1*4882a593SmuzhiyunSitronix ST7586 display panel 2*4882a593Smuzhiyun 3*4882a593SmuzhiyunRequired properties: 4*4882a593Smuzhiyun- compatible: "lego,ev3-lcd". 5*4882a593Smuzhiyun- a0-gpios: The A0 signal (since this binding is for serial mode, this is 6*4882a593Smuzhiyun the pin labeled D1 on the controller, not the pin labeled A0) 7*4882a593Smuzhiyun- reset-gpios: Reset pin 8*4882a593Smuzhiyun 9*4882a593SmuzhiyunThe node for this driver must be a child node of a SPI controller, hence 10*4882a593Smuzhiyunall mandatory properties described in ../spi/spi-bus.txt must be specified. 11*4882a593Smuzhiyun 12*4882a593SmuzhiyunOptional properties: 13*4882a593Smuzhiyun- rotation: panel rotation in degrees counter clockwise (0,90,180,270) 14*4882a593Smuzhiyun 15*4882a593SmuzhiyunExample: 16*4882a593Smuzhiyun display@0{ 17*4882a593Smuzhiyun compatible = "lego,ev3-lcd"; 18*4882a593Smuzhiyun reg = <0>; 19*4882a593Smuzhiyun spi-max-frequency = <10000000>; 20*4882a593Smuzhiyun a0-gpios = <&gpio 43 GPIO_ACTIVE_HIGH>; 21*4882a593Smuzhiyun reset-gpios = <&gpio 80 GPIO_ACTIVE_HIGH>; 22*4882a593Smuzhiyun }; 23