xref: /OK3568_Linux_fs/kernel/drivers/input/sensors/accel/iam20680_acc.c (revision 4882a59341e53eb6f0b4789bf948001014eff981)

// SPDX-License-Identifier: GPL-2.0
/*
 * accel driver for iam20680
 *
 * Copyright (c) 2021 Rockchip Electronics Co., Ltd.
 *
 * Author: sxj <sxj@rock-chips.com>
 *
 */
#include <linux/interrupt.h>
#include <linux/i2c.h>
#include <linux/slab.h>
#include <linux/irq.h>
#include <linux/miscdevice.h>
#include <linux/gpio.h>
#include <linux/uaccess.h>
#include <linux/atomic.h>
#include <linux/delay.h>
#include <linux/input.h>
#include <linux/workqueue.h>
#include <linux/freezer.h>
#include <linux/of_gpio.h>
#ifdef CONFIG_HAS_EARLYSUSPEND
#include <linux/earlysuspend.h>
#endif
#include <linux/sensor-dev.h>
#include <linux/iam20680.h>

static int iam20680_set_rate(struct i2c_client *client, int rate)
{
	/* always use poll mode, no need to set rate */
	return 0;
}

static int sensor_active(struct i2c_client *client, int enable, int rate)
{
	struct sensor_private_data *sensor =
	    (struct sensor_private_data *) i2c_get_clientdata(client);
	int result = 0;
	int status = 0;
	u8 pwrm1 = 0;

	sensor->ops->ctrl_data = sensor_read_reg(client, sensor->ops->ctrl_reg);
	pwrm1 = sensor_read_reg(client, IAM20680_PWR_MGMT_1);

	if (!enable) {
		status = BIT_ACCEL_STBY;
		sensor->ops->ctrl_data |= status;
		if ((sensor->ops->ctrl_data &  BIT_GYRO_STBY) == BIT_GYRO_STBY)
			pwrm1 |= IAM20680_PWRM1_SLEEP;
	} else {
		status = ~BIT_ACCEL_STBY;
		sensor->ops->ctrl_data &= status;
		pwrm1 &= ~IAM20680_PWRM1_SLEEP;

		iam20680_set_rate(client, rate);
	}
	result = sensor_write_reg(client, sensor->ops->ctrl_reg, sensor->ops->ctrl_data);
	if (result) {
		dev_err(&client->dev, "%s:fail to set pwrm2\n", __func__);
		return -1;
	}
	msleep(20);

	result = sensor_write_reg(client, IAM20680_PWR_MGMT_1, pwrm1);
	if (result) {
		dev_err(&client->dev, "%s:fail to set pwrm1\n", __func__);
		return -1;
	}
	msleep(50);

	return result;
}

static int sensor_init(struct i2c_client *client)
{
	int res = 0;
	struct sensor_private_data *sensor =
	    (struct sensor_private_data *) i2c_get_clientdata(client);

	res = sensor_write_reg(client, IAM20680_PWR_MGMT_1, 0x80);
	if (res) {
		dev_err(&client->dev, "set IAM20680_PWR_MGMT_1 error,res: %d!\n", res);
		return res;
	}
	msleep(40);

	res = sensor_write_reg(client, IAM20680_GYRO_CONFIG, 0x18);
	if (res) {
		dev_err(&client->dev, "set IAM20680_GYRO_CONFIG error,res: %d!\n", res);
		return res;
	}
	msleep(10);

	res = sensor_write_reg(client, IAM20680_ACCEL_CONFIG, 0x00);
	if (res) {
		dev_err(&client->dev, "set IAM20680_ACCEL_CONFIG error,res: %d!\n", res);
		return res;
	}
	msleep(10);

	res = sensor_write_reg(client, IAM20680_ACCEL_CONFIG2, 0x00);
	if (res) {
		dev_err(&client->dev, "set IAM20680_ACCEL_CONFIG2 error,res: %d!\n", res);
		return res;
	}
	res = sensor_write_reg(client, IAM20680_PWR_MGMT_2, 0x3F);
	if (res) {
		dev_err(&client->dev, "set IAM20680_PWR_MGMT_2 error,res: %d!\n", res);
		return res;
	}
	msleep(10);
	res = sensor_write_reg(client, IAM20680_PWR_MGMT_1, 0x41);
	if (res) {
		dev_err(&client->dev, "set IAM20680_PWR_MGMT_1 error,res: %d!\n", res);
		return res;
	}
	msleep(10);

	res = sensor->ops->active(client, 0, sensor->pdata->poll_delay_ms);
	if (res) {
		dev_err(&client->dev, "%s:line=%d,error\n", __func__, __LINE__);
		return res;
	}
	return res;
}

static int gsensor_report_value(struct i2c_client *client, struct sensor_axis *axis)
{
	struct sensor_private_data *sensor =
	    (struct sensor_private_data *) i2c_get_clientdata(client);

	if (sensor->status_cur == SENSOR_ON) {
		/* Report acceleration sensor information */
		input_report_abs(sensor->input_dev, ABS_X, axis->x);
		input_report_abs(sensor->input_dev, ABS_Y, axis->y);
		input_report_abs(sensor->input_dev, ABS_Z, axis->z);
		input_sync(sensor->input_dev);
	}

	return 0;
}

static int sensor_report_value(struct i2c_client *client)
{
	struct sensor_private_data *sensor =
		(struct sensor_private_data *) i2c_get_clientdata(client);
	struct sensor_platform_data *pdata = sensor->pdata;
	int ret = 0;
	short x, y, z;
	struct sensor_axis axis;
	u8 buffer[6] = {0};

	if (sensor->ops->read_len < 6) {
		dev_err(&client->dev, "%s: length is error, len=%d\n",
				__func__, sensor->ops->read_len);
		return -1;
	}

	memset(buffer, 0, 6);

	/* Data bytes from hardware xL, xH, yL, yH, zL, zH */
	do {
		*buffer = sensor->ops->read_reg;
		ret = sensor_rx_data(client, buffer, sensor->ops->read_len);
		if (ret < 0)
			return ret;
	} while (0);

	x = ((buffer[0] << 8) & 0xff00) + (buffer[1] & 0xFF);
	y = ((buffer[2] << 8) & 0xff00) + (buffer[3] & 0xFF);
	z = ((buffer[4] << 8) & 0xff00) + (buffer[5] & 0xFF);

	axis.x = (pdata->orientation[0]) * x + (pdata->orientation[1]) * y + (pdata->orientation[2]) * z;
	axis.y = (pdata->orientation[3]) * x + (pdata->orientation[4]) * y + (pdata->orientation[5]) * z;
	axis.z = (pdata->orientation[6]) * x + (pdata->orientation[7]) * y + (pdata->orientation[8]) * z;

	gsensor_report_value(client, &axis);

	mutex_lock(&(sensor->data_mutex));
	sensor->axis = axis;
	mutex_unlock(&(sensor->data_mutex));

	return ret;
}

static struct sensor_operate gsensor_iam20680_ops = {
	.name				= "iam20680_acc",
	.type				= SENSOR_TYPE_ACCEL,
	.id_i2c				= ACCEL_ID_IAM20680,
	.read_reg			= IAM20680_ACCEL_XOUT_H,
	.read_len			= 6,
	.id_reg				= IAM20680_WHOAMI,
	.id_data			= IAM20680_DEVICE_ID,
	.precision			= IAM20680_PRECISION,
	.ctrl_reg			= IAM20680_PWR_MGMT_2,
	.int_status_reg		= IAM20680_INT_STATUS,
	.range				= {-32768, 32768},
	.trig				= IRQF_TRIGGER_HIGH | IRQF_ONESHOT,
	.active				= sensor_active,
	.init				= sensor_init,
	.report				= sensor_report_value,
};

/****************operate according to sensor chip:end************/
static int gsensor_iam20680_probe(struct i2c_client *client,
				 const struct i2c_device_id *devid)
{
	return sensor_register_device(client, NULL, devid, &gsensor_iam20680_ops);
}

static int gsensor_iam20680_remove(struct i2c_client *client)
{
	return sensor_unregister_device(client, NULL, &gsensor_iam20680_ops);
}

static const struct i2c_device_id gsensor_iam20680_id[] = {
	{"iam20680_acc", ACCEL_ID_IAM20680},
	{}
};

static struct i2c_driver gsensor_iam20680_driver = {
	.probe = gsensor_iam20680_probe,
	.remove = gsensor_iam20680_remove,
	.shutdown = sensor_shutdown,
	.id_table = gsensor_iam20680_id,
	.driver = {
		.name = "gsensor_iam20680",
#ifdef CONFIG_PM
		.pm = &sensor_pm_ops,
#endif
	},
};

module_i2c_driver(gsensor_iam20680_driver);

MODULE_AUTHOR("sxj <sxj@rock-chips.com>");
MODULE_DESCRIPTION("iam20680_acc 3-Axis accelerometer driver");
MODULE_LICENSE("GPL");