Lines Matching refs:card

53 5. Prepare the SD boot card - with SD card reader
67 and run the script "sd_fusing.sh" - this script is valid only for SD card.
74 - put any SD card into the SD reader
76 - run ./sd_fusing.sh /dev/sdX - where X is SD card device (but not a partition)
79 6. Prepare the eMMC boot card
80    with a eMMC card reader (boot from eMMC card slot)
82 To boot the device from the eMMC slot you should use a special card reader
90 7. Prepare the eMMC boot card
91    with a SD card reader (boot from SD card slot)
93 If you have an eMMC->microSD adapter you can prepare the card as in point 5.
94 But then the device can boot only from the SD card slot.
99 delivered with the board on the eMMC/SD card. Then follow the steps: