| /rk3399_rockchip-uboot/board/boundary/nitrogen6x/ |
| H A D | 6x_upgrade.txt | 34 echo "Error re-reading EEPROM" ;
38 echo "Error reading boot loader from EEPROM" ;
|
| /rk3399_rockchip-uboot/drivers/bootcount/ |
| H A D | Kconfig | 48 hex "RAM address used for reading and writing the boot counter"
52 Set the address used for reading and writing the boot counter.
|
| /rk3399_rockchip-uboot/fs/cramfs/ |
| H A D | Kconfig | 4 This provides support for reading images from CRAMFS (Compressed ROM
|
| /rk3399_rockchip-uboot/fs/jffs2/ |
| H A D | Kconfig | 4 This provides support for reading images from JFFS2 (Journalling
|
| /rk3399_rockchip-uboot/fs/cbfs/ |
| H A D | Kconfig | 4 Define this to enable support for reading from a Coreboot
|
| /rk3399_rockchip-uboot/doc/SPI/ |
| H A D | README.ti_qspi_dra_test | 14 reading MLO
17 reading u-boot.img
|
| /rk3399_rockchip-uboot/drivers/block/ |
| H A D | Kconfig | 8 reading, writing and (in some cases) erasing blocks. Block
20 reading, writing and (in some cases) erasing blocks. Block
|
| /rk3399_rockchip-uboot/fs/fat/ |
| H A D | Kconfig | 4 This provides support for reading images from File Allocation Table
|
| /rk3399_rockchip-uboot/drivers/mmc/ |
| H A D | sunxi_mmc.c | 273 const int reading = !!(data->flags & MMC_DATA_READ); in mmc_trans_data_by_cpu() local
274 const uint32_t status_bit = reading ? SUNXI_MMC_STATUS_FIFO_EMPTY : in mmc_trans_data_by_cpu()
277 unsigned *buff = (unsigned int *)(reading ? data->dest : data->src); in mmc_trans_data_by_cpu()
293 if (reading) in mmc_trans_data_by_cpu()
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/spi/ |
| H A D | spi-stm32-qspi.txt | 15 - spi-rx-bus-width : Bus width (number of lines) for reading (1-4)
|
| H A D | spi-bus.txt | 63 a header byte before reading data from the slave.
|
| /rk3399_rockchip-uboot/drivers/ufs/ |
| H A D | Kconfig | 41 Enable support for reading, writing and programming the
|
| /rk3399_rockchip-uboot/arch/arm/mach-mvebu/ |
| H A D | Kconfig | 189 Enable support for reading and writing eFuses on mvebu SoCs.
197 Instead the eFuse accesses are emulated by writing to and reading
|
| /rk3399_rockchip-uboot/doc/ |
| H A D | README.fsl_iim | 38 immediately, but this does not make any difference for a user reading
|
| H A D | README.omap3 | 149 (place where SPL lives) we require this setup for u-boot at least when reading
152 handle this we can switch to another ECC algorithm after reading the payload
|
| H A D | README.memory-test | 71 that memory errors can be found by writing to and reading from memory.
97 to catch did not happen when accessing the RAM, but when reading from
|
| H A D | README.unaligned-memory-access.txt | 18 For example, reading 4 bytes of data from address 0x10004 is fine, but
19 reading 4 bytes of data from address 0x10005 would be an unaligned memory
92 by 4 (remember, we're reading a 4 byte value here).
|
| H A D | README.mxsimage | 132 reading loop.
137 break the reading loop.
|
| H A D | README.xtensa | 87 reading of meaningless data, written data being ignored or an exception,
|
| H A D | README.davinci.nand_spl | 87 !! RBL always starts reading from page 0 !!
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/input/ |
| H A D | cros-ec-keyb.txt | 4 a separate EC (Embedded Controller) device. It provides a message for reading
|
| /rk3399_rockchip-uboot/board/freescale/p1_p2_rdb_pc/ |
| H A D | README | 38 board by reading i2c bus and setting the appropriate mux values.
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/ |
| H A D | chosen.txt | 50 device may be probed by reading the image and verifying an image
|
| /rk3399_rockchip-uboot/drivers/mtd/nand/raw/ |
| H A D | Kconfig | 206 The SPL driver only supports reading from the NAND using DMA
350 determined by reading ONFI params.
353 - SPL boot does not support reading of ONFI parameters. This is done to
|
| /rk3399_rockchip-uboot/drivers/tpm/ |
| H A D | Kconfig | 12 such as reading and writing TPM private data. This is enough to
|