Searched +full:fll3 +full:- +full:clk (Results 1 – 3 of 3) sorted by relevance
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/pinctrl/ |
| H A D | cirrus,madera.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - patches@opensource.cirrus.com
30 Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
33 pinctrl-0:
38 pinctrl-names:
43 pin-settings:
50 '-pins$':
53 - $ref: "pincfg-node.yaml#"
[all …]
|
| /OK3568_Linux_fs/kernel/drivers/pinctrl/cirrus/ |
| H A D | pinctrl-madera-core.c | 1 // SPDX-License-Identifier: GPL-2.0-only
5 * Copyright (C) 2016-2018 Cirrus Logic
17 #include <linux/pinctrl/pinconf-generic.h>
22 #include "../pinctrl-utils.h"
24 #include "pinctrl-madera.h"
28 * NOTE: IDs are zero-indexed for coding convenience
74 * All single-pin functions can be mapped to any GPIO, however pinmux applies
78 * Since these do not correspond to anything in the actual hardware - they are
79 * merely an adaptation to pinctrl's view of the world - we use the same name
91 /* set of pin numbers for single-pin groups, zero-indexed */
[all …]
|
| /OK3568_Linux_fs/kernel/sound/soc/codecs/ |
| H A D | nau8825.h | 1 /* SPDX-License-Identifier: GPL-2.0-only */
93 /* 16-bit control register address, and 16-bits control register data */
126 /* FLL3 (0x06) */
157 /* 0 - open, 1 - short to GND */
168 #define NAU8825_JACK_POLARITY (1 << 1) /* 0 - active low, 1 - active high */
224 #define NAU8825_JKDET_PULL_UP (1 << 11) /* 0 - pull down, 1 - pull up */
225 #define NAU8825_JKDET_PULL_EN (1 << 9) /* 0 - enable pull, 1 - disable */
226 #define NAU8825_JKDET_OUTPUT_EN (1 << 8) /* 0 - enable input, 1 - enable output */
249 #define NAU8825_I2S_TRISTATE (1 << 15) /* 0 - normal mode, 1 - Hi-Z output */
451 struct clk *mclk;
[all …]
|