Searched full:thermistors (Results 1 – 18 of 18) sorted by relevance
| /OK3568_Linux_fs/kernel/Documentation/hwmon/ |
| H A D | ntc_thermistor.rst | 4 Supported thermistors from Murata:
6 * Murata NTC Thermistors NCP15WB473, NCP18WB473, NCP21WB473, NCP03WB473,
14 Supported thermistors from EPCOS:
16 * EPCOS NTC Thermistors B57330V2103
22 Other NTC thermistors can be supported simply by adding compensation
|
| H A D | pc87360.rst | 134 thermistors (as opposed to thermal diodes for the first three temperature
146 thermal diode, and thermistors).
|
| H A D | max6697.rst | 77 thermal transistors plus three thermistors in addition to the local temperature
|
| H A D | w83793.rst | 61 Temp5-6 can be connected to external thermistors (value of
|
| H A D | it87.rst | 346 If a temperature sensor is configured for thermistors, the attribute values
|
| H A D | vt1211.rst | 152 Temp3-temp7 support NTC thermistors. For these channels, the driver returns
|
| H A D | sysfs-interface.rst | 605 Some chips measure temperature using external thermistors and an ADC, and
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/iio/temperature/ |
| H A D | adi,ltc2983.yaml | 293 resistor is used for multiple thermistors. Note that this property
316 and uK only for custom thermistors. For more details look at table
360 Rsense are used by thermistors and RTD's.
|
| /OK3568_Linux_fs/kernel/arch/arm/boot/dts/ |
| H A D | cros-adc-thermistors.dtsi | 3 * Thermistor dts fragment for devices that use Thermistors as
|
| H A D | exynos5800-peach-pi.dts | 1100 #include "cros-adc-thermistors.dtsi"
|
| H A D | exynos5420-peach-pit.dts | 1118 #include "cros-adc-thermistors.dtsi"
|
| /OK3568_Linux_fs/kernel/include/linux/platform_data/ |
| H A D | ntc_thermistor.h | 3 * ntc_thermistor.h - NTC Thermistors
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/thermal/ |
| H A D | thermal-generic-adc.txt | 3 On some of platforms, thermal sensor like thermistors are connected to
|
| /OK3568_Linux_fs/kernel/drivers/hwmon/ |
| H A D | pc87360.c | 747 * used in the chip to measure voltage across the thermistors
1152 /* Are we using thermistors? */ in pc87360_find()
1163 pr_info("Using thermistors for temperature monitoring\n"); in pc87360_find()
1435 dev_dbg(&pdev->dev, "bios thermistors:%d\n", use_thermistors); in pc87360_init_device()
1440 /* thermistors are temp[4-6], measured on vin[11-14] */ in pc87360_init_device()
1443 dev_dbg(&pdev->dev, "using thermistors:%d\n", use_thermistors); in pc87360_init_device()
|
| H A D | ntc_thermistor.c | 3 * ntc_thermistor.c - NTC Thermistors
66 * Thermistors Datasheet
217 * Thermistors Datasheets
|
| H A D | Kconfig | 1369 This driver supports NTC thermistors sensor reading and its
|
| /OK3568_Linux_fs/kernel/drivers/iio/adc/ |
| H A D | Kconfig | 834 power, on board system thermistors connected to the PMIC ADC,
837 hardware supports internal pull-up for thermistors and can choose between
|
| H A D | qcom-pm8xxx-xoadc.c | 170 * thermistors are connected or other hardware characteristics are
|