1*4882a593SmuzhiyunSTM32MP157C-Odyssey 2*4882a593Smuzhiyun 3*4882a593SmuzhiyunIntro 4*4882a593Smuzhiyun===== 5*4882a593Smuzhiyun 6*4882a593SmuzhiyunThis configuration supports the STM32MP157C-Odyssey platform: 7*4882a593Smuzhiyun 8*4882a593Smuzhiyun https://wiki.seeedstudio.com/ODYSSEY-STM32MP157C/ 9*4882a593Smuzhiyun 10*4882a593SmuzhiyunHow to build 11*4882a593Smuzhiyun============ 12*4882a593Smuzhiyun 13*4882a593Smuzhiyun $ make stm32mp157c_odyssey_defconfig 14*4882a593Smuzhiyun $ make 15*4882a593Smuzhiyun 16*4882a593SmuzhiyunHow to write the microSD card 17*4882a593Smuzhiyun============================= 18*4882a593Smuzhiyun 19*4882a593SmuzhiyunOnce the build process is finished you will have an image called 20*4882a593Smuzhiyun"sdcard.img" in the output/images/ directory. 21*4882a593Smuzhiyun 22*4882a593SmuzhiyunCopy the bootable "sdcard.img" onto an microSD card with "dd": 23*4882a593Smuzhiyun 24*4882a593Smuzhiyun $ sudo dd if=output/images/sdcard.img of=/dev/sdX 25*4882a593Smuzhiyun 26*4882a593SmuzhiyunBoot the board 27*4882a593Smuzhiyun============== 28*4882a593Smuzhiyun 29*4882a593Smuzhiyun (1) Insert the microSD card in connector J21. 30*4882a593Smuzhiyun 31*4882a593Smuzhiyun (2) Connect to the UART connector J24 (located next the the DC jack 32*4882a593Smuzhiyun J24 and the battery connector J20) and run your serial communication 33*4882a593Smuzhiyun program on /dev/ttyACM0. 34*4882a593Smuzhiyun 35*4882a593Smuzhiyun (3) Plug a USB-C cable in J6 or a center-positive 12V jack into J17 36*4882a593Smuzhiyun to power-up the board. 37*4882a593Smuzhiyun 38*4882a593Smuzhiyun (4) The system will start, with the console on UART. 39