Merge git://git.denx.de/u-boot-uniphier

- Add workaround code to make LD20 SoC boot from ARM Trusted Firmware
- Sync DT with Linux to fix DTC warnings
- Add new SoC support code
- Misc fix, updates

ARM: uniphier: add more init code for PXs3

Add the boot device table and reset deassertion for eMMC.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

Merge branch 'master' of git://git.denx.de/u-boot

Signed-off-by: Stefano Babic <sbabic@denx.de>

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

ARM: uniphier: setup EHCI PHY paramters for LD11

Set the same PHY parameters as the Boot ROM uses.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

- Allow to disable SPL (mainly for ATF)
- Refactor SoC init code
- Update DRAM settings
- Add PXs3 SoC support (DT, pinctrl driver,

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

- Allow to disable SPL (mainly for ATF)
- Refactor SoC init code
- Update DRAM settings
- Add PXs3 SoC support (DT, pinctrl driver, SoC code)

show more ...

ARM: uniphier: simplify SoC ID get function

Currently, uniphier_get_soc_type() converts the SoC ID (this is
read from the revision register) to an enum symbol to use it for SoC
identification. Come

ARM: uniphier: simplify SoC ID get function

Currently, uniphier_get_soc_type() converts the SoC ID (this is
read from the revision register) to an enum symbol to use it for SoC
identification. Come to think of it, there is no need for the
conversion in the first place. Using the SoC ID from the register
as-is a straightforward way.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot

Signed-off-by: Stefano Babic <sbabic@denx.de>

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

ARM: uniphier: add PH1-LD11 SoC support

This is a low-cost ARMv8 SoC from Socionext Inc.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

Merge branch 'master' of git://www.denx.de/git/u-boot-uniphier

ARM: uniphier: add PH1-LD20 SoC support

This is the first ARMv8 SoC from Socionext Inc.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

ARM: uniphier: add sg_set_iectrl_range()

For PH1-LD20 or later, per-pin input-enable control is supported,
that is, we need to set-up IECTRL registers for a group of pins.
This helper function will

ARM: uniphier: add sg_set_iectrl_range()

For PH1-LD20 or later, per-pin input-enable control is supported,
that is, we need to set-up IECTRL registers for a group of pins.
This helper function will be useful for a bunch of register settings.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

show more ...

ARM: uniphier: add sg_set_iectrl() function

This helper function would be useful for new SoCs with per-pin
input enable controlling, such as PH1-LD20, PH1-LD11, etc.

Signed-off-by: Masahiro Yamada

ARM: uniphier: add sg_set_iectrl() function

This helper function would be useful for new SoCs with per-pin
input enable controlling, such as PH1-LD20, PH1-LD11, etc.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

ARM: uniphier: fix warnings reported by aarch64 compiler

The UniPhier SoC family has not supported ARMv8 yet, but these would
cause warnings if they were compiled with a 64bit compiler. Before
addi

ARM: uniphier: fix warnings reported by aarch64 compiler

The UniPhier SoC family has not supported ARMv8 yet, but these would
cause warnings if they were compiled with a 64bit compiler. Before
adding the ARMv8 support really, fix them now.

Because UniPhier SoCs do not support Large Physical Address Extension,
casting "phys_addr_t" into "unsigned long" would carry the address
as is.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

show more ...

ARM: uniphier: move headers out of include/mach directory

These headers are only included locally in arch/arm/mach-uniphier/.
There is no reason to export them by putting in the mach/ directory.

Si

ARM: uniphier: move headers out of include/mach directory

These headers are only included locally in arch/arm/mach-uniphier/.
There is no reason to export them by putting in the mach/ directory.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

show more ...