Searched refs:J22 (Results 1 – 4 of 4) sorted by relevance
| /OK3568_Linux_fs/u-boot/board/freescale/mpc8349itx/ |
| H A D | README | 21 Guide. Of particular interest to U-Boot developers is jumper J22:
34 Jumper J22.E is only for the ITX, and it decides the configuration
35 of the flash chips. If J22.E is ON (i.e. jumpered), then flash chip
37 If J22.E is OFF, then U7 is at FE000000 and U4 is at FE800000.
39 For U-Boot development, J22.E can be used to switch back-and-forth
60 On the ITX, jumper J22.E is used to determine which flash chips are
61 at which address. When J22.E is switched, addresses from FE000000
|
| /OK3568_Linux_fs/u-boot/doc/ |
| H A D | README.at91 | 38 0xD0000000 - Dxxxxxxx Atmel Dataflash card (J22)
|
| /OK3568_Linux_fs/kernel/drivers/pinctrl/aspeed/ |
| H A D | pinctrl-aspeed-g6.c | 167 #define J22 17 macro
168 SIG_EXPR_LIST_DECL_SESG(J22, RGMII3TXCTL, RGMII3, SIG_DESC_SET(SCU410, 17),
170 SIG_EXPR_LIST_DECL_SESG(J22, RMII3TXEN, RMII3, SIG_DESC_SET(SCU410, 17),
172 PIN_DECL_2(J22, GPIOC1, RGMII3TXCTL, RMII3TXEN);
238 FUNC_GROUP_DECL(RGMII3, H24, J22, H22, H23, G22, F22, G23, G24, F23, F26, F25,
240 FUNC_GROUP_DECL(RMII3, H24, J22, H22, H23, G23, F23, F26, F25, E26);
1827 ASPEED_PINCTRL_PIN(J22),
|
| /OK3568_Linux_fs/buildroot/board/atmel/ |
| H A D | readme.txt | 72 o sama5d4ek: DBGU: J22 or J24, USB sam-ba: J1
|