| /OK3568_Linux_fs/u-boot/drivers/power/pmic/ |
| H A D | Kconfig | 51 regulators (LDOs). It also provides some GPIO, reset and battery
58 The AS3722 includes 7 DC/DC buck convertors, 11 low-noise LDOs, a
91 - 21x LDOs
119 The Rockchip RK808 PMIC provides four buck DC-DC convertors, 8 LDOs,
128 The Rockchip RK8xx PMIC provides four buck DC-DC convertors, LDOs. It is
175 The S5M8767 PMIC provides a large array of LDOs and BUCKs for use
192 The TPS65090 is a PMIC containing several LDOs, DC to DC convertors,
201 The PALMAS is a PMIC containing several LDOs, SMPS.
208 The LP873X is a PMIC containing couple of LDOs and couple of SMPS.
222 SoC. It provides 4 buck DC-DC convertors and 5 LDOs, and it is accessed
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/regulator/ |
| H A D | twl-regulator.txt | 4 For twl6030 regulators/LDOs
21 For twl6032 regulators/LDOs
35 For twl4030 regulators/LDOs
60 For twl4030 regulators/LDOs:
75 For twl6030 regulators/LDOs:
|
| H A D | max77802.txt | 44 -LDOn : for LDOs, where n can lie in ranges 1-15, 17-21, 23-30
57 changing their mode during normal operation are: LDOs 1, 3, 20 and 21.
68 are: BUCKs 2-4 and LDOs 1-35. Also, it only takes effect if the regulator has
|
| H A D | regulator-max77620.txt | 3 Device has multiple DCDC(sd[0-3] and LDOs(ldo[0-8]). The input supply
38 Theres are also additional properties for SD/LDOs. These additional properties
39 are required to configure FPS configuration parameters for SDs and LDOs.
113 LDOs: 5mV/us, 100mV/us
|
| H A D | sprd,sc2731-regulator.txt | 4 14 LDO and 3 DCDCs are designed for external use. All DCDCs/LDOs have
6 ceramic capacitors are recommended to use with these LDOs.
|
| H A D | max77686.txt | 24 -LDOn : for LDOs, where n can lie in range 1 to 26.
|
| H A D | lm363x-regulator.txt | 10 LM3632 has external enable pins for two LDOs.
|
| /OK3568_Linux_fs/kernel/drivers/regulator/ |
| H A D | Kconfig | 114 Say y here to support Freescale i.MX on-chip ANATOP LDOs
275 Say y here to support the BUCKs and LDOs regulators found on
289 Say y here to support the BUCKs and LDOs regulators found on
299 Say y here to support the BUCKs and LDOs regulators found on
309 Say y here to support the BUCKs and LDOs regulators found on
385 21 general purpose LDOs, 3 dedicated LDOs, and 5 BUCKs. All
395 provides 5 general purpose LDOs, and all of them come with support
426 Other LDOs are used for the display module.
519 regulator. The MAX77836 has two additional LDOs.
535 chip to control Step-Down DC-DC and LDOs. Say Y here to
[all …]
|
| H A D | max77802-regulator.c | 107 * Some LDOs support Low Power Mode while the system is running.
109 * LDOs 1, 3, 20, 21.
152 * Enable Control Logic1 by PWRREQ (BUCK 2-4 and LDOs 2, 4-19, 22-35)
153 * Enable Control Logic2 by PWRREQ (LDOs 1, 20, 21)
277 * LDOs 2, 4-19, 22-35
293 * LDOs 1, 20, 21, 3
352 /* LDOs 3-7, 9-14, 18-26, 28, 29, 32-34 */
373 /* LDOs 1, 2, 8, 15, 17, 27, 30, 35 */
|
| H A D | max77686-regulator.c | 42 * Values used for configuring LDOs and bucks.
52 /* Low power mode controlled by PWRREQ: All LDOs */
94 /* all LDOs */ in max77686_get_opmode_shift()
119 /* Some BUCKs and LDOs supports Normal[ON/OFF] mode during suspend */
138 /* Some LDOs supports [LPM/Normal]ON mode during suspend state */
173 /* Some LDOs supports LPM-ON/OFF/Normal-ON mode during suspend state */
|
| H A D | da9063-regulator.c | 46 /* LDOs on both DA9063 and DA9063L */
53 /* DA9063-only LDOs */
268 * LDOs use sleep flags - one for normal and one for suspend state.
521 /* The following LDOs are present only on DA9063, not on DA9063L */
615 /* The following LDOs are present only on DA9063, not on DA9063L */
828 /* LDOs overcurrent event support */ in da9063_regulator_probe()
|
| H A D | hi6421v530-regulator.c | 23 * @mode_mask: ECO mode bitmask of LDOs; for BUCKs, this masks sleep
24 * @eco_microamp: eco mode load upper limit (in uA), valid for LDOs only
|
| H A D | lm363x-regulator.c | 273 * Those pins are used for enabling VPOS/VNEG LDOs. in lm363x_regulator_of_get_enable_gpio()
327 * LM3632 LDOs can be controlled by external pin. in lm363x_regulator_probe()
|
| H A D | hi6421-regulator.c | 35 * @mode_mask: ECO mode bitmask of LDOs; for BUCKs, this masks sleep
36 * @eco_microamp: eco mode load upper limit (in uA), valid for LDOs only
269 /* HI6421 BUCK3/4/5 share similar configurations as LDOs, with exception
|
| /OK3568_Linux_fs/u-boot/drivers/power/regulator/ |
| H A D | Kconfig | 33 driver implements get/set api for the various BUCKS and LDOS supported
42 driver implements enable/disable for step-down bucks and LDOs,
116 driver implements get/set api for the various BUCKS and LDOs supported
125 driver implements get/set api for the various BUCKS and LDOs supported
135 common requirements, including all LDOs and BUCKs. This allows many
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/mfd/ |
| H A D | da9062.txt | 11 da9062-regulator : : LDOs & BUCKs
22 da9062-regulator : : LDOs & BUCKs
53 - regulators : This node defines the settings for the LDOs and BUCKs.
|
| H A D | da9063.txt | 7 da9063-regulator : : LDOs & BUCKs
24 - regulators : This node defines the settings for the LDOs and BUCKs.
|
| H A D | sprd,sc27xx-pmic.txt | 9 - LDOs to support both internal and external requirement.
|
| /OK3568_Linux_fs/u-boot/board/toradex/apalis-tk1/ |
| H A D | as3722_init.c | 81 * Don't write LDCONTROL - it's already 0xFF, i.e. all LDOs enabled. in pmic_enable_cpu_vdd()
97 * Don't write LDCONTROL - it's already 0xFF, i.e. all LDOs enabled. in pmic_enable_cpu_vdd()
113 * Don't write LDCONTROL - it's already 0xFF, i.e. all LDOs enabled. in pmic_enable_cpu_vdd()
|
| /OK3568_Linux_fs/kernel/include/linux/mfd/ |
| H A D | twl.h | 760 #define TPS_SUBSET BIT(1) /* tps659[23]0 have fewer LDOs */
789 * the LDOs, and leave the three buck converters alone. VDD1 and VDD2
800 /* EXTERNAL LDOs */
813 /* INTERNAL LDOs */
833 /* EXTERNAL LDOs */
845 /* INTERNAL LDOs */
849 /* LDOs on 6025 have different names */
|
| /OK3568_Linux_fs/u-boot/board/nvidia/venice2/ |
| H A D | as3722_init.c | 82 * Don't write LDCONTROL - it's already 0xFF, i.e. all LDOs enabled. in pmic_enable_cpu_vdd()
98 * Don't write LDCONTROL - it's already 0xFF, i.e. all LDOs enabled. in pmic_enable_cpu_vdd()
|
| /OK3568_Linux_fs/kernel/drivers/mfd/ |
| H A D | lp8788.c | 77 /* 12 digital ldos */
91 /* 10 analog ldos */
|
| H A D | axp20x-rsb.c | 6 * converters, LDOs, multiple 12-bit ADCs of voltage, current and temperature
|
| /OK3568_Linux_fs/kernel/Documentation/devicetree/bindings/usb/ |
| H A D | mediatek,mt6360-tcpc.yaml | 14 regulators (BUCKs/LDOs), and TypeC Port Switch with Power Delivery controller.
|
| /OK3568_Linux_fs/u-boot/board/avionic-design/common/ |
| H A D | tamonten-ng.c | 23 /* Voltage selection for the LDOs with 100mV resolution */
|