Searched full:strobing (Results 1 – 17 of 17) sorted by relevance
46 On read 1 means that flash is currently strobing and 0 means55 Flash faults are re-read after strobing the flash. Possible84 controller is below the limit under which strobing the
110 Strobe status: whether the flash is strobing at the moment or not.171 which strobing the flash at full current will not be possible.The183 charged before strobing. LED flashes often require a cooldown period
150 * @state: 1 - flash is strobing, 0 - flash is off152 * Check whether the flash is strobing at the moment.
16 response data) by strobing the ACK pin with the ready signal. See the
14 * traditionally used for strobing the load average. This use case is
36 * @external_strobe_set: Setup strobing the flash by hardware pin state
365 /* DAI clock strobing */ in stm32_i2s_set_dai_fmt()380 dev_err(cpu_dai->dev, "Unsupported strobing %#x\n", in stm32_i2s_set_dai_fmt()
696 /* DAI clock strobing. Invert setting previously set */ in stm32_sai_set_dai_fmt()712 dev_err(cpu_dai->dev, "Unsupported strobing %#x\n", in stm32_sai_set_dai_fmt()
164 * conditions before strobing the flash. in max77693_set_mode_reg()212 * strobing on each subsequent torch mode setting. in max77693_add_mode()
228 /* Stop flash strobing */ in v4l2_flash_s_ctrl()
661 MODULE_PARM_DESC(tuhold, "Time to hold between strobing data to Arc board");
3577 * Strobing EDMA_RESET here causes a hard reset of the SATA transport, in mv_reset_channel()
2401 /* This function is used in AIBSS mode by BTCX to enable strobing to BT */
15010 /* MC2 strobing status */
15021 /* MC2 strobing status */