xref: /OK3568_Linux_fs/u-boot/doc/device-tree-bindings/clock/rockchip,rk3288-dmc.txt (revision 4882a59341e53eb6f0b4789bf948001014eff981)

Rockchip Dynamic Memory Controller Driver
Required properties:
- compatible: "rockchip,rk3288-dmc", "syscon"
- rockchip,cru: this driver should access cru regs, so need get cru here
- rockchip,grf: this driver should access grf regs, so need get grf here
- rockchip,pmu: this driver should access pmu regs, so need get pmu here
- rockchip,sgrf: this driver should access sgrf regs, so need get sgrf here
- rockchip,noc: this driver should access noc regs, so need get noc here
- reg: dynamic ram protocol controller(PCTL) address and phy controller(PHYCTL) address
- clock: must include clock specifiers corresponding to entries in the clock-names property.
- clock-output-names: from common clock binding to override the default output clock name
    Must contain
      pclk_ddrupctl0: support clock for access protocol controller registers of channel 0
      pclk_publ0: support clock for access phy controller registers of channel 0
      pclk_ddrupctl1: support clock for access protocol controller registers of channel 1
      pclk_publ1: support clock for access phy controller registers of channel 1
      arm_clk: for get arm frequency
-logic-supply: this driver should adjust VDD_LOGIC according to dmc frequency, so need get logic-supply here
-timings:
    Must contain
      rockchip,odt-disable-freq: if ddr clock frequency low than odt-disable-freq,this driver should disable DDR ODT
      rockchip,dll-disable-freq: if ddr clock frequency low than dll-disable-freq,this driver should disable DDR DLL
      rockchip,sr-enable-freq: if ddr clock frequency high than sr-enable-freq,this driver should enable the automatic self refresh function
      rockchip,pd-enable-freq: if ddr clock frequency high than pd-enable-freq,this driver should enable the automatic power down function
      rockchip,auto-self-refresh-cnt: Self Refresh idle period. Memories are placed into Self-Refresh mode if the NIF is idle in Access state for auto-self-refresh-cnt * 32 * n_clk cycles.The automatic self refresh function is disabled when auto-self-refresh-cnt=0.
      rockchip,auto-power-down-cnt: Power-down idle period. Memories are placed into power-down mode if the NIF is idle for auto-power-down-cnt n_clk cycles.The automatic power down function is disabled when auto-power-down-cnt=0.
      rockchip,ddr-speed-bin: DDR3 type,AC timing parameters from the memory data-sheet
        0.DDR3_800D (5-5-5)
        1.DDR3_800E (6-6-6)
        2.DDR3_1066E (6-6-6)
        3.DDR3_1066F (7-7-7)
        4.DDR3_1066G (8-8-8)
        5.DDR3_1333F (7-7-7)
        6.DDR3_1333G (8-8-8)
        7.DDR3_1333H (9-9-9)
        8.DDR3_1333J (10-10-10)
        9.DDR3_1600G (8-8-8)
        10.DDR3_1600H (9-9-9)
        11.DDR3_1600J (10-10-10)
        12.DDR3_1600K (11-11-11)
        13.DDR3_1866J (10-10-10)
        14.DDR3_1866K (11-11-11)
        15.DDR3_1866L (12-12-12)
        16.DDR3_1866M (13-13-13)
        17.DDR3_2133K (11-11-11)
        18.DDR3_2133L (12-12-12)
        19.DDR3_2133M (13-13-13)
        20.DDR3_2133N (14-14-14)
        21.DDR3_DEFAULT
      rockchip,trcd: tRCD,AC timing parameters from the memory data-sheet
      rockchip,trp: tRP,AC timing parameters from the memory data-sheet
-rockchip,num-channels: number of SDRAM channels (1 or 2)
-rockchip,pctl-timing: parameters for the SDRAM setup, in this order:
	togcnt1u
	tinit
	trsth
	togcnt100n
	trefi
	tmrd
	trfc
	trp
	trtw
	tal
	tcl
	tcwl
	tras
	trc
	trcd
	trrd
	trtp
	twr
	twtr
	texsr
	txp
	txpdll
	tzqcs
	tzqcsi
	tdqs
	tcksre
	tcksrx
	tcke
	tmod
	trstl
	tzqcl
	tmrr
	tckesr
	tdpd
-rockchip,phy-timing: PHY timing information in this order:
	dtpr0
	dtpr1
	dtpr2
	mr0..mr3
-rockchip,sdram-channel: SDRAM channel information, each 8 bits. Both channels
will be set up the same. The parameters are in this order:
	rank
	col
	bk
	bw
	dbw
	row_3_4
	cs0_row
	cs1_row
- rockchip,sdram-params: SDRAM base parameters, in this order:
	NOC timing	- value for ddrtiming register
	NOC activate	- value for activate register
	ddrconf		- value for ddrconf register
	DDR frequency in MHz
	DRAM type (3=DDR3, 6=LPDDR3)
	stride		- stride value for soc_con2 register
	odt             - 1 to enable DDR ODT, 0 to disable

Example:
	dmc: dmc@ff610000 {
		compatible = "rockchip,rk3288-dmc", "syscon";
		rockchip,cru = <&cru>;
		rockchip,grf = <&grf>;
		rockchip,pmu = <&pmu>;
		rockchip,sgrf = <&sgrf>;
		rockchip,noc = <&noc>;
		reg = <0xff610000 0x3fc
		       0xff620000 0x294
		       0xff630000 0x3fc
		       0xff640000 0x294>;
		clocks = <&cru PCLK_DDRUPCTL0>, <&cru PCLK_PUBL0>,
			 <&cru PCLK_DDRUPCTL1>, <&cru PCLK_PUBL1>,
			 <&cru ARMCLK>;
		clock-names = "pclk_ddrupctl0", "pclk_publ0",
			      "pclk_ddrupctl1", "pclk_publ1",
			      "arm_clk";
	};

	&dmc {
		logic-supply = <&vdd_logic>;
		timings {
			rockchip,odt-disable-freq = <333000000>;
			rockchip,dll-disable-freq = <333000000>;
			rockchip,sr-enable-freq = <333000000>;
			rockchip,pd-enable-freq = <666000000>;
			rockchip,auto-self-refresh-cnt = <0>;
			rockchip,auto-power-down-cnt = <64>;
			rockchip,ddr-speed-bin = <21>;
			rockchip,trcd = <10>;
			rockchip,trp = <10>;
		};
		rockchip,num-channels = <2>;
		rockchip,pctl-timing = <0x29a 0x1f4 0xc8 0x42 0x4e 0x4 0xea 0xa
			0x5 0x0 0xa 0x7 0x19 0x24 0xa 0x7
			0x5 0xa 0x5 0x200 0x5 0x10 0x40 0x0
			0x1 0x7 0x7 0x4 0xc 0x43 0x100 0x0
			0x5 0x0>;
		rockchip,phy-timing = <0x48f9aab4 0xea0910 0x1002c200
			0xa60 0x40 0x10 0x0>;
		rockchip,sdram-channel = /bits/ 8 <0x1 0xa 0x3 0x2 0x1 0x0 0xf 0xf>;
		rockchip,sdram-params = <0x30B25564 0x627 3 666000000 3 9 1>;
	};