1*4882a593SmuzhiyunSamsung S5K6A3(YX) raw image sensor 2*4882a593Smuzhiyun--------------------------------- 3*4882a593Smuzhiyun 4*4882a593SmuzhiyunS5K6A3(YX) is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces 5*4882a593Smuzhiyunand CCI (I2C compatible) control bus. 6*4882a593Smuzhiyun 7*4882a593SmuzhiyunRequired properties: 8*4882a593Smuzhiyun 9*4882a593Smuzhiyun- compatible : "samsung,s5k6a3"; 10*4882a593Smuzhiyun- reg : I2C slave address of the sensor; 11*4882a593Smuzhiyun- svdda-supply : core voltage supply; 12*4882a593Smuzhiyun- svddio-supply : I/O voltage supply; 13*4882a593Smuzhiyun- afvdd-supply : AF (actuator) voltage supply; 14*4882a593Smuzhiyun- gpios : specifier of a GPIO connected to the RESET pin; 15*4882a593Smuzhiyun- clocks : should contain list of phandle and clock specifier pairs 16*4882a593Smuzhiyun according to common clock bindings for the clocks described 17*4882a593Smuzhiyun in the clock-names property; 18*4882a593Smuzhiyun- clock-names : should contain "extclk" entry for the sensor's EXTCLK clock; 19*4882a593Smuzhiyun 20*4882a593SmuzhiyunOptional properties: 21*4882a593Smuzhiyun 22*4882a593Smuzhiyun- clock-frequency : the frequency at which the "extclk" clock should be 23*4882a593Smuzhiyun configured to operate, in Hz; if this property is not 24*4882a593Smuzhiyun specified default 24 MHz value will be used. 25*4882a593Smuzhiyun 26*4882a593SmuzhiyunThe common video interfaces bindings (see video-interfaces.txt) should be 27*4882a593Smuzhiyunused to specify link to the image data receiver. The S5K6A3(YX) device 28*4882a593Smuzhiyunnode should contain one 'port' child node with an 'endpoint' subnode. 29*4882a593Smuzhiyun 30*4882a593SmuzhiyunFollowing properties are valid for the endpoint node: 31*4882a593Smuzhiyun 32*4882a593Smuzhiyun- data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in 33*4882a593Smuzhiyun video-interfaces.txt. The sensor supports only one data lane. 34