| /rk3399_rockchip-uboot/doc/device-tree-bindings/gpio/ |
| H A D | intel,x86-pinctrl.txt | 15 - mode-gpio - (optional) standalone property to force the pin into GPIO mode
16 - mode-func - (optional) function number to assign to the pin. If
19 - output-value - (optional) this set the default output value of the GPIO
20 - direction - (optional) this set the direction of the gpio
21 - pull-strength - (optional) this set the pull strength of the pin
22 - pull-assign - (optional) this set the pull assignement (up/down) of the pin
23 - invert - (optional) this input pin is inverted
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/clock/ |
| H A D | rockchip,rk3288-cru.txt | 32 - "xin32k" - rtc clock - optional,
33 - "ext_i2s" - external I2S clock - optional,
34 - "ext_hsadc" - external HSADC clock - optional,
35 - "ext_edp_24m" - external display port clock - optional,
36 - "ext_vip" - external VIP clock - optional,
37 - "ext_isp" - external ISP clock - optional,
38 - "ext_jtag" - external JTAG clock - optional
|
| H A D | rockchip,rk3188-cru.txt | 33 - "xin32k" - rtc clock - optional,
34 - "xin27m" - 27mhz crystal input on rk3066 - optional,
35 - "ext_hsadc" - external HSADC clock - optional,
36 - "ext_cif0" - external camera clock - optional,
37 - "ext_rmii" - external RMII clock - optional,
38 - "ext_jtag" - externalJTAG clock - optional
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/net/ |
| H A D | fixed-link.txt | 14 * 'full-duplex' (boolean, optional), to indicate that full duplex is
16 * 'pause' (boolean, optional), to indicate that pause should be
18 * 'asym-pause' (boolean, optional), to indicate that asym_pause should
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/spi/ |
| H A D | spi-bus.txt | 15 - cs-gpios - (optional) gpios chip select.
50 - spi-cpol - (optional) Empty property indicating device requires
52 - spi-cpha - (optional) Empty property indicating device requires
54 - spi-cs-high - (optional) Empty property indicating device requires
56 - spi-3wire - (optional) Empty property indicating device requires
58 - spi-tx-bus-width - (optional) The bus width(number of data wires) that
60 - spi-rx-bus-width - (optional) The bus width(number of data wires) that
62 - spi-half-duplex - (optional) Indicates that the SPI bus should wait for
|
| /rk3399_rockchip-uboot/arch/x86/dts/ |
| H A D | emulation-u-boot.dtsi | 15 optional-ucode;
19 optional-ucode;
|
| H A D | quark-u-boot.dtsi | 13 optional-ucode;
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/leds/ |
| H A D | leds-gpio.txt | 13 - label : (optional)
15 - linux,default-trigger : (optional)
17 - default-state: (optional) The initial state of the LED. Valid
|
| /rk3399_rockchip-uboot/board/seco/ |
| H A D | Kconfig | 5 optional
20 optional
|
| /rk3399_rockchip-uboot/arch/arm/mach-integrator/ |
| H A D | Kconfig | 6 optional
22 optional
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/adc/ |
| H A D | adc.txt | 9 *optional and always checked, Voltage polarity info:
15 *optional and always checked, supply Voltage constants:
19 *optional and checked only if the above corresponding, doesn't exist:
|
| /rk3399_rockchip-uboot/doc/device-tree-bindings/video/ |
| H A D | display-timing.txt | 10 optional properties:
25 optional properties:
39 All the optional properties that are not bool follow the following logic:
|
| /rk3399_rockchip-uboot/doc/ |
| H A D | README.bitbangMII | 15 MII_INIT - Generic code to enable the MII bus (optional)
16 MDIO_DECLARE - Declaration needed to access to the MDIO pin (optional)
21 MDC_DECLARE - Declaration needed to access to the MDC pin (optional)
|
| /rk3399_rockchip-uboot/arch/arm/mach-imx/mx7ulp/ |
| H A D | Kconfig | 8 optional
|
| /rk3399_rockchip-uboot/arch/arm/mach-tegra/tegra114/ |
| H A D | Kconfig | 5 optional
|
| /rk3399_rockchip-uboot/arch/ |
| H A D | Kconfig | 148 This is optional. For those targets without the CPU directory,
157 This is optional. For those targets without the SoC directory,
170 This is optional. For those targets without the vendor directory,
181 This is optional. For those targets without the board directory,
|
| /rk3399_rockchip-uboot/tools/binman/test/ |
| H A D | 44_x86_optional_ucode.dts | 12 optional-ucode;
|
| /rk3399_rockchip-uboot/arch/nds32/ |
| H A D | Kconfig | 9 optional
|
| /rk3399_rockchip-uboot/arch/arm/mach-s5pc1xx/ |
| H A D | Kconfig | 5 optional
|
| /rk3399_rockchip-uboot/arch/arm/mach-orion5x/ |
| H A D | Kconfig | 5 optional
|
| /rk3399_rockchip-uboot/drivers/cpu/ |
| H A D | amp.its | 102 load = <0x2000000>; // optional
103 load_c = <0x4000000>; // optional
|
| /rk3399_rockchip-uboot/arch/microblaze/ |
| H A D | Kconfig | 9 optional
|
| /rk3399_rockchip-uboot/arch/arm/mach-omap2/ |
| H A D | Kconfig | 109 protocols, dual camera support, optional 3D graphics
110 and an optional customer programmable secure boot.
125 protocols, optional 3D graphics and an optional customer
|
| /rk3399_rockchip-uboot/board/dbau1x00/ |
| H A D | Kconfig | 31 optional
|
| /rk3399_rockchip-uboot/board/efi/ |
| H A D | Kconfig | 5 optional
|