Merge changes from topic "imx8ulp_support" into integration

* changes:
docs(maintainers): add the maintainers for imx8ulp
docs(imx8ulp): add imx8ulp platform
fix(imx8ulp): increase the mmap re

Merge changes from topic "imx8ulp_support" into integration

* changes:
docs(maintainers): add the maintainers for imx8ulp
docs(imx8ulp): add imx8ulp platform
fix(imx8ulp): increase the mmap region num
feat(imx8ulp): adjust the dram mapped region
feat(imx8ulp): ddrc switch auto low power and software interface
feat(imx8ulp): add some delay before cmc1 access
feat(imx8ulp): add a flag check for the ddr status
fix(imx8ulp): add sw workaround for csi/hotplug test hang
feat(imx8ulp): adjust the voltage when sys dvfs enabled
feat(imx8ulp): enable the DDR frequency scaling support
fix(imx8ulp): fix suspend/resume issue when DBD owner is s400 only
feat(imx8ulp): update XRDC for ELE to access DDR with CA35 DID
feat(imx8ulp): add memory region policy
feat(imx8ulp): protect TEE region for secure access only
feat(imx8ulp): add trusty support
feat(imx8ulp): add OPTEE support
feat(imx8ulp): update the upower config for power optimization
feat(imx8ulp): allow RTD to reset APD through MU
feat(imx8ulp): not power off LPAV PD when LPAV owner is RTD
feat(imx8ulp): add system power off support
feat(imx8ulp): add APD power down mode(PD) support in system suspend
feat(imx8ulp): add the basic support for idle & system suspned
feat(imx8ulp): enable 512KB cache after resume on imx8ulp
feat(imx8ulp): add the initial XRDC support
feat(imx8ulp): allocated caam did for the non secure world
feat(imx8ulp): add i.MX8ULP basic support
build(changelog): add new scopes for nxp imx8ulp platform
feat(scmi): add scmi sensor support

show more ...

fix(imx8ulp): add sw workaround for csi/hotplug test hang

When doing CSI stress test after cpu hotplug, sometimes, system
will hang in CSI test. After some debug, we find that if slow
down the APD N

fix(imx8ulp): add sw workaround for csi/hotplug test hang

When doing CSI stress test after cpu hotplug, sometimes, system
will hang in CSI test. After some debug, we find that if slow
down the APD NIC frequency before power on the offline CPU,
the issue is gone. For now, just add such SW workaround.

Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Reviewed-by: Ye Li <ye.li@nxp.com>
Change-Id: I39a49efc382fbebf46e1ff15c93d506bd5f6bec1

show more ...

feat(imx8ulp): add trusty support

Support trusty on imx8ulp.

Signed-off-by: Ji Luo <ji.luo@nxp.com>
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Change-Id: I7ada2557023e271a721d50bfe7fd20b5f01cb128

feat(imx8ulp): add APD power down mode(PD) support in system suspend

The APD can be put into PD mode when linux suspend(mem). This patch
add the support for it. As the whole AP domain's context will

feat(imx8ulp): add APD power down mode(PD) support in system suspend

The APD can be put into PD mode when linux suspend(mem). This patch
add the support for it. As the whole AP domain's context will be lost,
so we must save the necessary HW module states before entering PD mode,
and we need to restore those contexts when system wake up. Fot details
about which HW module's state will be lost, please refer to the RM.

When APD enter PD mode, only the wakeup event connected to the WUU
can wakeup APD successfully. The upower wakeup source is used to
wakeup APD by RTD due to the factor that the MU between A core & M
core is not connected into WUU to generate wakeup event.

as the SRAM0 will be power down when APD enters PD mode, so we
need to re-init the scmi channels(resides in the SRAM0). otherwise
the SCMI can NOT work anymore.

Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Reviewed-by: Ye Li <ye.li@nxp.com>
Change-Id: I44b0cdc8397e5d6a82081ea6746542e9fa4b9fc1

show more ...

feat(imx8ulp): add the initial XRDC support

Add the initial xRDC support on i.MX8ULP.

Signed-off-by: Ye Li <ye.li@nxp.com>
Signed-off-by: Peng Fan <peng.fan@nxp.com>
Signed-off-by: Jacky Bai <ping.

feat(imx8ulp): add the initial XRDC support

Add the initial xRDC support on i.MX8ULP.

Signed-off-by: Ye Li <ye.li@nxp.com>
Signed-off-by: Peng Fan <peng.fan@nxp.com>
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Change-Id: I93ea8e2cebb049e6f20e71cfe50c7583a3228f38

show more ...

feat(imx8ulp): allocated caam did for the non secure world

JR1, JR2 and JR3 are available for use by the non secure
world. Setup the A35 core DID for these job rings.

Signed-off-by: Varun Sethi <v.

feat(imx8ulp): allocated caam did for the non secure world

JR1, JR2 and JR3 are available for use by the non secure
world. Setup the A35 core DID for these job rings.

Signed-off-by: Varun Sethi <v.sethi@nxp.com>
Signed-off-by: Pankaj Gupta <pankaj.gupta@nxp.com>
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Change-Id: If64d4ce11ebff49a2405d8b561b344fcd7b2614f

show more ...

feat(imx8ulp): add i.MX8ULP basic support

Add the basic support for i.MX8ULP.

The i.MX 8ULP family of processors features NXP’s advanced
implementation of the dual Arm Cortex-A35 cores alongside
an

feat(imx8ulp): add i.MX8ULP basic support

Add the basic support for i.MX8ULP.

The i.MX 8ULP family of processors features NXP’s advanced
implementation of the dual Arm Cortex-A35 cores alongside
an Arm Cortex-M33. This combined architecture enables the
device to run a rich operating system (such as Linux) on
the Cortex-A35 core and an RTOS (such as FreeRTOS) on the
Cortex-M33 core. It also includes a Cadence Tensilica Fusion
DSP for low-power audio and a HiFi4 DSP for advanced audio
and machine learning applications.

Signed-off-by: Peng Fan <peng.fan@nxp.com>
Signed-off-by: Ye Li <ye.li@nxp.com>
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Change-Id: I12df622b95960bcdf7da52e4c66470a700690e36

show more ...