| /OK3568_Linux_fs/kernel/net/rfkill/ |
| H A D | rfkill-wlan.c | 290 reset = &mrfkill->pdata->reset_n; in rockchip_wifi_power()
627 data->reset_n.io = gpio; in wlan_platdata_parse_dt()
628 data->reset_n.enable = in wlan_platdata_parse_dt()
633 data->reset_n.io = -1; in wlan_platdata_parse_dt()
861 ret = rfkill_rk_setup_gpio(&pdata->reset_n, wlan_name, in rfkill_wlan_probe()
918 if (gpio_is_valid(rfkill->pdata->reset_n.io))
919 gpio_free(rfkill->pdata->reset_n.io);
|
| /OK3568_Linux_fs/kernel/tools/virtio/ |
| H A D | virtio_test.c | 170 bool delayed, int batch, int reset_n, int bufs) in run_test() argument
173 long started = 0, completed = 0, next_reset = reset_n; in run_test()
182 if (!reset_n) { in run_test()
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/net/ |
| H A D | micrel-ks8851.txt | 18 - reset-gpios: reset_n input pin
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/i2c/ |
| H A D | i2c-pca-platform.txt | 15 - reset-gpios : gpio specifier for gpio connected to RESET_N pin. As the line
|
| /OK3568_Linux_fs/kernel/include/linux/platform_data/ |
| H A D | nfcmrvl.h | 25 /* GPIO that is wired to RESET_N signal */
|
| /OK3568_Linux_fs/kernel/include/linux/ |
| H A D | rfkill-wlan.h | 37 struct rksdmmc_gpio reset_n; //SYSRET_B, DAIRST member
|
| /OK3568_Linux_fs/kernel/arch/mips/include/asm/octeon/ |
| H A D | cvmx-lmcx-defs.h | 1378 uint64_t reset_n:1; member
1382 uint64_t reset_n:1;
2123 uint64_t reset_n:1; member
2143 uint64_t reset_n:1;
2155 uint64_t reset_n:1; member
2175 uint64_t reset_n:1;
2185 uint64_t reset_n:1; member
2205 uint64_t reset_n:1;
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/pinctrl/ |
| H A D | qcom,ipq6018-pinctrl.yaml | 95 qdss_tracedata_a, qdss_tracedata_b, reset_n, sd_card, sd_write,
|
| H A D | qcom,msm8916-pinctrl.txt | 126 qdss_tracedata_b, reset_n, sd_card, sd_write, sec_mi2s, smb_int,
|
| /OK3568_Linux_fs/kernel/drivers/nfc/nfcmrvl/ |
| H A D | uart.c | 235 MODULE_PARM_DESC(reset_n_io, "GPIO that is wired to RESET_N signal.");
|
| H A D | main.c | 132 nfc_err(dev, "failed to request reset_n io\n"); in nfcmrvl_nci_register_dev()
|
| /OK3568_Linux_fs/kernel/drivers/usb/misc/ |
| H A D | usb251xb.c | 277 usleep_range(1, 10); /* >=1us RESET_N asserted */ in usb251xb_reset()
281 usleep_range(500, 750); /* >=500us after RESET_N deasserted */ in usb251xb_reset()
|
| /OK3568_Linux_fs/kernel/drivers/net/ethernet/micrel/ |
| H A D | ks8851.h | 360 * @gpio: Optional reset_n gpio
|
| /OK3568_Linux_fs/kernel/drivers/pinctrl/qcom/ |
| H A D | pinctrl-msm8916.c | 798 FUNCTION(reset_n),
|
| /OK3568_Linux_fs/kernel/drivers/infiniband/hw/hfi1/ |
| H A D | chip.c | 14140 * ASIC_QSFPn_OUT otherwise. This leaves RESET_N low and in init_chip()
14142 * to RESET_N. in init_chip()
|