1 /* 2 * (C) Copyright 2003 3 * Wolfgang Denk, DENX Software Engineering, wd@denx.de. 4 * 5 * SPDX-License-Identifier: GPL-2.0+ 6 */ 7 8 /* 9 * This file contains the configuration parameters for the dbau1x00 board. 10 */ 11 12 #ifndef __CONFIG_H 13 #define __CONFIG_H 14 15 #define CONFIG_PB1X00 1 16 #define CONFIG_SOC_AU1X00 1 /* alchemy series cpu */ 17 18 #define CONFIG_DISPLAY_BOARDINFO 19 20 #ifdef CONFIG_PB1000 21 #define CONFIG_SOC_AU1000 1 22 #else 23 #ifdef CONFIG_PB1100 24 #define CONFIG_SOC_AU1100 1 25 #else 26 #ifdef CONFIG_PB1500 27 #define CONFIG_SOC_AU1500 1 28 #else 29 #error "No valid board set" 30 #endif 31 #endif 32 #endif 33 34 #define CONFIG_BOOTDELAY 2 /* autoboot after 2 seconds */ 35 36 #define CONFIG_BAUDRATE 115200 37 38 #define CONFIG_TIMESTAMP /* Print image info with timestamp */ 39 #undef CONFIG_BOOTARGS 40 41 #define CONFIG_EXTRA_ENV_SETTINGS \ 42 "addmisc=setenv bootargs ${bootargs} " \ 43 "console=ttyS0,${baudrate} " \ 44 "panic=1\0" \ 45 "bootfile=/vmlinux.img\0" \ 46 "load=tftp 80500000 ${u-boot}\0" \ 47 "" 48 /* Boot from NFS root */ 49 #define CONFIG_BOOTCOMMAND "bootp; setenv bootargs root=/dev/nfs rw nfsroot=${serverip}:${rootpath} ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}:${hostname}::off; bootm" 50 51 /* 52 * Miscellaneous configurable options 53 */ 54 #define CONFIG_SYS_LONGHELP /* undef to save memory */ 55 #define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */ 56 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */ 57 #define CONFIG_SYS_MAXARGS 16 /* max number of command args*/ 58 59 #define CONFIG_SYS_MALLOC_LEN 128*1024 60 61 #define CONFIG_SYS_BOOTPARAMS_LEN 128*1024 62 63 #define CONFIG_SYS_MIPS_TIMER_FREQ 396000000 64 65 #define CONFIG_SYS_SDRAM_BASE 0x80000000 /* Cached addr */ 66 67 #define CONFIG_SYS_LOAD_ADDR 0x81000000 /* default load address */ 68 69 #define CONFIG_SYS_MEMTEST_START 0x80100000 70 #undef CONFIG_SYS_MEMTEST_START 71 #define CONFIG_SYS_MEMTEST_START 0x80200000 72 #define CONFIG_SYS_MEMTEST_END 0x83800000 73 74 /*----------------------------------------------------------------------- 75 * FLASH and environment organization 76 */ 77 #define CONFIG_SYS_MAX_FLASH_BANKS 2 /* max number of memory banks */ 78 #define CONFIG_SYS_MAX_FLASH_SECT (128) /* max number of sectors on one chip */ 79 80 #define PHYS_FLASH_1 0xbec00000 /* Flash Bank #1 */ 81 #define PHYS_FLASH_2 0xbfc00000 /* Flash Bank #2 */ 82 83 /* The following #defines are needed to get flash environment right */ 84 #define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE 85 #define CONFIG_SYS_MONITOR_LEN (192 << 10) 86 87 #define CONFIG_SYS_INIT_SP_OFFSET 0x4000000 88 89 /* We boot from this flash, selected with dip switch */ 90 #define CONFIG_SYS_FLASH_BASE PHYS_FLASH_2 91 92 /* timeout values are in ticks */ 93 #define CONFIG_SYS_FLASH_ERASE_TOUT (2 * CONFIG_SYS_HZ) /* Timeout for Flash Erase */ 94 #define CONFIG_SYS_FLASH_WRITE_TOUT (2 * CONFIG_SYS_HZ) /* Timeout for Flash Write */ 95 96 #define CONFIG_ENV_IS_NOWHERE 1 97 98 /* Address and size of Primary Environment Sector */ 99 #define CONFIG_ENV_ADDR 0xB0030000 100 #define CONFIG_ENV_SIZE 0x10000 101 102 #define CONFIG_FLASH_16BIT 103 104 #define CONFIG_NR_DRAM_BANKS 2 105 106 107 #define CONFIG_MEMSIZE_IN_BYTES 108 109 110 /*---USB -------------------------------------------*/ 111 #if 0 112 #define CONFIG_USB_OHCI 113 #define CONFIG_USB_STORAGE 114 #define CONFIG_DOS_PARTITION 115 #endif 116 117 /*---ATA PCMCIA ------------------------------------*/ 118 #if 0 119 #define CONFIG_SYS_PCMCIA_MEM_SIZE 0x4000000 /* Offset to slot 1 FIXME!!! */ 120 #define CONFIG_SYS_PCMCIA_MEM_ADDR 0x20000000 121 #define CONFIG_PCMCIA_SLOT_A 122 123 #define CONFIG_ATAPI 1 124 #define CONFIG_MAC_PARTITION 1 125 126 /* We run CF in "true ide" mode or a harddrive via pcmcia */ 127 #define CONFIG_IDE_PCMCIA 1 128 129 /* We only support one slot for now */ 130 #define CONFIG_SYS_IDE_MAXBUS 1 /* max. 1 IDE bus */ 131 #define CONFIG_SYS_IDE_MAXDEVICE 1 /* max. 1 drive per IDE bus */ 132 133 #undef CONFIG_IDE_LED /* LED for ide not supported */ 134 #undef CONFIG_IDE_RESET /* reset for ide not supported */ 135 136 #define CONFIG_SYS_ATA_IDE0_OFFSET 0x0000 137 138 #define CONFIG_SYS_ATA_BASE_ADDR CONFIG_SYS_PCMCIA_MEM_ADDR 139 140 /* Offset for data I/O */ 141 #define CONFIG_SYS_ATA_DATA_OFFSET 8 142 143 /* Offset for normal register accesses */ 144 #define CONFIG_SYS_ATA_REG_OFFSET 0 145 146 /* Offset for alternate registers */ 147 #define CONFIG_SYS_ATA_ALT_OFFSET 0x0100 148 149 #endif 150 /*----------------------------------------------------------------------- 151 * Cache Configuration 152 */ 153 #define CONFIG_SYS_DCACHE_SIZE 16384 154 #define CONFIG_SYS_ICACHE_SIZE 16384 155 #define CONFIG_SYS_CACHELINE_SIZE 32 156 157 158 /* 159 * BOOTP options 160 */ 161 #define CONFIG_BOOTP_BOOTFILESIZE 162 #define CONFIG_BOOTP_BOOTPATH 163 #define CONFIG_BOOTP_GATEWAY 164 #define CONFIG_BOOTP_HOSTNAME 165 166 167 /* 168 * Command line configuration. 169 */ 170 #define CONFIG_CMD_DHCP 171 #define CONFIG_CMD_MII 172 #define CONFIG_CMD_PING 173 174 #undef CONFIG_CMD_FAT 175 #undef CONFIG_CMD_IDE 176 #undef CONFIG_CMD_BEDBUG 177 178 #endif /* __CONFIG_H */ 179