| #
1c408d3c |
| 01-Mar-2024 |
Manish Pandey <manish.pandey2@arm.com> |
Merge changes from topic "imx8ulp_support" into integration
* changes:
docs(maintainers): add the maintainers for imx8ulp
docs(imx8ulp): add imx8ulp platform
fix(imx8ulp): increase the mmap re
Merge changes from topic "imx8ulp_support" into integration
* changes:
docs(maintainers): add the maintainers for imx8ulp
docs(imx8ulp): add imx8ulp platform
fix(imx8ulp): increase the mmap region num
feat(imx8ulp): adjust the dram mapped region
feat(imx8ulp): ddrc switch auto low power and software interface
feat(imx8ulp): add some delay before cmc1 access
feat(imx8ulp): add a flag check for the ddr status
fix(imx8ulp): add sw workaround for csi/hotplug test hang
feat(imx8ulp): adjust the voltage when sys dvfs enabled
feat(imx8ulp): enable the DDR frequency scaling support
fix(imx8ulp): fix suspend/resume issue when DBD owner is s400 only
feat(imx8ulp): update XRDC for ELE to access DDR with CA35 DID
feat(imx8ulp): add memory region policy
feat(imx8ulp): protect TEE region for secure access only
feat(imx8ulp): add trusty support
feat(imx8ulp): add OPTEE support
feat(imx8ulp): update the upower config for power optimization
feat(imx8ulp): allow RTD to reset APD through MU
feat(imx8ulp): not power off LPAV PD when LPAV owner is RTD
feat(imx8ulp): add system power off support
feat(imx8ulp): add APD power down mode(PD) support in system suspend
feat(imx8ulp): add the basic support for idle & system suspned
feat(imx8ulp): enable 512KB cache after resume on imx8ulp
feat(imx8ulp): add the initial XRDC support
feat(imx8ulp): allocated caam did for the non secure world
feat(imx8ulp): add i.MX8ULP basic support
build(changelog): add new scopes for nxp imx8ulp platform
feat(scmi): add scmi sensor support
show more ...
|
| #
caee2733 |
| 25-Jan-2022 |
Jacky Bai <ping.bai@nxp.com> |
feat(imx8ulp): enable the DDR frequency scaling support
Enable the DDR frequency scaling support on i.MX8ULP.
Normally, the freq_index define is as below:
0: boot frequency;
1: low frequency(PLL
feat(imx8ulp): enable the DDR frequency scaling support
Enable the DDR frequency scaling support on i.MX8ULP.
Normally, the freq_index define is as below:
0: boot frequency;
1: low frequency(PLL bypassed);
2. high frequency(PLL ON).
Currently, DDR DFS only do frequency switching between
Low freq and high freq.
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Reviewed-by: Ye Li <ye.li@nxp.com>
Change-Id: I3acd8bdf75e2dd6dff645b9f597dcfc0a756c428
show more ...
|