT combo chip.
17 bool "AP6256 WiFi/BT"
19 Firmware files for AP6256 WiFi/BT combo chip.
22 bool "AP6255 WiFi/BT"
24 Firmware files for AP6255 WiFi/BT combo chip.
27 bool "Realtek 8822CS SDIO WiFi/BT"
/OK3568_Linux_fs/kernel/Documentation/scsi/
H A DBusLogic.rst57 BT-948/958/958D, will always be available from my Linux Home Page at URL
69 the BT-948 PCI Ultra SCSI Host Adapter, and then again for the BT-958 PCI Wide
198 The ISA compatible I/O port is disabled by default on the BT-948/958/958D.
225 FlashPoint LT (BT-930) Ultra SCSI-3
226 FlashPoint LT (BT-930R) Ultra SCSI-3 with RAIDPlus
227 FlashPoint LT (BT-920) Ultra SCSI-3 (BT-930 without BIOS)
228 FlashPoint DL (BT-932) Dual Channel Ultra SCSI-3
229 FlashPoint DL (BT-932R) Dual Channel Ultra SCSI-3 with RAIDPlus
230 FlashPoint LW (BT-950) Wide Ultra SCSI-3
231 FlashPoint LW (BT-950R) Wide Ultra SCSI-3 with RAIDPlus
[all …]
H A DFlashPoint.rst78 BusLogic FlashPoint LT/BT-948 Upgrade Program
82 BusLogic FlashPoint LW/BT-958 Upgrade Program
99 customers to make sure the BT-946C/956C MultiMaster cards would still be
101 the FlashPoint would be able to upgrade to the BT-946C. While this helped
135 to trade in their FlashPoint LT for the new BT-948 MultiMaster PCI Ultra
136 SCSI Host Adapter. The BT-948 is the Ultra SCSI successor to the BT-946C
137 and has all the best features of both the BT-946C and FlashPoint LT,
145 As of 14 June 1996, the original BusLogic FlashPoint LT to BT-948 upgrade
148 LW (BT-950) for a BT-958 MultiMaster PCI Ultra SCSI Host Adapter. The
151 I was a beta test site for the BT-948/958, and versions 1.2.1 and 1.3.1 of
[all …]
/OK3568_Linux_fs/yocto/meta-openembedded/meta-oe/recipes-connectivity/gammu/gammu/
H A Dgammurc82 ; Nokia protocol with serial device set in BT stack (WidComm, other) from
85 ; Nokia protocol with serial device set in BT stack (WidComm, other) from
90 ; Connection "bluerffbus", device type BT
93 ; Connection "bluerfphonet", device type BT
95 ; Connection "bluephonet", device type BT
98 ; inform about BT services correctly (6310, 6310i with firmware lower
100 ; Connection "bluerfat", device type BT
102 ; Connection "blueat", device type BT
105 ; BT services correctly (6310, 6310i with firmware lower than 5.50, 8910,...)
106 ; Connection "bluerfobex", device type BT
[all …]
/OK3568_Linux_fs/kernel/Documentation/userspace-api/media/v4l/
H A Dbiblio.rst70 ITU BT.470
74 :title: ITU-R Recommendation BT.470-6 "Conventional Television Systems"
80 ITU BT.601
84 :title: ITU-R Recommendation BT.601-5 "Studio Encoding Parameters of Digital Television for Sta…
90 ITU BT.653
94 :title: ITU-R Recommendation BT.653-3 "Teletext systems"
100 ITU BT.709
104 :title: ITU-R Recommendation BT.709-5 "Parameter values for the HDTV standards for production a…
110 ITU BT.1119
114 :title: ITU-R Recommendation BT.1119 "625-line television Wide Screen Signalling (WSS)"
[all …]
/OK3568_Linux_fs/kernel/net/bluetooth/
H A DKconfig6 menuconfig BT config
48 depends on BT
74 depends on BT
88 depends on BT
97 depends on BT
104 depends on BT && DEBUG_FS
112 depends on BT && DEBUG_KERNEL
139 depends on BT && !DYNAMIC_DEBUG
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/ipmi/
H A Daspeed,ast2400-ibt-bmc.txt1 * Aspeed BT (Block Transfer) IPMI interface
4 (BaseBoard Management Controllers) and the BT interface can be used to
16 - interrupts: interrupt generated by the BT interface. without an
/OK3568_Linux_fs/kernel/drivers/net/wireless/rsi/
H A DKconfig48 bool "Redpine Signals WLAN BT Coexistence support"
49 depends on BT && RSI_91X
50 depends on !(BT=m && RSI_91X=y)
53 This option enables the WLAN BT coex support in rsi drivers.
/OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/net/
H A Dnokia-bluetooth.txt16 - reset-gpios: GPIO specifier, used to reset the BT module (active low)
17 - bluetooth-wakeup-gpios: GPIO specifier, used to wakeup the BT module (active high)
29 /* controlled (enabled/disabled) directly by BT module */
H A Dti-bluetooth.txt9 * TI WiLink 7/8 (wl12xx/wl18xx) Shared Transport BT/FM/GPS devices
13 standard BT HCI protocol with additional channels for the other functions.
36 - enable-gpios : GPIO signal controlling enabling of BT. Active high.
/OK3568_Linux_fs/external/xserver/hw/xfree86/ramdac/
H A Dmeson.build7 'BT.c',
20 'BT.h',
H A DMakefile.am4 xf86CursorRD.c xf86HWCurs.c IBM.c BT.c TI.c
6 sdk_HEADERS = BT.h IBM.h TI.h xf86Cursor.h xf86RamDac.h
/OK3568_Linux_fs/kernel/arch/arm64/boot/dts/rockchip/
H A Dpx30-mini-evb-v11.dtsi28 BT,reset_gpio = <&gpio0 RK_PA1 GPIO_ACTIVE_HIGH>;
29 BT,wake_gpio = <&gpio2 RK_PB0 GPIO_ACTIVE_HIGH>;
H A Drk3528-evb3-lp4x-v10.dtsi62 BT,reset_gpio = <&gpio3 RK_PC2 GPIO_ACTIVE_HIGH>;
63 BT,wake_gpio = <&gpio3 RK_PB4 GPIO_ACTIVE_HIGH>;
64 BT,wake_host_irq = <&gpio3 RK_PC1 GPIO_ACTIVE_HIGH>;
H A Drk3528-evb1-ddr4-v10.dtsi30 BT,reset_gpio = <&gpio1 RK_PC1 GPIO_ACTIVE_HIGH>;
31 BT,wake_gpio = <&gpio1 RK_PB4 GPIO_ACTIVE_HIGH>;
32 BT,wake_host_irq = <&gpio1 RK_PC2 GPIO_ACTIVE_HIGH>;
H A Drk3528-evb2-ddr3-v10.dtsi61 BT,reset_gpio = <&gpio1 RK_PC1 GPIO_ACTIVE_HIGH>;
62 BT,wake_gpio = <&gpio1 RK_PB4 GPIO_ACTIVE_HIGH>;
63 BT,wake_host_irq = <&gpio1 RK_PC2 GPIO_ACTIVE_HIGH>;
H A Drk3399-excavator-sapphire.dtsi86 //BT,power_gpio = <&gpio3 19 GPIO_ACTIVE_HIGH>; /* GPIOx_xx */
87 BT,reset_gpio = <&gpio0 9 GPIO_ACTIVE_HIGH>; /* GPIO0_B1 */
88 BT,wake_gpio = <&gpio2 26 GPIO_ACTIVE_HIGH>; /* GPIO2_D2 */
89 BT,wake_host_irq = <&gpio0 4 GPIO_ACTIVE_HIGH>; /* GPIO0_A4 */
H A Drk3308bs-evb-v11.dtsi32 BT,power_gpio = <&gpio2 RK_PB7 GPIO_ACTIVE_HIGH>;
33 BT,wake_host_irq = <&gpio2 RK_PB0 GPIO_ACTIVE_HIGH>;
/OK3568_Linux_fs/kernel/arch/arm/boot/dts/
H A Drk3229-at-3nod.dts57 BT,reset_gpio = <&gpio2 29 GPIO_ACTIVE_HIGH>;
58 BT,wake_gpio = <&gpio3 27 GPIO_ACTIVE_HIGH>;
59 BT,wake_host_irq = <&gpio3 26 GPIO_ACTIVE_HIGH>;
H A Dbcm2837-rpi-3-a-plus.dts92 /* Used by BT module */
136 * WL_REG_ON and BT_REG_ON of the CYW43455 Wifi/BT module are driven
163 /* uart0 communicates with the BT module */
H A Drk3229-at-3nod-func.dts68 BT,reset_gpio = <&gpio2 29 GPIO_ACTIVE_HIGH>;
69 BT,wake_gpio = <&gpio3 27 GPIO_ACTIVE_HIGH>;
70 BT,wake_host_irq = <&gpio3 26 GPIO_ACTIVE_HIGH>;
/OK3568_Linux_fs/kernel/drivers/misc/ti-st/
H A DKconfig4 # drivers (BT, FM and GPS)
14 BT / FM and GPS combo chips. This enables protocol drivers
/OK3568_Linux_fs/device/rockchip/common/configs/
H A DConfig.in.post-rootfs244 comment "wifi/BT depends on linux kernel"
250 string "wifi/BT chip"
254 Set "" for no WIFI/BT.
257 string "BT serial port"
/OK3568_Linux_fs/kernel/arch/nios2/include/asm/
H A Dasm-macros.h78 .macro BT reg1, reg2, bit
98 BT \reg1, \reg2, \bit
110 BT \reg1, \reg2, \bit
/OK3568_Linux_fs/kernel/Documentation/sound/soc/
H A Ddpcm.rst38 PCM3 <------------> * * <----DAI3-----> BT
69 PCM3 <------------> * * <----DAI3-----> BT
86 PCM3 <------------> * * <----DAI3-----> BT
139 PCM3 <------------> * * <----DAI3-----> BT
204 like a BT phone call :-
214 PCM3 <------------> * * <====DAI3=====> BT
221 This allows the host CPU to sleep while the DSP, MODEM DAI and the BT DAI are
322 PCM3 <------------> * * <----DAI3-----> BT

1234567891011