Kconfig: USB: Migrate CONFIG_USB_EHCI to CONFIG_USB_EHCI_HCD

In order to be able to migrate the various SoC EHCI CONFIG options we
first need to finish the switch from CONFIG_USB_EHCI to
CONFIG_USB_

Kconfig: USB: Migrate CONFIG_USB_EHCI to CONFIG_USB_EHCI_HCD

In order to be able to migrate the various SoC EHCI CONFIG options we
first need to finish the switch from CONFIG_USB_EHCI to
CONFIG_USB_EHCI_HCD.

Cc: Marek Vasut <marex@denx.de>
Signed-off-by: Tom Rini <trini@konsulko.com>
Reviewed-by: Marek Vasut <marex@denx.de>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot

Signed-off-by: Stefano Babic <sbabic@denx.de>

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

ARM: uniphier: setup EHCI PHY paramters for LD11

Set the same PHY parameters as the Boot ROM uses.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

- Fix regressions caused by the previous reworks
- Add pin configuration support
- Re-work SPL code
- Update DRAM and PLL setup cod

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

- Fix regressions caused by the previous reworks
- Add pin configuration support
- Re-work SPL code
- Update DRAM and PLL setup code
- Enable needed configs, disable unneeded configs

show more ...

ARM: uniphier: deassert RST_n of eMMC device for LD11/LD20

For LD11 and LD20 SoCs, the RST_n pin is asserted by default. If
the EXT_CSD[162], bit[1:0] (RST_n_ENABLE) is fused, the eMMC device
would

ARM: uniphier: deassert RST_n of eMMC device for LD11/LD20

For LD11 and LD20 SoCs, the RST_n pin is asserted by default. If
the EXT_CSD[162], bit[1:0] (RST_n_ENABLE) is fused, the eMMC device
would stay in the reset state until its RST_n pin is deasserted by
software.

Currently, this is cared by an ad-hoc way because the eMMC hardware
reset provider is not supported in U-Boot for now. This code should
be re-written once the "mmc-pwrseq-emmc" binding is supported.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

show more ...

ARM: uniphier: rework spl_boot_device() and related code

The current implementation has ugly switch statements here and there,
and duplicates similar code. Rework it using table lookups for SoC
dat

ARM: uniphier: rework spl_boot_device() and related code

The current implementation has ugly switch statements here and there,
and duplicates similar code. Rework it using table lookups for SoC
data and reduce code duplication.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

ARM: uniphier: do not run harmful code for USB boot mode of LD11 ES3

The USB boot without the stand-by MPU is available on ES3 or later
of LD11 SoC, but the code in this if-conditional block must no

ARM: uniphier: do not run harmful code for USB boot mode of LD11 ES3

The USB boot without the stand-by MPU is available on ES3 or later
of LD11 SoC, but the code in this if-conditional block must not be
run when booting from USB. Check if the boot device is USB, and
skip the code in the case.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

show more ...

ARM: uniphier: enable clocks to MIO/STDMAC on LD11 if USB is enabled

At the moment, the clk driver is not clever enough to automatically
enable parent clocks like Linux. Enable the STDMAC clock exp

ARM: uniphier: enable clocks to MIO/STDMAC on LD11 if USB is enabled

At the moment, the clk driver is not clever enough to automatically
enable parent clocks like Linux. Enable the STDMAC clock explicitly
if USB is enabled.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot

Signed-off-by: Stefano Babic <sbabic@denx.de>

Merge branch 'master' of git://git.denx.de/u-boot-uniphier

ARM: uniphier: add PH1-LD11 SoC support

This is a low-cost ARMv8 SoC from Socionext Inc.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>