| /OK3568_Linux_fs/u-boot/doc/SPI/ |
| H A D | README.ti_qspi_flash | 16 MLO/u-boot.img will be flashed from SD/MMC to the flash device
19 from the predefined location in the flash, where it was flashed and
|
| /OK3568_Linux_fs/buildroot/board/technologic/ts4900/ |
| H A D | readme.txt | 16 The default U-boot configuration flashed scans the SD card to find the
48 The bootloader comes pre-flashed on the board on an SPI flash. Since
|
| /OK3568_Linux_fs/buildroot/board/freescale/imx6slevk/ |
| H A D | readme.txt | 10 directory, ready to be flashed into the SD card:
|
| /OK3568_Linux_fs/buildroot/board/freescale/imx6sxsdb/ |
| H A D | readme.txt | 10 directory, ready to be flashed into the SD card:
|
| /OK3568_Linux_fs/buildroot/board/warp7/ |
| H A D | readme.txt | 54 In case a bad U-Boot has been flashed to the eMMC and the board no
82 Transfer u-boot-dtb.imx that will be flashed into the eMMC:
|
| /OK3568_Linux_fs/buildroot/package/bmap-tools/ |
| H A D | Config.in.host | 9 image files, can be copied or flashed a lot faster with
|
| H A D | Config.in | 13 image files, can be copied or flashed a lot faster with
|
| /OK3568_Linux_fs/buildroot/board/technexion/imx8mpico/ |
| H A D | readme.txt | 38 command. The boards are sold pre-flashed with such a u-boot. It is
46 In case the board was flashed with a wrong u-boot, or the eMMC is
|
| /OK3568_Linux_fs/buildroot/board/technexion/imx8mmpico/ |
| H A D | readme.txt | 39 command. The boards are sold pre-flashed with such a u-boot. It is
47 In case the board was flashed with a wrong u-boot, or the eMMC is
|
| /OK3568_Linux_fs/buildroot/board/beaglev/ |
| H A D | readme.txt | 63 The bootloader pre-flashed on the Beagle-V has a non-working
99 The BeagleV comes pre-flashed with functional low-level bootloaders
|
| /OK3568_Linux_fs/buildroot/board/beagleboardx15/ |
| H A D | readme.txt | 8 The image must be flashed to a SD card to be used.
|
| /OK3568_Linux_fs/yocto/poky/meta/recipes-support/bmap-tools/ |
| H A D | bmap-tools_git.bb | 5 unused blocks, like raw system image files, can be copied or flashed a lot \
|
| /OK3568_Linux_fs/u-boot/doc/ |
| H A D | README.nokia_rx51 | 9 onenand as such. This u-boot is intended to be flashed to the N900 like
100 flashed with attached zImage to RX-51 kernel nand area. For enabling UBIFS
|
| H A D | README.pblimage | 31 boot image that can be flashed on the board eSPI flash, SD/MMC and NAND.
|
| /OK3568_Linux_fs/u-boot/board/wandboard/ |
| H A D | README | 24 flashed into the SD card;
|
| /OK3568_Linux_fs/u-boot/board/technexion/pico-imx7d/ |
| H A D | README | 41 Transfer u-boot.imx to be flashed into the eMMC:
|
| /OK3568_Linux_fs/u-boot/board/warp/ |
| H A D | README | 42 Transfer u-boot.imx that will be flashed into the eMMC:
|
| /OK3568_Linux_fs/u-boot/board/technexion/pico-imx6ul/ |
| H A D | README | 43 Transfer u-boot.imx that will be flashed into the eMMC:
|
| /OK3568_Linux_fs/u-boot/board/warp7/ |
| H A D | README | 49 Transfer u-boot.imx that will be flashed into the eMMC:
|
| /OK3568_Linux_fs/u-boot/board/freescale/mx28evk/ |
| H A D | README | 62 to generate a binary to be flashed into SPI NOR.
|
| /OK3568_Linux_fs/buildroot/board/technologic/ts7680/ |
| H A D | readme.txt | 46 The bootloader comes pre-flashed on the board on an SPI flash. Since
|
| /OK3568_Linux_fs/buildroot/docs/manual/ |
| H A D | beyond-buildroot.txt | 47 It can be easily flashed to a USB drive with +dd+:
|
| /OK3568_Linux_fs/kernel/Documentation/networking/devlink/ |
| H A D | devlink-info.rst | 78 ``stored`` versions when new software is flashed, it must not report
114 - Identifier of a distribution package which was flashed onto the device.
|
| /OK3568_Linux_fs/buildroot/package/mfgtools/ |
| H A D | readme.txt | 39 5. Copy the prebuilt binaries to be flashed
|
| /OK3568_Linux_fs/buildroot/board/globalscale/espressobin/ |
| H A D | readme.txt | 46 By default, the ESPRESSObin comes with a pre-flashed U-Boot set up to
|